纳米SrTiO3对高铁酸盐电化学性能影响研究

Two ferrates, K₂FeO₄ and BaFeO₄, had been prepared and characterized by XRD, IR and SEM. The electrochemical tests of the samples were carried out in the voltage range of 0.8～2.0 V and current density of 0.5～3.0 mA·cm^-2. The results indicated that performance of Zn-BaFeO₄ battery was superior to that of Zn-MnO₂ and Zn-K₂FeO₄ batteries. Nanometer SrTiO₃ prepared by Sol-gel methode with different ratio was added to the BaFeO₄ cathode in order to improve the discharge performance. The discharge capacity of the BaFeO₄ cathode was increased from 224 mAh·g^-1 to 246 mAh·g^-1 by addition of 5% nanometer SrTiO₃. The reason of enhancing BaFeO₄ electrochemical performance was discussed.     

Pt掺杂对Mo-Ru-Se簇合物电催化氧还原性能的影响

直接甲醇燃料电池(DMFC)是理想的移动电源,但因金属Pt阴极催化剂的选择性较差,甲醇在阴极产生“混合电位”,导致电池效率降低。抗甲醇氧电还原催化剂可降低“混合电位”,是解决该问题的有效的方法。     

牙本质中天冬氨酸消旋化程度的测定——手性毛细管气相色谱法与高效液相色谱法的比较

应用手性毛细管气相色谱法（酸性异丙醇、三氟乙酸酐为衍生试剂）、高效液相色谱法（邻苯二甲醛－Ｎ－乙酰－Ｌ－半胱氨酸为手性衍生试剂）同时测定人类第一磨牙牙本质中天冬氨酸的消旋化程度，结果表明，两者均可有效地用于天冬氨酸对映体的分离测定，但气相色谱检测限（０．２ｐｍｏｌ）低于高效液相色谱（１．０ｐｍｏｌ），而变异系数（７％）、总分析时间（１００ｍｉｎ）均高于高效液相色谱（分别对应为４％，３１ｍｉｎ）。     

无机胶体法制备Pt/C催化剂及其性能表征

采用无机胶体法制备用于质子交换膜燃料电池(PEMFC)的Pt/C催化剂。研究了影响PtO₂胶体生成和稳定性的因素(溶液的pH值、浓度和温度条件等)以及不同还原剂浓度对Pt/C催化剂性能的影响。透射电子显微镜测试结果表明，采用经优化的工艺条件所制备的Pt/C催化剂平均粒径为3 nm，且分散性好、粒度均匀。X-射线衍射分析表明，催化剂中Pt(111)晶面的相对含量较高，有利于加速氧还原反应。单体PEMFC的电压/电流密度曲线测试表明，所制备的Pt/C催化剂具有良好的电化学性能。     

高效毛细管电泳法测定二氢叶酸还原酶活力的研究

通过胶束电动毛细管电泳法研究分离二氢叶酸还原酶体系中二氢叶酸、四氢叶酸、 NADP、 NADPH和酶5种组分,在含0.002%Brij-35的pH 9.18 50 mmol/L 的硼砂缓冲溶液中,5种组分在18min内得到基线分离.通过对其产物四氢叶酸峰面积的定量测定,计算出二氢叶酸还原酶的米氏常数,建立了毛细管电泳法对二氢叶酸还原酶活力的测定方法.     

Aromatic poly(sulfone sulfide amide imide)s as new types of soluble thermally stable polymers

A new diamine monomer containing flexible sulfone, sulfide, and amide units was prepared via three steps. Nucleophilic chloro displacement reaction of 4‐aminothiophenol with 4‐nitrobenzoyl chloride in the presence of propylene oxide afforded N‐(4‐mercapto‐phenyl)‐4‐nitrobenzamide and subsequent reduction of the nitro intermediate led to 4‐amino‐N‐(4‐mercapto‐phenyl)benzamide. Two moles of this amino thiophenol compound was reacted with bis‐(4‐chloro phenyl)sulfone to provide a novel diamine monomer. The diamine was reacted with aromatic dianhydrides to form polyimides via a two‐step polycondensation method, formation of poly(amic acid)s, followed by chemical imidization. The resulting polymers were characterized and their physical properties including thermal behavior, thermal stability, solubility and inherent viscosity were studied. Copyright © 2007 John Wiley & Sons, Ltd.     

免疫亲和柱净化/柱前衍生化-高效液相色谱荧光检测法测定粮谷中的T-2毒素

建立了免疫亲和柱净化/柱前衍生化-高效液相色谱荧光检测器测定粮谷中T-2毒素含量的方法。样品经甲醇-水(体积比为80∶20)混合溶剂提取,通过免疫亲和柱(IAC)净化,以氰酸蒽(1-AN)为衍生化试剂、4-二甲基氨基吡啶(DMAP)为催化剂进行衍生,以ZORBAX Eclipse XDB-C18 柱为分离柱,乙腈-水(体积比为80∶20)为流动相进行高效液相色谱分离及荧光检测，荧光检测的激发波长为381 nm，发射波长为470 nm。T-2毒素的质量浓度为0.01~1.5 mg/L时与峰高呈良好的线性,相关系数为0.9985。在0.01~1.5 μg/g添加水平下，回收率为79.7%~94.5%,相对标准偏差小于7%；检出限（S/N＝3）为0.01 μg/g。该方法净化效果好,灵敏度高,操作简便快速。     

Quantitative determination of UV filters in sunscreen lotions using microemulsion electrokinetic chromatography

Microemulsion electrokinetic chromatography (MEEKC) has been applied to the separation of some UV filters (Eusolex 4360, Eusolex 6300, Eusolex OCR, Eusolex 2292, Eusolex 6007, Eusolex 9020, Eusolex HMS, Eusolex OS, and Eusolex 232) commonly used in sunscreen lotions. Use of a MEEKC buffer with a mixed surfactant system to stabilize the oil droplets and an organic modifier in the aqueous phase allowed separation of most of the selected analytes in a single run in a system fitted with a diode array detector recording three wavelengths (240 nm, 300 nm, and 380 nm) simultaneously. The microemulsion employed consisted of 2.25 g of SDS, 0.75 g of Brij 35, 6.6 g 1‐butanol, 0.8 g n‐octane, 17.5 g 2‐propanol, and 72.1 g of 10 mM borate buffer (pH 9.2). Detection limits from 0.65 to 6.0 μg/mL were obtained and the calibration plots were linear over at least one order of magnitude for all analytes. The developed method could be applied to the determination of UV filters in several sun protection products including lotions, milks, and oils. Comparison of the obtained data with those from an HPLC method described in the literature showed acceptable agreement.     

负载型TiO2-聚酰亚胺亲水复合膜的制备与分离性能

采用溶解－流涎法，湿相转换法和干湿相转换法制轩了负载型ＴｉＯ２－聚酰亚胺亲水复合膜，采用扫描电镜，红外光谱，压汞和透气性实验等手段对该膜的孔径分布，表面结构及扩散性能进行了表征，并讨论了制备亲水对膜孔结构的影响，实验结果表明，三种膜均具有很好的亲水性能，而干湿相转换膜具有良好的孔径分布和分离性能。     

煤液化残渣与褐煤混煤燃烧特性的实验研究

煤液化是提高煤炭资源利用率、减轻燃煤污染的有效途径[1].在煤液化工艺过程中,煤液化残渣的主体是由液化原料煤中未转化的煤有机体、无机矿物质以及外加的液化催化剂组成,是一种高炭、高灰和高硫的物质,在某些工艺中会占到液化原煤总量的30%左右,如此多的残渣量对液化过程的热效率和经济性所产生的影响是不可低估的[2].