Numerical study of a well boat operating at a fish farm in current

Dynamic response of a well boat operating at a fish farm in current is investigated numerically. An objective is to determine the operational conditions of the well boat. In terms of the fish farm, a realistic set-up (with single cage) is considered, including a floating collar, an elastic sinker tube, a flexible-closed net cage and a complex mooring system. A time-domain solution is used to find the steady configuration and response. Transverse viscous current loads are estimated using the cross-flow principle. The drag coefficients are obtained empirically by considering cross-sectional details, free surface and three-dimensional (3D) flow effects. The drag force is experimentally validated. The effect of the ship wake on the net loading is also assessed.The most critical scenario with the well boat placed at the weather side of the fish farm is analyzed in detail. Critical response variables for operational limits are the maximum anchor-line tensions and floater stresses. Numerical results show that the anchor loads will increase more than 40% in small current velocities and up to 90% in high current velocities due to the viscous current loads on the boat. There is also a strong increase of the floating collar deformations and stresses when the well boat is in contact with the floating collar.A sensitivity analysis has been carried out to identify the physical parameters affecting the anchor loads and the maximum stress in the floating collar. From our studies, the anchor loads are more sensitive to current direction, bottom weight system, sinker tube depth and mooring line properties (pretension load, anchor chain weight, etc.) and less sensitive to other parameters such as floating collar stiffness and cross-sectional drag coefficients of the well boat. The shading effect of the well boat on the fish-farm inflow has been examined and appeared not negligible with 4% to 10% reduction of the anchor loads for the studied current conditions. The maximum stress in the floating collar is sensitive to well-boat loads related parameters (current direction, cross-sectional drag coefficient) and pretension load in the anchor line; not so sensitive to net loading related parameters such as sinker tube depth and sinker tube weight.Lastly, the operational conditions of the well boat at the fish farm were discussed. Numerical results show that the maximum stresses in the floating collar should be of major concern. The loads in the mooring lines are moderate compared with the corresponding breaking limits.     

A new multiresponse optimization approach in combination with a D-Optimal experimental design for the determination of biogenic amines in fish by HPLC-FLD

A new strategy to approach multiresponse optimization in conjunction to a D-optimal design for simultaneously optimizing a large number of experimental factors is proposed. The procedure is applied to the determination of biogenic amines (histamine, putrescine, cadaverine, tyramine, tryptamine, 2-phenylethylamine, spermine and spermidine) in swordfish by HPLC-FLD after extraction with an acid and subsequent derivatization with dansyl chloride. Firstly, the extraction from a solid matrix and the derivatization of the extract are optimized. Ten experimental factors involved in both stages are studied, seven of them at two levels and the remaining at three levels; the use of a D-optimal design leads to optimize the ten experimental variables, significantly reducing by a factor of 67 the experimental effort needed but guaranteeing the quality of the estimates. A model with 19 coefficients, which includes those corresponding to the main effects and two possible interactions, is fitted to the peak area of each amine. Then, the validated models are used to predict the response (peak area) of the 3456 experiments of the complete factorial design. The variability among peak areas ranges from 13.5 for 2-phenylethylamine to 122.5 for spermine, which shows, to a certain extent, the high and different effect of the pretreatment on the responses. Then the percentiles are calculated from the peak areas of each amine. As the experimental conditions are in conflict, the optimal solution for the multiresponse optimization is chosen from among those which have all the responses greater than a certain percentile for all the amines. The developed procedure reaches decision limits down to 2.5 μg L⁻¹ for cadaverine or 497 μg L⁻¹ for histamine in solvent and 0.07 mg kg⁻¹ and 14.81 mg kg⁻¹ in fish (probability of false positive equal to 0.05), respectively.     

Analytical strategies to determine antibiotic residues in fish

The accelerated growth of aquaculture has resulted in a series of harmful effects to human health. The widespread and unrestricted use of antibiotics in this industry, to prevent bacterial infections, leads to remaining amounts in the aquatic environment. This has resulted in the emergence of antibiotic-resistant bacteria in aquaculture environments, in the increase in antibiotic resistance in fish pathogens as well as in the transfer of these resistance determinants to human pathogens. Moreover, the use of large amounts of antibiotics may lead to the presence of residual antibiotics in fish tissue and fish products. Fluoroquinolones, tetracyclines, penicillins, sulphonamides and other antibiotics, exhibiting activity against both Gram-positive and Gram-negative bacteria, are widely used for the treatment and prevention of diseases in fish. An extended and comprehensive review on the recent analytical methodologies concerning antibiotic residues in fish reported in the literature is provided in the present article. Emphasis is given on sample preparation regarding isolation and purification, chromatographic conditions and method validation according to legislation. Results of published assays are comparatively presented and criticised.     

Determination of polybrominated diphenyl ethers in environmental standard reference materials

Standard reference materials (SRMs) are valuable tools in developing and validating analytical methods to improve quality assurance standards. The National Institute of Standards and Technology (NIST) has a long history of providing environmental SRMs with certified concentrations of organic and inorganic contaminants. Here we report on new certified and reference concentrations for 27 polybrominated diphenyl ether (PBDE) congeners in seven different SRMs: cod-liver oil, whale blubber, fish tissue (two materials), mussel tissue and sediment (two materials). PBDEs were measured in these SRMs, with the lowest concentrations measured in mussel tissue (SRM 1974b) and the highest in sediment collected from the New York/New Jersey Waterway (SRM 1944). Comparing the relative PBDE congener concentrations within the samples, we found the biota SRMs contained primarily tetrabrominated and pentabrominated diphenyl ethers, whereas the sediment SRMs contained primarily decabromodiphenyl ether (BDE 209). The cod-liver oil (SRM 1588b) and whale blubber (SRM 1945) materials were also found to contain measurable concentrations of two methoxylated PBDEs (MeO-BDEs). Certified and reference concentrations are reported for 12 PBDE congeners measured in the biota SRMs and reference values are available for two MeO-BDEs. Results from a sediment interlaboratory comparison PBDE exercise are available for the two sediment SRMs (1941b and 1944).     

甲苯胺蓝共振光散射法测定纳克级脱氧核糖核酸

研究了吩噻嗪类染料甲苯胺蓝 (TB)与DNA作用的共振光散射光谱 ,在pH 1 0～ 1 1的范围内 ,加入DNA导致甲苯胺蓝共振光散射增强 ,在 35 0nm处 ,存在一共振光散射增强峰 ,其强度与DNA浓度呈线性关系 ,据此建立了一种测定DNA的共振光散射法。对于ctDNA ,方法的线性范围为 0～ 90 0ng·mL-1 ,检出限为6 75ng·mL-1 ,RSD为 3 7% ;对于fsDNA ,方法的线性范围为 0～ 90 0ng·mL-1 ,检出限为 2 99ng·mL-1 ,RSD为 5 6 % .已用于合成样品中DNA的测定     

An optimized digestion method coupled to electrochemical sensor for the determination of Cd, Cu, Pb and Hg in fish by square wave anodic stripping voltammetry

An optimized digestion method coupled to electrochemical detection to monitor lead, copper, cadmium and mercury in fish tissues was developed. Square wave anodic stripping voltammetry (SWASV) coupled to disposable screen-printed electrodes (SPEs) was employed as fast and sensitive electroanalytical method for heavy metals detection. Different approaches in digestion protocols were assessed. The study was focused on Atlantic hake fillets because of their wide diffusion in the human nutrition. Best results were obtained by digesting fish tissue with hydrogen peroxide/hydrochloric acid mixture coupled to solid phase (SP) purification of the digested material. This combined treatment allowed quantitative extraction from fish tissue (muscle) of the target analytes, with fast execution times, high sensitivity and avoiding organic residues eventually affecting electrochemical measurements. Finally, the method has been validated with reference standard materials such as dogfish muscle (DORM-2) and mussel tissues (NIST 2977).     

Simultaneous residue monitoring of four tetracycline antibiotics in fish muscle by in-tube solid-phase microextraction coupled with high-performance liquid chromatography

An on-line simple and rapid method for the simultaneous determination of tetracycline (TC), oxytetracycline (OTC), chlortetracycline (CTC) and doxycycline (DC) residues in fish muscle was developed by coupling in-tube solid-phase microextraction (SPME) to high-performance liquid chromatography (HPLC) with a photodiode array detector. Biocompatible poly (methacrylic acid-ethylene glycol dimethacrylate) monolithic capillary was selected as the extraction medium, and no precipitating protein and removing fat steps were required prior to extraction. In order to optimize the extraction of these compounds, several in-tube SPME parameters were investigated. Simply performed by extracting with 0.01 M EDTA-MacIlvaine buffer solution (pH 4.0) and centrifugation, the sample then could be directly injected into the device for extraction. The limits of detection of tetracycline, oxytetracycline, chlortetracycline and doxycycline were calculated to be 22, 16, 30 and 21 ng/g, respectively. The calibration curves showed linearity in the range of 100-10,000 ng/g with a linear coefficient R² value above 0.9980. Excellent method reproducibility was found by intra- and inter-day precisions, yielding the R.S.D.s less than 4.22% and 5.71%, respectively.     

可见-近红外光谱分析技术对鱼油掺假定量快速无损检测方法研究

对掺入不同含量大豆油和菜籽油的鱼油进行鱼油掺假含量的可见-近红外光谱(Vis-NIR)研究。向3个不同品牌鱼油中分别掺入不同比例的大豆油,另外3个不同品牌中分别掺入不同比例的菜籽油,共获得300个样本。对所采集样本的光谱数据分别采用原始光谱,以及平滑,变量标准化(SNV),多元散射校正(MSC),一阶求导和二阶求导等预处理算法进行处理后,建立偏最小二乘回归(PLSR)模型。基于全波段光谱的鱼油中大豆油和菜籽油掺假含量预测的最优模型分别为全波段PLSR模型和MSC-PLSR模型,其预测相关系数(R_p)分别达到0.938 6和0.959 3。进一步采用连续投影算法(SPA)分析鱼油中大豆油和菜籽油掺假样品的光谱,并分别获得了11个和15个光谱特征波长变量。基于特征变量的PLSR模型的R_p分别为0.941 2和0.932 6。试验研究表明, 可以采用Vis-NIR技术实现对鱼油掺假物含量的检测。     

Effect of high pressure processing on the preservation of frozen and re-thawed sliced cod (Gadus morhua) and salmon (Salmo salar) fillets

Cod and salmon are both widely found in the seafood market, but those products are easily spoiled. This work reports on the investigation of the effects of three moderate pressure values (150, 300 and 450?MPa) applied for 5?min at 20°C on crude sliced cod and salmon fillets. It was found that high pressure processing (HPP) significantly reduced the microbial load during refrigerated storage for up to 14 days. As expected, the most effective treatment was 450?MPa because it inhibited microbial growth. This process affected the hardness, lightness, lipid oxidation, protein denaturation and oxidation. The fish muscle composition (lipid amount and protein profile) played a main role in the changes promoted by pressure. HPP permits the shelf life of the raw product at 4°C to be increased with minimal changes in the organoleptic characteristics and to enable crude consumption.     

Molecularly-Imprinted Materials for Potentiometric Transduction: Application to the Antibiotic Enrofloxacin

Enrofloxacin (ENR) is an antimicrobial used both in humans and in food producing species. Its control is required in farmed species and their surroundings in order to reduce the prevalence of antibiotic resistant bacteria. Thus, a new biomimetic sensor enrofloxacin is presented. An artificial host was imprinted in specific polymers. These were dispersed in 2-nitrophenyloctyl ether and entrapped in a poly(vinyl chloride) matrix. The potentiometric sensors exhibited a near-Nernstian response. Slopes expressing mV/Δlog([ENR]/M) varied within 48–63. The detection limits ranged from 0.28 to 1.01 µg mL^?1. Sensors were independent from the pH of test solutions within 4–7. Good selectivity was observed toward potassium, calcium, barium, magnesium, glycine, ascorbic acid, creatinine, norfloxacin, ciprofloxacin, and tetracycline. In flowing media, the biomimetic sensors presented good reproducibility (RSD of ± 0.7%), fast response, good sensitivity (47 mV/Δlog([ENR]/M), wide linear range (1.0 × 10^?5–1.0 × 10^?3 M), low detection limit (0.9 µg mL^?1), and a stable baseline for a 5 × 10^?2 M acetate buffer (pH 4.7) carrier. The sensors were used to analyze fish samples. The method offered the advantages of simplicity, accuracy, and automation feasibility. The sensing membrane may contribute to the development of small devices allowing in vivo measurements of enrofloxacin or parent-drugs.