纳米级稠化剂颗粒沉积膜在乏脂润滑中的作用机制研究

利用双光束干涉法对点接触区乏脂润滑成膜特性规律以及接触区附近润滑剂的微观迁移特性进行了观测.在试验条件下,接触区会经历充分润滑—乏脂—沉积膜润滑—分离油润滑等润滑状态.借助原子力显微镜,探测到沉积膜是润滑脂的稠化剂被碾压破碎而沉积在滚压轨道表面的一层纳米级颗粒薄膜;而分离油是在剪切过程中润滑脂内逐渐释放基础油.试验初始,接触区周围的润滑脂池因乏脂而迅速消失,但分离油会逐渐形成"第二相油池"以实现回流补给.沉积膜增大了基础油在滚动轨道表面的接触角,阻碍回流补给,但其会随运动逐渐磨损,此后分离油将进入接触区补充润滑膜.初步发现,当分离油不充足时,沉积膜有利于保护润滑轨道.     

Fast calibration methods using cosmic rays for a neutron detection array

An overall irradiation and calibration technique was introduced and applied to a test scintillation detector array. An integral conversion method was used to reduce the nonlinearity of the time difference spectrum, and to improve the position determination especially for positions close to the two ends of a long scintillation bar. An overall position resolution of about 3.0 cm (FWHM) was extracted from the residual analysis method and verified by a direct measurement. Energy calibration was also realized by selecting cosmic rays at different incident angles. The bulk light attenuation lengths for the four test bars were also determined. It is demonstrated that these methods are especially efficient for calibrating large and complex detector arrays.     

Rechargeable lithiated silicon-sulfur (SLS) battery prototypes

Amorphous columnar structured silicon film electrodes were prepared and electrochemically tested in dioxolane based electrolyte solution, containing LiNO₃. The electrochemical performance of prelithiated amorphous silicon anodes coupled with sulfur composite cathodes was evaluated in full Si-Li-Sulfur (SLS) cells. The reversible capacity at the first 10 cycles was 600 mAh/g sulfur with gradual fading to ~ 380 mAh/g sulfur after 60 cycles which is the highest obtained capacity reported for SLS full cells. Possible reasons for this capacity fading are discussed.     

Matrix‐assisted laser ablation production of gold cluster ions from Au‐coated photonic crystals

A new strategy was explored to generate pure gold cluster ions, Au_n^+/?, from gold films deposited on solid substrates via a matrix‐assisted laser ablation technique. The gold films deposited on SiO₂‐particle‐assembled photonic crystals were demonstrated to be the most ideal compared with the films deposited on various glass slides. Dropped with a matrix of 2‐(4‐hydroxyphenylazo) benzoic acid and bombarded by nitrogen pulse laser (355 nm), they could release a series of Au_n⁺ with n more than 110 or Au_n^? with n more than 60 according to the data obtained by inline time‐of‐flight mass spectrometry. The gold‐deposited photonic crystal substrates could be stored at room temperature for at least 6 months. The method is hence steady and convenient in use. Copyright © 2012 John Wiley & Sons, Ltd.     

正交实验研究硝酸改性对活性焦表面性质及脱硫性能的影响

用硝酸对活性焦进行改性,采用正交实验法,考察了硝酸浓度、活化温度、活化时间以及煅烧温度对活性焦脱硫性质的影响,并在固定床反应装置上进行了活性焦评价实验。利用酸碱滴定、碘值测定、N₂吸附法、傅里叶红外光谱分析等对改性活性焦的表面酸碱性、比表面积、孔容等进行了分析和表征。实验结果表明,硝酸改性增加了活性焦的比表面积,提高了活性焦表面碱性;煅烧有助于提高表面碱性;硝酸改性明显提高了活性焦的脱硫性能。     

乙烯装置裂解炉管焦炭燃烧特性的研究

齐鲁石化公司乙烯厂是我国最先引进计算机控制下蒸汽 空气在线烧焦技术的乙烯厂 ,在线烧焦使其过程自动化程度大大提高 ,裂解炉没有升降温过程 ,延长了裂解炉管的使用年限[1～ 5] 。但裂解气盘管管径较小 ,易于堵塞 ,烧焦时间稍短 ,管壁上的焦炭就燃烧不完全 ,目前在线烧焦时间还需 70ｈ～ 80ｈ。为了进一步缩短烧焦时间 ,节约能源 ,提高炉子运行周期 ,必须对乙烯装置裂解炉管焦炭的微观结构及燃烧过程进行深入研究 ,以提出进一步加快烧焦速度的办法 ,满足工业生产的需要。本研究采用国内某乙烯厂裂解炉管焦炭为实验原料 ,研究了焦炭的微观…     

Ni-W-纳米Al2O3复合涂层沉积特性的研究

采用复合电镀的方法制备出Ni-W-纳米Al2O3复合涂层,研究了Al2O3添加量、温度和超声波分散等沉积条件对复合涂层沉积特性如沉积速率、Al2O3复合量和显微硬度的影响.结果表明,随着纳米Al2O3添加量的增加,复合涂层的沉积速率、Al2O3复合量和显微硬度不断增加,但当Al2O3添加量达到15g/L时沉积速度开始下降,Al2O3添加量达到17.5g/L时硬度开始下降;适宜的镀液温度大约为80℃,超声波分散时间大约为1h.     

聚乙二醇类表面活性剂对硅表面无电沉积Ag膜光滑作用研究

应用原子力显微镜技术及开路电位～时间谱技术,研究了非离子表面活性剂聚乙二醇2000,6000,20000对硅(100)表面无电沉积银膜的光滑作用.实验表明硅(100)表面无电沉积银的光滑程度以及镀层的质量均随聚乙二醇聚合度的增加而变好.     

ZnHZSM－5芳构化催化剂积炭影响因素的研究

本文利用ＮＨ３－ＴＰＤ，ＩＲ，Ｃａｈｎ－２０００电天平及微型反应装置，考察了ＺｎＨＺＳＭ－５沸石催化剂在劳构化反应中的积炭行为．结果表明，催化剂的表面酸强度和性质、酸中心密度及晶粒大小都对结炭有显著的影响．加入Ｐｔ４＋可抑制积炭．外表面中毒则加速炭的生成．积炭分为两个阶段进行，积炭初始主要发生在沸石催化剂晶粒内部．预结炭并钝化炭表面可提高ＺｎＨＺＳＭ－５催化剂的稳定性．