CTAB水溶液表面的吸附动力学

用最大气泡压力法测定了十六烷基三甲基溴化铵(CTAB)水溶液的动态表面张力,研究了CTAB水溶液表面吸附的动力学及其影响因素。结果表明,吸附过程由初始的扩散控制经混合控制过渡到势垒控制。扩散控制吸附速率快,时间短;势垒控制速率慢,时间长,吸附势垒一般为4～10kJ.mol^-^1。温度升高,动态表面张力减小,但吸附机理不变;无机盐或醇类的加入对势垒值影响不大,但对扩散控制步骤的影响较大。     

孔雀绿与CTAB胶束的相互作用

以CTAB胶束模拟生命体系,用UV-Vis和荧光光谱等技术研究了孔雀绿与CTAB胶束的相互作用.结果表明,孔雀绿自发地定位于CTAB胶束栅栏层,使得胶束聚集数增加,胶束的微环境极性I1/I3下降.孔雀绿与CTAB胶束之间的结合常数K和孔雀绿在胶束相与水连续相之间的分配系数KD均随孔雀绿浓度增加而降低,表明孔雀绿与CTAB胶束之间的相互作用随孔雀绿浓度增加而降低.     

沙林在CTAB逆胶束介质中的化学发光分析

以 CTAB在氯仿 /环已烷为主体溶剂相中所形成的逆胶束介质 ,基于鲁米诺 - H2 O2 化学发光体系对沙林进行定量分析 ;研究了氯仿与环已烷的不同配比、R值、CTAB浓度、p H、鲁米诺浓度及 H2 O2 浓度对化学发光强度的影响。沙林的检测线性范围为 1× 1 0 -6～ 1× 1 0 -2 mol/L,检出限为 1 .5× 1 0 -7mol/L ,对水样及土样测定的回收率均在 90 %以上     

Different Aggregation Behaviors of Tetra- (4-hydroxyphenyl) Porphyrin (THPPH2) in the Inner Core and on the Surface of CTAB Micelles

It is hard to study the effects of different microenvironments on porphyrin aggregation because of its complex substituted groups. A trans-membrane process was realized by controlling bulk pH values for an amphiphilic porphyrin from the inner core to the surface of CTAB micelles1. Thus it is posible to study the different aggregation actions of the porphyrin in the inner core and on the surface of micelle. Results and DiscussionThe absorption spectra of THPPH2 at pH 7.2 have four Q bands…     

模板沉淀法制备高比表面积MnOx-CeO2催化剂及其CO低温氧化活性

以十六烷基三甲基溴化铵(CTAB)为模板剂, Ce(NO3)3和Mn(NO3)2为前驱体, 通过沉淀法制备了一系列晶粒小于5 nm的高比表面积MnOx-CeO2催化剂, 并考察了催化剂的CO氧化反应性能. 采用XRD、Raman光谱、TPR和N2气吸附脱附等手段对催化剂的比表面积、晶粒大小和物相组成进行了表征. 当Mn摩尔分数≤34%时, 催化剂的比表面积在160~170 m2/g之间; 当锰含量进一步提高后, 催化剂的比表面积呈下降趋势. 当Mn摩尔分数≤34%时, XRD只检测到CeO2物相, 而Raman光谱则检测到α-Mn2O3的存在. 催化剂上表现出较好的CO氧化活性, 这主要归因于高比表面积. 随着锰含量的增加, 催化剂的轻化频率(TOF)下降, 表明高分散、小晶粒的氧化锰物种是催化剂的活性物种. H2-TPR结果表明, 催化剂的CO氧化活性还与催化剂中高价锰物种有关. 焙烧温度升高使催化剂的晶粒增大、比表面积减小, 同时催化剂中锰的平均价态降低, 导致CO氧化活性下降.     

单链四苯酚基卟啉在CTAB胶束微环境中的去质子化现象

叶绿素分子的光能转化功能的实现与其聚集状态、所处微环境性质及条件密切相关[1,2]．如何设计控制叶琳类分子在膜介质中的增溶位置，对于研究叶琳在膜体系中的跨膜电子传递、光能转化过程具有重要意义．本文研究了长链双亲卟啉──单链四苯酚基叶琳THPPH2在CTAB胶束中的去质子化，该过程能控制叶琳环在胶束中的增溶位置，使其由内核转移到胶束表面．1实验部分1·1仪器和测试条件岛津UV－240型紫外可见光谱仪（带有恒温夹套），狭缝宽2nm，石英池厚1cm，所用试剂皆为分析纯．UV光谱测试均在恒温条件下进行．1．2溶液的配制含一个十六…     

单分散、小粒径金纳米颗粒的形貌控制增长

利用种子生长法合成了形状规则、尺寸单一的形状不同金纳米颗粒. 其中立方体纳米颗粒的边长为33±2 nm, 它是在十六烷基三甲基溴化胺(CTAB)存在的条件下, 在种子的表面上用弱还原剂——抗坏血酸还原而成的. 在这个体系中, 表面活性剂CTAB既作为保护剂又作为颗粒成长的导向剂. 用UV-vis, TEM, XRD对纳米颗粒的光学性质、几何形状、纳米颗粒的单层膜概貌以及纳米颗粒的晶体结构作了表征. 考察了种子生长的时间、种子的量、抗坏血酸的量对生成纳米颗粒形状的影响.     

青霉素G钾盐在CTAB胶束中的水解及其抑制

以紫外光谱法研究了青霉素G钾盐(Pen-K)在十六烷基三甲基溴化铵（CTAB）胶束体系中的水解反应, 并探讨了水解反应机理.结果表明, CTAB胶束对Pen-K的水解具有抑制作用; Pen-K在CTAB胶束体系水解时,体系pH值的变化与在水中相似, 表明H＋浓度对这种抑制作用影响较小.红外光谱和微极性研究表明,部分Pen-K钾盐定位于CTAB胶束栅栏层中, 增加了其稳定性.     

On-line separation and preconcentration of inorganic arsenic and selenium species in natural water samples with CTAB-modified alkyl silica microcolumn and determination by inductively coupled plasma-optical emission spectrometry

A new, simple, and selective method has been presented for the separation and preconcentration of inorganic arsenic (As(III)/As(V)) and selenium (Se(IV)/Se(VI)) species by a microcolumn on-line coupled with inductively coupled plasma-optical emission spectrometry (ICP-OES). Trace amounts of As(V) and Se(VI) species were separated and preconcentrated from total As and Se at desired pH values by a conical microcolumn packed with cetyltrimethylammonium bromide (CTAB)-modified alkyl silica sorbent in the absence of chelating reagent. The species adsorbed by CTAB-modified alkyl silica sorbent were quantitatively desorbed with 0.10 ml of 1.0 mol l⁻¹ HNO₃. Total inorganic arsenic and selenium were similarly extracted after oxidation of As(III) and Se(IV) to As(V) and Se(VI) with KMnO₄ (50.0 μmol l⁻¹). The assay of As(III) and Se(IV) were based on subtracting As(V) and Se(VI) from total As and total Se, respectively. All parameters affecting the separation/preconcentration of As(V) and Se(VI) including pH, sample flow rate and volume, eluent solution and volume have been studied. With a sample volume of 3.0 ml, the sample throughput was 24 h⁻¹ and the enrichment factors for As(V) and Se(VI) were 26.7 and 27.6, respectively. The limits of detection (LODs) were 0.15 μg l⁻¹ for As(V) and 0.10 μg l⁻¹ for Se(VI). The relative standard deviations (RSDs) for nine replicate determinations at 5.0 μg l⁻¹ level of As(V) and Se(VI) were 4.0% and 3.6%, respectively. The calibration graphs of the method for As(V) and Se(VI) were linear in the range of 0.5–1000.0 μg l⁻¹ with a correlation coefficient of 0.9936 and 0.9992, respectively. The developed method was successfully applied to the speciation analysis of inorganic arsenic and selenium in natural water samples with satisfactory results.     

Electrochemical behavior of phenol at acetylene black-dihexadecyl hydrogen phosphate composite modified glassy carbon electrode in the presence of cetyltrimethylammonium bromide

The electrochemical response of phenol at acetylene black (AB)-dihexadecyl hydrogen phosphate (DHP) composite modified glassy carbon electrode in the presence of cetyltrimethylammonium bromide (CTAB) was investigated. In this system, a sensitive oxidation peak at 0.62 V (SCE) was obtained. The electrode process and the influence of CTAB on the oxidation of phenol were explored by chronocoulometry and linear sweep voltammetry (LSV). Experimental conditions for the determination of phenol were optimized. In the range of 5.0 × 10⁻⁷ to 1.2 × 10⁻⁵ M, the phenol concentration was linear with the oxidation peak current and the detection limit was found to be 1.0 × 10⁻⁷ M for 3 min accumulation. The method was applied for the determination of phenol in lake water and the results were satisfactory. Published in Russian in Elektrokhimiya, 2008, Vol. 44, No. 2, pp. 222–229. The text was submitted by the authors in English.