微悬臂梁检测三肽Gly-Gly-His与Cu~(2+)的相互作用过程

将三肽Gly-Gly-His(GGH)共价键合到MPA修饰的微悬臂梁表面,研究了肽与Cu2+的相互作用过程.研究发现,在Cu2+浓度较高时,Cu2+能快速与不同肽链上的羧基和咪唑环配位,并通过连锁反应诱导悬臂梁向镀金面偏转;而后肽链上的氮原子与Cu2+配位,同时构象发生变化,由直链转变成折叠状,进而增加链间的作用力使悬臂梁反向偏转;而Cu2+浓度低时不能实现连锁反应诱导悬臂梁表面快速的形成向内的拉力,直接通过构象变化推动悬臂梁反向偏转.考察了溶液pH值、Cl-浓度对GGH与Cu2+作用的影响,结果表明,在pH 7.0的条件下GGH与Cu2+作用导致悬臂梁偏转最大.Cl-的存在会与Cu2+形成CuCl2–xx配合物不易与肽链结合.     

轴向运动梁的横向振动分析

论述了轴向运动梁横向振动问题以及研究轴向运动梁横向振动问题的方法,指出对轴向运动梁横向振动问题研究中存在的一些错误并进行了更正.针对一端可看作固定边界条件的轴向运动悬臂梁,基于连续体的模态叠加法,推导出含自重效应的轴向运动梁动力响应的计算公式,进行实例计算,并对计算结果进行了详细的讨论,得出影响轴向运动梁振动响应的因素主要有速度和运动方向.     

Optimization designed large-stroke MEMS micromirror for adaptive optics

A novel micromirror based on the PolyMUMPs process is designed and presented. The hexagonal micromirror with a diameter of 450 μm consists of three supporting bilayer cantilevers and a mirror plate. The bilayer cantilevers, formed with a polysilicon layer and a gold layer, elevate the mirror plate according to residual stress-induced bending. Both analytical and finite element analysis (FEA) models are built to calculate the elevated height of the free end of the cantilever. The analytical solution is in accordance with the FEA simulation results, with longitudinal stresses applied only. Results of a three-dimensional (3D) simulation with two direction stresses applied also show the elevated height to be proportional to the width of the cantilever and the length of the gold layer. Due to the torque of the joint, the elevated heights of the two kinds of cantilevers assembled with the mirror plates are much smaller than those of the free end of the cantilevers. Both micromirrors with different cantilevers are fabricated. The elevated heights of the fabricated micromirrors are measured using Veeco optical profiler, which show good coincidence with simulation results.     

基于F型梁的光纤光栅加速度传感器

为满足悬臂梁式传感器测量带宽大、灵敏度高的需求,采用F型梁增敏结构设计了一种光纤光栅加速度传感器。首先推导出传感器的谐振频率和灵敏度公式,在此基础上使用MATLAB优化传感器参数,并利用ANSYS对传感器进行模态分析和谐响应分析,得到了传感器的模态振型图以及两种不同阻尼比条件下的幅频响应,仿真结果与理论计算基本一致。制作了2个传感器实物,对直接封装的传感器1和填充硅油后封装的传感器2进行了幅频响应、灵敏度特性和横向抗干扰能力测试。实验结果表明：传感器1的谐振频率约为168 Hz,测量带宽为1.5～50 Hz,灵敏度系数为159.84 pm/g,横向抗干扰度为9.88%,谐振频率和灵敏度理论值与实际值误差分别为0.93%和3.29%;填充硅油后的传感器2的测量带宽为1.5～100 Hz,灵敏度系数为133.57 pm/g,横向抗干扰度为8.1%。实验证明在传感器内部填充硅油可以增大传感器工作带宽,提高横向抗干扰能力。     

Broadband energy harvesting via magnetic coupling between two movable magnets

Harvesting energy from ambient mechanical vibrations by the piezoelectric effect has been proposed for powering microelectromechanical systems and replacing batteries that have a finite life span. A conventional piezoelectric energy harvester （PEH） is usually designed as a linear resonator, and suffers from a narrow operating bandwidth. To achieve broadband energy harvesting, in this paper we introduce a concept and describe the realization of a novel nonlinear PEH. The proposed PEH consists of a primary piezoelectric cantilever beam coupled to an auxiliary piezoelectric cantilever beam through two movable magnets. For predicting the nonlinear response from the proposed PEH, lumped parameter models are established for the two beams. Both simulation and experiment reveal that for the primary beam, the introduction of magnetic coupling can expand the operating bandwidth as well as improve the output voltage. For the auxiliary beam, the magnitude of the output voltage is slightly reduced, but additional output is observed at off-resonance frequencies. Therefore, broadband energy harvesting can be obtained from both the primary beam and the auxiliary beam.     

非线性磁式压电振动能量采集系统建模与分析

为便于评价、优化磁式压电振动能量采集系统的性能,系统研究了该类系统的建模与分析方法,建立了非线性的分布参数模型用于描述系统的非线性动力学行为,并采用谐波平衡法给出了谐波响应的解析解.随后利用仿真模型分析了磁铁间距、加速度幅值、负载阻抗对输出功率的影响,比较了不同激励频率和加速度幅值下的最优阻抗.结果表明:双稳态特性适用于低强度的振动环境,且愈接近临界区域,输出功率愈高,而单稳态渐硬特性适用于高强度振动环境,其最优间距并不靠近临界区域;阱间大幅运动和阱内小幅运动均存在高低能量态共存的现象,愈接近临界区域,现象愈明显;激振频率是影响最优负载阻抗的决定性因素.     

光纤布喇格光栅沉降传感器

根据光纤布喇格光栅的光学传感原理,提出了一种基于悬臂梁及金属弹性膜片的光纤布喇格光栅沉降传感器结构,对其传感特性进行了实验研究.实验通过产生水的液位差来模拟地基沉降,分析结果显示,光纤布喇格光栅中心反射波长漂移对液位差呈现良好的线性关系,线性度高于0.999,灵敏度可达-2.11 pm/mm.通过改变悬臂梁厚度和有效长度,可以对传感器测量范围和灵敏度进行调整,以满足各种应用场合.综合实验结果,该传感器在桥梁、铁路地基等沉降监测方面具有重要意义.     

离心场中纵向悬臂梁的大范围分岔分析

采用打靶法研究了离心场中纵向悬臂梁的大范围失稳与分岔问题。分析结果证实：随着参数a（离心臂长与梁长之比）的变化,梁平衡解可能发生三种分岔现象。文中给出了平衡解的分岔形态,并发现了梁分岔解的单向跳跃现象,即突变现象。     

匀速转动内悬臂梁稳定性研究

本文采用了凯恩简化模型并提出大范围平动和转动共同作用下的连续体梁模型;通过两种模型分析了匀速转动内悬臂梁的稳定性;指出了匀速转动内悬臂梁存在动力柔化现象,动力柔化的原因在于梁的大范围平动;提出了匀速转动内悬臂梁的内转半径和外转半径的概念,指出匀速转动内臂梁的内转半径和外转半径比值存在一定关系时,系统为一阶稳定,研究表明,同时作大范围平动和转动的柔性梁存在柔化和刚化的分界点,需要在实际应用中予以注意。     

谐变磁场激励下非线性铁磁梁式板的共振分叉研究

本文采用磁场计算的磁体力理论模型,对处于均匀横向周期时变磁场中的非线性铁磁悬臂梁式板动力分叉问题进行理论分析和定量研究,首先建立了铁磁悬臂梁式板的非线性动力方程,在此基础上,采用非线性分析的多尺度法研究了铁磁悬壁板的共振分岔,最后,采用Floquet理论研究了该动力系统周期轨道的稳定性问题,数值给出了周期轨道的稳定性区域,Floquet理论研究了该动力系统周期轨道的稳定性问题,数值给出了周期轨道的稳定性区域,并分析了稳定区域与不稳定区域分界线上解的分叉情形。