Yeast cell microfiltration: Flux enhancement in baffled and pulsatile flow systems

The filtration performance of yeast cell harvesting was greatly improved by using an oscillatory flow mixing technique in both tubular and flat sheet membrane systems; flux increases of several fold were achieved. The effects of various operating parameters such as frequency, amplitude and ratio of net forward flow rate to oscillatory flow rate were investigated. A simple alternative to the dual head pump, which involved the use of solenoid valves for producing flow reversal, was developed. The flux was significantly increased using this new operating mode. As the only increase of power consumption was from inertia loss due to change of flow direction the additional power consumption is minimal.     

A Novel Preprocessing Algorithm for Three-Way HPLC Data

Orthogonal signal correction (OSC) was a data preprocessing algorithm. It ensured that the filtered information was irrelevant to concentration data while using it to filter the noise from the original data. This paper extended the OSC application range from two-way data to three-way data. Two drug data sets, Enoxacin, Norfloxacin, Ciprofloxacin and Betamethasone, cortisone acetate, prednisone acetate, showed that the application of the OSC algorithm to three-way HPLC data was feasible and needed further research.     

X-射线荧光分析散射幂函数法原理及其应用I·RhKα相干散射平方法

本文发现6~40号元素对能量为20keV的X_射线的质量吸收系数和质量相干散射系数之间呈二次幂函数关系,并据此提出了X_射线荧光定量分析校正基体效应的新方法——RhKa相干散射平方法.用国家标准物质GBW对该原理进行了验证.本法用于硅酸盐地质样品中微量元素的测定取得令人满意的结果.     

电感耦合等离子体原子发射光谱法测定镍基单晶高温合金中Mo、W、Ta、Re、Ru时元素之间相互干扰的消除与校正的研究

称取镍基单晶高温合金0.100 0g于聚四氟乙烯烧杯中,先令其与盐酸9mL和硝酸1mL加热反应,待反应缓慢时滴加氢氟酸2mL并继续加热使样品完全溶解。加入500g·L^-1酒石酸溶液2mL,冷却至室温,在塑料容量瓶中加水定容至100.0mL。按仪器工作条件采用电感耦合等离子体原子发射光谱法测定其中5种合金元素(Mo、W、Ta、Re、Ru)的含量,选择分析谱线依次为204.598,207.911,240.063,197.312,240.272nm。结果发现:除了Re外,其余4种元素的测定中均受共存元素的光谱干扰,严重影响了测定结果的准确性。为克服其干扰,除了采用基体匹配法消除镍的基体干扰外,试验采用混合校正系数矩阵法对测定结果进行校准。通过一系列试验计算得到混合校准系数矩阵K,并应用于模拟样品的分析。结果表明:经过矩阵K的校准,所测定的5种元素的准确度显著提高,达到了消除共存元素之间光谱干扰的目的。通过精密度试验,测得上述5种元素测定值的相对标准偏差(n=11)均在1.5%以下,并通过标准加入法进行回收试验,测得5种元素的回收率为97.0%~105%。     

Synthesis and Crystal Structure of Ho_4S_3Si_2O_7

1 INTRODUCTION Halide fluxes are excellent media for growing single crystals of chalcogenides[1~5]. On our research in the Ln-Cu-Zn-Se system to find new phases and to search for potential infrared ceramic materials, two new compounds, KHo2CuSe4 and KEr2CuSe4, were synthesized from the reaction of the precursor with KCl flux[6]. In an attempt to synthesize the homologous sulfide by the same method using KBr as flux in a sealed evacuated quartz tube, single crystals of Ho4S3Si2O7 w…     

助熔剂对Y3Al5O12：Ce荧光粉性能的影响

在还原气氛下采用高温固相反应法合成了白光LED用黄色荧光粉Y3Al5O12:Ce(YAG:Ce)研究了助熔剂对YAG：Ce荧光粉发光特性的影响，。XRD的测量结果表明加入合适的助熔剂有利于YAG:Ce荧光粉的晶化，并且不引入杂相，选择BaF2和H3BO3同时使用效果要好于单独使用一种助熔剂，助熔剂的加入可增大YAG：Ce荧光粉的激发和发射光谱强度，并能有效降低荧光粉的中心粒径（D50）控制粉体的粒径分布，适用于白光LED的制造。     

高频燃烧红外吸收光谱法测定钨钛合金中碳含量

建立高频燃烧红外吸收光谱法测定钨钛合金中碳含量的分析方法。在1980 W分析功率下,称取0.3 g样品,以2.0 g钨锡及0.5 g纯铁混合助熔,用高频红外分析仪测定碳。碳的含量在0.013%~0.050%范围内与红外吸收峰面积线性相关,相关系数为0.9993。碳的测定下限为3.6μg/g,方法检出限为1.08μg/g。该法测定结果的相对标准偏差为2.97%~4.11%(n=8),碳的加标回收率为96.2%~103.1%。该方法能够满足合金中碳含量的分析要求。     

神府烟煤以及贵阳贫煤分别与木屑掺烧灰沉积特性研究

利用CCD相机和沉积探针组成的在线监测系统，在50 kW下行炉上研究了木屑与神府烟煤以及贵阳贫煤的掺烧灰沉积特性。灰渣沉积过程可分为三个阶段：缓慢增长阶段、快速增长阶段和稳定阶段。烟煤掺烧灰沉积厚度随着木屑掺烧比例的增加而增加，贫煤掺烧灰沉积厚度则随着木屑掺烧比例增加而减小。烟煤中掺烧木屑比例为0、6.7%、15%和22%时，渣层稳定厚度分别为1.37、3.85、11.50、20.56 mm，稳定相对热流密度分别为0.44、0.41、0.30、0.26。贫煤掺烧木屑比例为6.7%、15%和22%时，稳定厚度分别为18.65、10.97和9.78 mm，稳定相对热流密度分别为0.29、0.31、0.33。掺烧木屑之后，灰渣初始层中Ca、K元素显著增加。在相同温度下，随着木屑掺烧比例的增加，灰中熔融相比例增加，因为木屑灰分中含有较多的Na₂O、K₂O等碱金属氧化物，而Al₂O₃、SiO₂等含量较少，降低了灰的熔融温度。     

Correction procedure for the electron microprobe analysis of porous materials

A correction method is proposed for the quantitative determination of stoichiometric ratios in porous materials by electron microprobe analysis. Analysis of this kind of material is complicated by an imperfect surface that can only be improved to some extent. The correction is based on a linear dependence (different for each element) of the analyses on a sum of weight concentrations of oxides. With this correction it is possible to use analyses affected by the imperfection of the surface with much better confidence compared to common normalisation. An example is presented for a series of ceramic superconductors Bi_2.1(SrCa)_2.9Cu₂O₈₊.