(Ba, Sr)TiO3纳米棒的反相微乳法制备与表征

在氢氧化钡和氢氧化锶水溶液/Triton X-100/环己烷/正己醇四元W/O型反相微乳液中制备了钛酸锶钡纳米棒, 研究了ω₀值(水与表面活性剂Triton X-100的物质的量之比)、反应物浓度、陈化时间对产品形貌和尺寸的影响, 用TEM, SAED, SEM, EDS和XRD等技术对产品进行了表征. 结果表明, 所得Ba_0.7Sr_0.3TiO₃纳米棒长约500～1200 nm、直径约为50～120 nm; 具有立方相单晶结构. 产品中钡、锶、钛的物质的量之比约为0.7∶0.3∶1.     

制备条件对CdWO4纳米棒的光致发光性能的影响

以Na₂WO₄和CdCl₂为主要原料，在130 ℃水热制备了CdWO₄纳米棒，并用扫描电镜(SEM)、透射电镜(TEM)、粉末X射线衍射(XRD)和能谱元素分析(EDS)对产物进行了表征。结果表明，产物为长约100 nm，直径10～30 nm的CdWO₄纳米棒。研究了不同反应条件下制备的CdWO₄纳米棒的光致发光性能。     

Hydrothermal Synthesis of Nanorods and Nanowires of Mg/Al Layered Double Hydroxides

Layered double hydroxides (LDHs) are a class of synthetic anion clays, characterized by the formula[MⅡ1-xMⅢx (OH)2]x (An- )x/n·yH2O (where M =metal and A = anion, usually carbonate)[1-3]. A large number of LDHs with a wide variety of M Ⅱ-M Ⅲ cation pairs including M Ⅰ-M Ⅲ ( e. g. , Li-Al ) and M Ⅱ-MⅣ( e. g. , Co-Ti) have been reported. Thus the identities of the cations(MⅠ , MⅡ , MⅢ and MⅣ) and the interlayer anion (An-) together with the value of the stoichiometric coefficient (x) may vary widely, giving rise to a large class of isostructural materials.     

邻苯二甲酸二烯丙酯和甲基丙烯酸甲酯共聚物梯度折射率棒制备过程的研究

<正> 梯度折射率棒是折射率沿径向或轴向连续变化的透明圆棒,具有光自聚焦性能。可用于制作自聚焦型光纤维和自焦聚透镜。用玻璃制得的梯度棒直径和折射率差都很小。近年来,开始研究高分子梯度棒,据估计其直径可望达到100mm,折射率差也可达0.1。本文采用二元掖体扩散共聚法,制得梯度棒,其径向折射率分布接近于抛物线型。     

水/油型微乳液中球形及棒状钛酸锶钡纳米粒子的控制合成

Barium strontium titanate nanoparticles with spherical and rod-like morphologies were synthesized in water/Triton X-100/n-hexanol/cyclohexane quaternary reverse microemulsion solution. The influences of the molar ratio of water to surfactant (ω₀) and the concentration of reactants on the morphology and size of barium strontium titanate nanoparticles were studied. The structure, compositions and morphology of the prepared products were characterized by XRD, SAED, ICP, EDS and TEM. The results show that the obtained Ba_0.7Sr_0.3TiO₃ spherical nanoparticles with diameters of 20～100 nm and the Ba_0.7Sr_0.3TiO₃ nanorods with diameters of 70～120 nm and lengths up to 600～800 nm are a single crystal, with a cubic phase. The molar ratio for barium, strontium and titanate in products is about 0.7:0.3:1.     

球磨-溶剂热诱导法合成WS2纳米棒及其摩擦性能

采用行星式高能球磨机，将WS₂与S粉末混合球磨，得到纳米片状结构的前驱体，然后添加分散剂聚乙二醇(PEG)用溶剂热诱导的方法使纳米片状前驱体发生结构转变，制备了棒状结构的WS₂纳米材料。用XRD、SEM、TEM等方法对WS₂纳米棒进行了形貌和结构表征，并对其作为润滑油添加剂的摩擦性能进行了初步的研究。     

一维棒状ZnO的制备及电化学嵌锂性能研究

目前,商业化锂离子电池一般采用石墨作为负极材料,因其电位与金属锂电极的电位很接近,所以当电池反复循环和过充时,石墨表面易析出金属锂,会因形成枝晶而短路。在温度过高时还容易引起热失控。同时,锂离子电池的容量在很大程度上取决于负极的锂嵌入量,而且石墨材料容量相对较低     

气化炉渣的碱活性研究

目前混凝土骨料资源短缺问题突显,气化炉渣是潜在资源.若采用气化炉渣作细骨料,首先需要判别气化炉渣的碱活性.试验按照砂浆棒快速法研究气化炉渣的碱活性,用三个主要粒级的气化炉渣替代天然砂制作砂浆棒,测定各龄期砂浆棒的长度.试验结果表明天然砂砂浆棒28 d的膨胀率为0.09%,而含有气化炉渣的各组砂浆棒膨胀率均小于0.06%,且0.63 mm粒级是碱硅酸型碱骨料反应的敏感粒级.作为混凝土细骨料使用时,气化炉渣不属于碱活性骨料,反而对碱骨料反应膨胀有一定抑制作用.应用于混凝土时,不必担忧气化炉渣会引起碱骨料反应危害.     

碳纳米管为基质对氨基酸的MALDI-FT MS分析

Twenty common amino acids have been analyzed successfully by matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS) using carbon nanotubes as matrix. From the spectra, little or no background interference or fragmentation of the analytes has been observed. This method was also applied to the analysis of amino acid mixture successfully. Carbon nanotubes have some features such as large surface area to disperse the analyte molecules sufficiently and prevent the sample aggregation and strong ultraviolet absorption to transfer energy easily to the analyte molecules. The present method has potential application for the rapid and sensitive analysis of amino acids and their mixture.     

常温直接沉淀法制备ZnO纳米棒

在常温下, 以PEG-400(聚乙二醇400)为表面活性剂, 采用直接沉淀法合成了ZnO纳米棒. 产物用XRD, TEM, SAED和 HRTEM等进行了表征. 结果表明, 所得ZnO为一维的纳米棒, 属于六方纤维矿的单晶结构. ZnO纳米棒的直径在20~40 nm之间, 长度在300~800 nm范围. (0001)面为ZnO纳米棒的生长方向. 讨论了ZnO相的生成和ZnO纳米棒的形成机理以及PEG-400在其形成过程中的作用.