全文获取类型
收费全文 | 190篇 |
免费 | 67篇 |
国内免费 | 43篇 |
专业分类
化学 | 83篇 |
晶体学 | 2篇 |
力学 | 53篇 |
综合类 | 5篇 |
数学 | 44篇 |
物理学 | 113篇 |
出版年
2024年 | 1篇 |
2023年 | 4篇 |
2022年 | 9篇 |
2021年 | 8篇 |
2020年 | 9篇 |
2019年 | 11篇 |
2018年 | 9篇 |
2017年 | 12篇 |
2016年 | 7篇 |
2015年 | 9篇 |
2014年 | 25篇 |
2013年 | 12篇 |
2012年 | 7篇 |
2011年 | 18篇 |
2010年 | 12篇 |
2009年 | 13篇 |
2008年 | 10篇 |
2007年 | 7篇 |
2006年 | 5篇 |
2005年 | 10篇 |
2004年 | 15篇 |
2003年 | 7篇 |
2002年 | 15篇 |
2001年 | 9篇 |
2000年 | 11篇 |
1999年 | 2篇 |
1998年 | 5篇 |
1997年 | 1篇 |
1996年 | 1篇 |
1995年 | 2篇 |
1994年 | 3篇 |
1993年 | 4篇 |
1992年 | 3篇 |
1991年 | 3篇 |
1990年 | 4篇 |
1989年 | 2篇 |
1987年 | 1篇 |
1985年 | 3篇 |
1984年 | 3篇 |
1983年 | 1篇 |
1982年 | 2篇 |
1981年 | 1篇 |
1980年 | 3篇 |
1978年 | 1篇 |
排序方式: 共有300条查询结果,搜索用时 296 毫秒
291.
罗秀娟张羽高存孝任娟曹蓓刘辉陈明徕 《光学学报》2015,(3):154-163
傅里叶望远镜发射系统的性能直接影响图像的分辨率和质量。分析了激光器的参数和性能要求,提出了光纤激光器的设计要点,并指出激光相干长度应至少为光程残差的1.6倍;对激光器的功率和频率稳定性进行了仿真,从设计、算法和使用角度给出了保证激光器稳定性的一些方法;而且结合仿真和实验结果,从发射孔径布局、孔径数量、位置精度和光束瞄准误差等方面,分析了发射器性能对成像质量的影响。指出了基线冗余度、图像分辨率、目标频谱分布和图像质量等因素在布设发射阵列应综合考虑。基于二维抽样定理和统计分析结果,得出计算发射孔径数量的公式,计算了傅里叶望远镜对1000 km低轨道目标达到5 cm分辨率时所需的发射孔径数目。此外,还得出发射孔径位置误差应小于最小孔径间距的5%的结论。 相似文献
292.
结合微腔面发射器件辐射/发光亮度的空间分布以及相对光谱功率分布给出了器件外量子效率的计算模型. 该模型可以计算工作于不同波段的微腔面发射器件的外量子效率,如红外波段的垂直腔面发射激光器,可见光波段的微腔有机发光二极管和谐振腔发光二极管以及太赫兹波段的平面微腔结构等. 制备了结构为玻璃/DBR /ITO /NPB /Alq ∶C545T/Alq/LiF/Al的微腔有机电致发光器件,测试其不同观察角度下器件的发光亮度以及发光光谱. 当电流密度和发光亮度分别为14 A/m2和100 cd/
关键词:
外量子效率
平面微腔器件
辐射/发光亮度空间分布 相似文献
293.
柱后衍生-高效液相色谱法测定水中呋喃丹和甲萘威 总被引:1,自引:0,他引:1
提出了测定水中呋喃丹和甲萘威的柱后衍生-高效液相色谱法。水样经盐酸酸化至pH 3后,用0.45μm水性滤膜过滤,取200μL水样直接进样,用Waters Carbamate Analysis分析柱(3.9 mm×150 mm,5μm)和以甲醇-乙腈-水(1+1+3)混合液作为流动相进行分离。分离后用2 g·L-1氢氧化钠溶液进行水解,用每升中含邻苯二甲醛0.1 g、十水硼酸钠19.1 g及2-巯基乙醇0.5 mL的溶液进行衍生化,用荧光检测器在激发波长(eλx)为339 nm,发射波长(eλm)为445 nm处检测。方法检出限(3S/N)均为4×10-4mg·L-1。应用此方法测定了水厂出厂水和河水中呋喃丹和甲萘威,并用标准加入法做回收试验,测得其平均回收率依次为93.0%~98.0%之间和93.0%~99.4%之间,相对标准偏差(n=6)小于0.50%。 相似文献
294.
295.
Partially-depleted Silicon-On-Insulator Negative Channel Metal Oxide Semiconductor (SOI NMOS) transistors with different layouts are fabricated on radiation hard Separation by IMplanted OXygen (SIMOX) substrate and tested using 10keV X-ray radiation sources. The radiation performance is characterized by transistor threshold voltage shift and transistor leakage currents as a function of the total dose up to 2.0×106 rad(Si). The results show that the total dose radiation effects on NMOS devices are very sensitive to their layout structures. 相似文献
296.
The erbium ions at energy of 400 keV and dose of 5×10 15 ions/cm 2 were implanted into silicon single crystals at room temperature at the angles of 0,45 and 60.The lateral spread of 400 keV erbium ions implanted in silicon sample was measured by the Rutherford backscattering technique.The results show that the measured values were in good agreement with those obtained from the prediction of TRIM’98 (Transport of Ions in Matter) and SRIM2006 (Stopping and Range of Ions in Matter) codes. 相似文献
297.
A Clock Enhanced Loop for Simultaneous Error-Free Demultiplexing and Clock Recovery of 160Gb/s OTDM Signal Single-Channel Transmission over 100km 下载免费PDF全文
A simple clock enhanced loop of cascaded electro-absorption modulators (EAMs) and 10 GHz clock recovery modules is presented. The intensity of harmonic of clock-frequency component is analyzed theoretically and verified experimentally in a 160 Gb/s OTDM 100 km transmission system. The 10 GHz clock component is enhanced obviously before launching into the clock recovery module and the recovered clock signal exhibits low rms jitter of 〈400 fs. Moreover, completely error^-1free (10-12) transmission is observed for more than two hours without using forward error correction technology. The power penalty is about 3.6 dB. The proposed loop has merits of enhancing base clock component, simultaneously de-multiplexing and clock recovery, which make the performance of this loop more stable and high suppression of non-target channels. 相似文献
298.
S波震相初至时刻的精确识别是岩石动力学参数反演的关键环节。其拾取的精度和速度直接影响到岩石动力学参数反演的精度和效率。对S波的识别研究大多都集中在地震领域,现有方法难以有效的识别工程尺度下的爆破地震波S波的到时。本文中拟提出一种适用于工程尺度下S波的识别方法。该方法不对振动信号进行滤波处理,采用短时平均过零率、偏转角、偏振度和横向能量与总能量比值等4个识别参数对S波进行识别。结合丰宁抽水蓄能电站地质勘探洞爆破实验实测数据识别效果与数值模拟结果表明:该方法在工程尺度下的识别误差小于3%。该算法能较好地适用于工程尺度下S波初至时刻进行识别。 相似文献
299.
300.