La掺杂浓度对PLZT薄膜红外光学性质的影响

采用溶胶-凝胶法在Pt/Ti/SiO2/Si衬底上制备了不同La掺杂浓度PLZT(x/40/60)薄膜- x射线衍射分析表明制备的PLZT(x/40/60)薄膜是具有单一钙钛矿结构的多晶薄膜- 通过红外椭圆偏振光谱仪测量了波长为2-5—12-6μm范围内PLZT薄膜的椭偏光谱，采用经典色 散模型拟合获得PLZT薄膜的红外光学常数，同时也拟合获得PLZT薄膜的厚度- 随着La掺杂浓 度的增大，折射率逐渐减小- 而消光系数除PLZT(4/40/60)薄膜外，呈现逐渐增大的趋势- 分析表明这些差异主要与PLZ 关键词： PLZT薄膜 红外光学性质 红外椭圆偏振光谱     

Influence of silicon on the microstructure and mechanical properties of Zr-Si-N composite films

A series of Zr-Si-N composite films with different Si contents were synthesized in an Ar and N₂ mixture atmosphere by the bi-target reactive magnetron sputtering method. These films’ composition, microstructure and mechanical properties were characterized by energy dispersive spectroscopy, X-ray diffraction, scanning electron microscopy, atomic force microscopy and nanoindentation. Experimental results revealed that after the addition of silicon, Si₃N₄ interfacial phase formed on the surface of ZrN grains and prevented them from growing up. Zr-Si-N composite films were strengthened at low Si content with the hardness and elastic modulus reaching their maximum values of 29.8 and 352 GPa at 6.2 at% Si, respectively. With a further increase of Si content, the crystalline Zr-Si-N films gradually transformed into amorphous, accompanied with a remarkable fall of films’ mechanical properties. This limited enhancement of mechanical properties in the Zr-Si-N films may be due to the low wettability of Si₃N₄ on the surface of ZrN grains.     

Conductivity and dielectric properties of sol–gel derived porous zirconia

The 8-mol percentage Y₂O₃-stabilized Porous Zirconia was prepared using sol–gel method. Zirconium oxalate gel was prepared by the addition of appropriate amount of oxalic acid solution into the 1 M aqueous solution of zirconium-oxy chloride. A cubic phase zirconia powder was obtained by calcination and milling of the zirconium oxalate gel. Crystallization temperature was found about 450 °C from the Differential thermal analysis. The phase analysis by X-ray diffraction shows the presence of cubic phase. Pellets sintered at 1,350 °C were highly porous, and the electrical conductivity was found with lower value due to the porosity, and the hardness was about 8.0 GPa. Paper presented at the Third International Conference on Ionic Devices (ICID 2006), Chennai, Tamilnadu, India, Dec. 7–9, 2006.     

ZnSe/SiO2复合薄膜光学常数与荧光光谱的研究

采用溶胶-凝胶工艺与原位生长技术，制备了ZnSe/SiO₂复合薄膜.X射线衍射分 析表明薄膜中ZnSe晶体呈立方闪锌矿结构.X射线荧光分析结果显示薄膜中Zn与Se摩尔比为1 ∶1.01—1∶1.19.利用场发射扫描电子显微镜观察了复合薄膜的表面形貌，结果表明复合薄 膜表面既存在尺寸约为400nm的ZnSe晶粒，也存在尺寸小于100nm的ZnSe晶粒.利用椭偏仪测 量了薄膜椭偏角Ψ，Δ与波长λ的关系，采用Maxwell-Garnett有效介质理论对薄膜的光学 常数、厚度、气孔率、ZnS 关键词： 2复合薄膜')" href="#">ZnSe/SiO₂复合薄膜 光学性质 椭偏光度法 荧光光谱     

Making equation of state models predictive: Part 2: An improved PCP-SAFT equation of state

We use the PCP-SAFT equation of state, which is of the Van der Waals type and has a sound physical basis, to predict mixture properties, such as vapor–liquid and liquid–liquid equilibria, as well as excess enthalpies. We use molecular properties, such as dipole moment, quadrupole moment, polarizability and dispersion interaction coefficients, that have been determined quantum mechanically in Part I of this publication and adjust the remaining three pure compound parameters to pure compound data. We finally present a new combination rule for the dispersion energy parameter ? that is based on the quantum mechanically determined data. The predictions based on quantum mechanically determined pure compound properties along with the new combination rule show an improved performance compared to the original PCP-SAFT combination rule.     

Voltage ‐ Current Study of an Atmospheric Dielectric Barrier Discharge

The discharge behaviour of an atmospheric dielectric barrier parallel plate discharge, used for surface treatment, is studied. Since an uniform plasma is preferable for surface treatment, filaments must be avoided in the discharge. The occurrence of filaments can be detected by measuring the current flowing through the discharge. Current and voltage measurements give an indication of the power consumption by the plasma. The power consumption of the plasma as function of the applied frequency is examined. (© 2007 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Structure and mechanical properties of Al/AlN multilayer with different AlN layer thickness

Nanometer scale Al/AlN multilayers have been prepared by dc magnetron sputtering technique with a columnar target. A set of Al/AlN multilayers with the Al layer thickness of 2.9 nm and the AlN layer thickness variation from 1.13 to 6.81 nm were determined. Low angle X-ray diffraction (LAXRD) was used to analyze the layered structure of multilayers. The phase structure of the coatings was investigated with grazing angle XRD (GAXRD). Mechanical properties of these multilayers were thoroughly studied using a nanoindentation and ball-on-disk micro-tribometer. It was found that the multilayer hardness and reduced modulus showed no strong dependence on the AlN layer thickness. Al2.9 nm/AlN1.13 nm multilayer had more excellent tribological properties than single layers and other proportion multilayers with a lowest friction coefficient of 0.15. And the tribological properties of all the multilayers are superior to the AlN single layer.     

<Emphasis Type="Italic">Comment on</Emphasis>¶Low temperature specific heat of blue bronze K <Emphasis Type="Bold">0.30</Emphasis>MoO <Emphasis Type="Bold">3</Emphasis>, by J. Odin,J.C. Lasjaunias,K. Biljaković, K. Hasselbach,and P. Monceau

Eur. Phys. J. B 24, 315 (2001) Here we comment on a recently published paper on the presence of a phason contribution in the low temperature heat capacity data of the charge-density-wave compounds K_0.3MoO₃ and (TaSe₄)₂I. We have shown that the anomaly in the C _P / T ³ data reported by Odin et al. is straightforwardly interpreted in terms of low energy phonon modes resulting from the peculiar topology of these compounds. Received 21 February 2002 Published online 19 July 2002     

相互作用对玻色气体热力学性质及稳定性的影响

根据由赝势法得到的非理想玻色气体的自由能和状态方程，研究了相互作用对凝聚温度的影响.从热力学角度揭示了存在引力作用时定压热容量、等温压缩系数、定压膨胀系数的反常热力学特性.研究了引力作用下玻色气体系统的不稳定性，给出了不稳定性的温度判据和粒子数密度判据. 关键词： 相互作用 玻色气体 热力学性质 不稳定性判据     

二维随机激光器的模式选择及阈值与饱和特性

基于将Maxwell方程与四能级原子系统速率方程相结合而建立起随机激光时域理论，并利用有限时域差分法，研究了二维随机介质中激光模式的输出特性与介质尺寸、外形及抽运速率等参数的关系.结果表明，与传统激光模式相似，随机激光模式的强度随抽运速率的变化不仅具有阈值特性，而且具有饱和特性.基于模式特性对介质及抽运参数的依赖关系，提出了二维随机激光器的选模方式，在很大程度上不同于传统激光器的选模方式. 关键词： 随机激光器 模式选择 无序介质中的光学特性