High pressure X-ray diffraction study of CdAl2Se4 and Raman study of AAl2Se4 (A=Hg, Zn) and CdAl2X4 (X=Se, S)

We report the results of an X-ray diffraction study of CdAl₂Se₄ and of Raman studies of HgAl₂Se₄ and ZnAl₂Se₄ at room temperature, and of CdAl₂S₄ and CdAl₂Se₄ at 80 K at high pressure. The ambient pressure phase of CdAl₂Se₄ is stable up to a pressure of 9.1 GPa above which a phase transition to a disordered rock salt phase is observed. A fit of the volume pressure data to a Birch-Murnaghan type equation of state yields a bulk modulus of 52.1 GPa. The relative volume change at the phase transition at ∼9 GPa is about 10%. The analysis of the Raman data of HgAl₂Se₄ and ZnAl₂Se₄ reveals a general trend observed for different defect chalcopyrite materials. The line widths of the Raman peaks change at intermediate pressures between 4 and 6 GPa as an indication of the pressure induced two stage order-disorder transition observed in these materials. In addition, we include results of a low temperature Raman study of CdAl₂S₄ and CdAl₂Se₄, which shows a very weak temperature dependence of the Raman-active phonon modes.     

新颖外燃式湿空气燃气轮机循环及性能研究

本文首先提出一种新型的高效燃煤燃气轮机循环一外燃式湿空气透平循环动力系统。由于外燃的特点，作功工质为洁净湿空气，从而可以实现水的回收，是对常规ＨＡＴ循环的突破；另外洁净湿空气排放不受通常烟气露点限制，从而可回收利用湿空气降温时的低温凝结潜热，提高了加湿能力，从而提高系统性能。揭示了新型循环的基本规律；推导出具有湿化特点的约束方程和系统性能简明表达式，指明影响系统性能的关键因素。在透平初温为８５０℃的工况下，系统热效率高达４８．１１％。基于能量品位梯级利用原理和系统集成方法论，通过探索充分而合理利用中低温余热的有效途径，开拓洁净煤燃气轮机总能系统的新方向。     

测定麦芽糖转糖苷反应体系组成的高效液相色谱法

建立了分析低聚异麦芽糖组成的高效液相色谱法，采用Spherisorb-NH2色谱柱，示差折光检测器，乙腈－水（体积比70：30）为流动相，外标法定量测定；结果显示各糖质量浓度在0．1－10g/L范围内与峰面积呈良好线性关系，相关系数为0．999 0－0．999 7；应用法跟踪了pH5．0的柠檬酸－柠檬酸钠缓冲溶液中以α－葡萄糖转苷酶为催化剂在58℃温度下的麦芽糖转糖苷反应，分析了反应体系组成随时间的变化，得到了上述反应条件下麦芽糖最大限度地转化为低聚异麦芽糖的最佳反应时间为24h；该法快捷、简单、准确，可用于低聚异麦芽糖生产的质量控制。     

Weak convergence of the U-statistic and weak invariance of the one-sample rank order statistic for Markov processes and ARMA models

Harel and Puri (1989, J. Multivariate Anal. 29) studied the asymptotic behavior of the U-statistic and the one-sample rank order statistic for nonstationary absolutely regular processes. In this note, we present some applications of these results for Markov processes as well as ARMA processes.     

High-throughput screening of fuel cell electrocatalysts

The drawbacks of our earlier report of preparing fuel cell catalyst arrays by borohydride reduction of inkjet prepared arrays of metal salts are discussed along with the need for inclusion of state-of-the-art metrics in all array screening. An alternative method for screening of hydrogen/air cathode catalysts, direct methanol fuel cell (DMFC) anode catalysts, and catalyst loading studies is provided. State-of-the-art Johnson Matthey catalysts were used in control experiments to demonstrate the utility of the array fuel cell for high throughput screening of fuel cell catalysts in the 3-4 mg/cm² range. This report lays out hard learned rules for high throughput screening and demonstrates that the array fuel cell can be used for very precise screening of libraries of membrane electrode assembly (MEA) components without the pitfalls discussed in the introduction.     

Comparison of growth stress measurements with modelling in thin iron oxide films

High temperature oxidation of metals leads to residual stresses both in the metal and in the growing oxide. In this work, the evolution of this residual stresses is theoretically predicted in the growing oxide layers. The origin of these stresses is based on a microstructural model. Using experimental results providing from the oxidation kinetics, and an analysis proposed to describe the growth strain occurring in the thin layers, a set of equations is established allowing determining the stresses evolution with oxidation time. Then, the model is compared with experimental results obtained on both α-Fe and phosphated α-Fe, oxidised at different temperatures. Numerical data are extracted from experiments either with an asymptotic formulation or with an inverse method. These two methods give good agreement with experiments and allow extracting the model parameters.     

一种高信噪比的双光束激光光声光谱仪原理及应用

作为一种新兴的检测手段 ,激光光声光谱技术与其他检测技术相比具有很多优点。本文设计的光声光谱仪用激光做光源 ,有两个光声池 ,分别用来放置参考样品和待测样品 ,输出结果为二者光声信号的比值。利用这一比值 ,可以由参考样品的性能参数方便地求出待测样品的相关性能参数。该光声光谱仪有效地减小了本底吸收噪声的影响 ,提高了信噪比 ,扩大了固体光声理论的应用范围。本文还阐述了该光声光谱仪在定性定量分析中的一些应用     

INTERSECTION OF PRIME SUBMODULES AND DIMENSION OF MODULES

The aim of this paper is to study the conditions by which a P-prime submodule can be expressed as a finite intersection or union of P-prime submodules. Also corresponding to dimension and rank of modules, some equivalent conditions for a ring to be a Dedekind domain are given.     

高频聚焦换能器声场的激光测量法

本文描述了一种使用激光测振技术测量高频聚焦换能器声场布的方法，并给出了使用该方法对一种高频聚换能器进行测量的结果，通过理论计算对结果的正确性进行了验证。     

CFD在燃煤细粒子凝聚过程中的应用

燃煤产生的细粒子富集了大量的有毒痕量元素,对大气环境和人类健康造成严重危害。本文针对燃煤细粒子的形成过程,在计算流体力学(CFD)的基础上,结合气溶胶动力学理论,模拟了烟气中细粒子在圆柱形流场中由于碰撞而凝聚的过程,并通过计算结果分析细粒子颗粒特征参量(速度、质量、直径和颗粒数目)随流场的变化趋势,为深入研究燃煤细粒子的形成演化机理提供理论基础。