ZnS∶Zn,Pb蓝粉在低压阴极射线激发下的应用

通过对ZnS∶Zn,Pb蓝色荧光粉进行表面包覆SiO2以改善其稳定性;In2O3材料的适量混合,提高了荧光粉的导电性,降低了它的起辉电压。采用沉淀法制备荧光屏,考察了阳极电压和阳极电流对亮度以及衰减过程的影响,实验结果表明ZnS∶Zn,Pb的性能优于ZnS∶Ag,Cl和ZnS∶Zn,可适用于FED等低压显示器。     

宽带膜厚实时监控过程中膜层折射率的确定方法

为了准确计算出镀膜过程中每层膜的折射率，介绍了实时监控过程中确定膜层折射率的2种方法：一种是由实测的透射比光谱直接反算出膜层的折射率；另一种是用最小二乘法的优化算法实时拟合折射率。试验结果表明：在线反算适合单点监控，所得折射率误差小于2%。然而在实际镀膜过程中,由于宽带内膜层参数误差较大,一般大于25%。为此，采用最小二乘法拟合，即在整个宽光谱范围内采集每个波长点的信息，所得结果误差很小，一般都在2％～5%之间,有时可达到10%,在很大程度上提高了实际镀膜时膜厚监控的精度。     

两种方法制备ITO薄膜的红外特性分析

比较了用电束加热蒸发法和直流磁控溅射法制备的氧化锡铟(ITO)薄膜在红外波段的光学特性实验发现,通过直流磁控溅射在常温下制备的ITO薄膜在红外波段折射率稳定、消光系数小,比电子束加热蒸发制备的膜有较高的透过率在波长1550nm附近的透过率可达86%以上,消光系数约为004,方电阻最低为100Ω/□.     

Zn(Thr)Ac2·2H2O固态配合物的制备及标准生成焓

在水-丙酮混合溶剂中合成了未见文献报导的Zn(Thr)Ac2@2H2O固态配合物,通过化学分析、元素分析、IR、XRD和TG-DTG等对其组成、结构及热稳定性进行了研究.用微量热法测定了配合物在298.15 K时在纯水中的溶解焓,计算了Zn(Thr)2+(aq,∞)和Zn(Thr)Ac2@2H2O(s)的标准摩尔生成焓分别为(955.24±5.70)kJ@mol-1和(-570.92±5.71)kJ@mol-1.     

相变光盘介电薄膜ZnS-SiO2 的微结构和光学特性

采用射频磁控溅射法制备了ZnS-SiO₂ 介电薄膜,利用透射电镜和椭偏仪研究了溅射条件对ZnS-SiO₂薄膜微结构和折射率n的影响.研究表明,ZnS-SiO₂薄膜中存在微小晶粒,大小为2～10 nm的ZnS颗粒分布在SiO₂基体中,当溅射功率和溅射气压变化时,ZnS-SiO₂薄膜的微结构和折射率n发生显著变化,微结构的变化是导致折射率n变化的主要原因,通过优化溅射条件可以制备适用于相变光盘的高质量ZnS-SiO₂介电薄膜.     

KrF激光诱导BrC2F4Br+C2H4反应

激光诱导化学合成是一有兴趣的课题。不久前已报导了红外激光诱导调聚反应的结果。由于红外激光的加热特性,在许多情况下导致选择性与量子产率的矛盾。因紫外光反应的低温特性,有可能获得较高的选择性。但普通光源是宽带光源,对一个以平方断链为主的链反应,过强的吸收不利于链长的提高,而弱吸收又使反应速度太慢。为此,激光光源是满足最佳吸收的合宜光源。在使用了昂贵的激光光源后,经济上的合理性主要取决于链长     

Structural and Electrical Characteristics of Pb（Zr0.53,Ti0.47）O3 Thin Films Deposited on Si （100） Substrates

Pb(Zr0.53, Ti0.47)O3 (PZT) films were directly deposited on Si substrates without a buffer layer by pulsed laser deposition. Only(110)-oriented PZT peaks (other than Si substrate peaks) were observed from the XRD data. The electrical properties of the PZT/Si capacitor were characterized in terms of both the capacitance versus voltage (C-V) and current versus voltage (I-V) measurements. The clockwise trace of the C-V curve shows ferroelectric polarization switching, as is expected. From the I-V curves, the Schottky emission and spacecharge-limited-current behaviour are found to be the mainly leakage current mechanism in a certain electric field range in the negative and positive bias, respectively.     

Deposition of Hydrogen-Free Silicon Nitride Thin Films by Microwave ECR plasma Enhanced Magnetron Sputtering at Room Temperature

Hydrogen-free silicon nitride （SiNx） films were deposited at room temperature by microwave electron cyclotron resonance （MW-ECR） plasma enhanced unbalance magnetron sputtering system. Both Fourier-transform infrared spectroscopy and x-ray photoelectron spectroscopy are used to study the bonding type and the change of bonding structures of the silicon nitride films. The results indicate that the chemical structure and composition of SiNx films deposited by this technique depend strongly on the N2 flow rates, the stoichiometric SiNx film, which has the highest hardness of 22.9 GPa, could be obtained at lower N2 flow rate of 4 sccm.     

Ultraviolet Luminescence in Mg0.12Zn0.88O Alloy Films

We investigate the origin of ultraviolet （UV） emission from Mg0.12 Zn0.88 O alloy thin films with a wurtzite structure fabricated on c-plane Al2O3 substrates by plasma assisted molecular beam epitaxy. At room temperature, the absorption edge and UV emission band of the Mg0.12Zn0.88O film shift to high-energy side compared with ZnO films. Temperature dependence of the photoluminescence spectra shows that the UV emission is composed of free exciton and neutral donor bound exciton emissions. Two-step dissociation processes of the UV emission are observed with the increasing temperature. The thermal quenching mechanism is attributed to the dissociation of the free exciton from the neutral donor bound exciton in the low temperature region and the dissociation of free electron and hole from the free exciton in the high temperature region.