Ceramic Films via Organometallic Complex as Single Source Precursor

Fe2(CO)6(μ-S2) was used as a single source precursor in attempt to produce FeS film via MOCVD. Pyrolysis of Fe2(CO)6(μ-S2) at temperature below 500℃ produced Fe1-xS or Fe7S8 powder as indicated by its powder X-ray spectra. At 750 ℃, polycrystalline FeS powder was obtained. In film deposition, polycrystalline Fe1-xS or Fe7Ss films were obtained on Si(100) and Ag/Si(100) substrates below 500 ℃. SEM micrographs showed the film on Si(100) substrate containing whisker like grains. However, pillar like grains were obtained on Ag/Si(100) substrate.Deposition rates are also different for different substrates as evaluated by the thickness of the films, which were obtained by SEM micrographs of the cross section of the films. At 750℃, similar polycrystalline Fe1-xS or Fe7S8 film was obtained.     

Local adsorption sites and bondlength changes in Ni(1 0 0)/H/CO and Ni(1 0 0)/CO

The local adsorption geometry of CO adsorbed in different states on Ni(1 0 0) and on Ni(1 0 0) precovered with atomic hydrogen has been determined by C 1s (and O 1s) scanned-energy mode photoelectron diffraction, using the photoelectron binding energy changes to characterise the different states. The results confirm previous spectroscopic assignments of local atop and bridge sites both with and without coadsorbed hydrogen. The measured Ni–C bondlengths for the Ni(1 0 0)/CO states show an increase of 0.16 ± 0.04 Å in going from atop to bridge sites, while comparison with similar results for Ni(1 1 1)/CO for threefold coordinated adsorption sites show a further lengthening of the bond by 0.05 ± 0.04 Å. These changes in the Ni–CO chemisorption bondlength with bond order (for approximately constant adsorption energy) are consistent with the standard Pauling rules. However, comparison of CO adsorbed in the atop geometry with and without coadsorbed hydrogen shows that the coadsorption increases the Ni–C bondlength by only 0.06 ± 0.04 Å, despite the decrease in adsorption energy of a factor of 2 or more. This result is also reproduced by density functional theory slab calculations. The results of both the experiments and the density functional theory calculations show that CO adsorption onto the Ni(1 0 0)/H surface is accompanied by significant structural modification; the low desorption energy may then be attributed to the energy cost of this restructuring rather than weak local bonding.     

不良导体热系数和热体散热率测量方法研究(英文)

本文介绍一种直接测量散热率新方法．进而测出不良导体的热系数。该方法，减小了由间接测量散热率所带来的误差，实验装置简单，操作方便，参数少，测量结果的精确性和重复性都有较大提高，更重要的是这一新的实验方法突出了物理思想。     

Noise-assisted mound coarsening in epitaxial growth

Two types of mechanisms are proposed for mound coarsening during unstable epitaxial growth: stochastic, due to deposition noise, and deterministic, due to mass currents driven by surface energy differences. Both yield the relation H=(RWL)² between the typical mound height W, mound size L, and the film thickness H. An analysis of simulations and experimental data shows that the parameter R saturates to a value which discriminates sharply between stochastic () and deterministic () coarsening. We derive a scaling relation between the coarsening exponent 1/z and the mound-height exponent which, for a saturated mound slope, yields . Received: 11 November 1997 / Revised in final form: 28 November 1997 / Accepted: 28 November 1997     

Synthesis of Dimethyl Carbonate from CO2 , Methanol, and Epoxides Using Re（CO） 5 Cl/K2 CO3 as Catalyst System

IntroductionOver the past few years, dimethyl carbonate(DMC) has been proven to be an efficientmethylating,methoxylating, and methoxycarbonylating agent inorganic syntheses, in which DMC is used to replace thetoxic methyl halides, dimethyl sulfate or carb     

BRD96N光调制吸收增强现象的实验研究

通过光谱响应特性实验和记录／读出图像实验，研究了基因变异型细菌视紫红质（BR_D96N）分子膜对单色光的光调制特性.发现BR_D96N分子膜在550nm—600nm范围内对调制光有吸收增强的现象，且对此范围内不同波长的单色光其调制程度有差异.利用曲线拟和方法发现550nm—600nm吸收增强的变化过程分为快过程和慢过程，其对应的时间常数分别为30s和5min.利用强度调制器的吸收强度与图像灰度之间的关系，分析了560nm—600nm范围内出现图像反转的实验现象. 关键词： 细菌视紫红质D96N分子膜 光谱响应 吸收增强现象 图像反转现象     

Simulation and fabrication of carbon nanotubes field emission pressure sensors

A novel field emission pressure sensor has been achieved utilizing carbon nanotubes (CNTs) as the electron source. The sensor consists of the anode sensing film fabricated by wet etching process and multi-wall carbon nanotubes (MWNTs) cathode in the micro-vacuum chamber. MWNTs on the silicon substrate were grown by thermal CVD. The prototype pressure sensor has a measured sensitivity of about 0.17-0.77 nA/Pa (101-550 KPa). The work shows the potential use of CNTs-based field-emitter in microsensors, such as accelerometers and tactile sensors.     

Dynamic response of permalloy/Cu/Co magnetoresistive sandwiches

The dynamic response of trilayer magnetoresistive permalloy/Cu/Co films was studied by high-frequency permeability spectra measurements. The resonance frequency is shown to depend on the interlayer copper thickness. This dependence is related to exchange coupling between permalloy and cobalt and the interaction field is estimated using the Landau–Lifschitz–Gilbert model.     

非晶硅薄膜的低温快速晶化及其结构分析

在镀铝的廉价玻璃衬底上高速沉积的非晶硅薄膜在不同的温度下退火10min.退火温度为500℃时,薄膜表面形成了硅铝的混合相,非晶硅薄膜开始呈现了晶化现象 退火温度为550℃时,大部分(约80%)的非晶硅晶化为多晶硅,平均晶粒尺寸为500nm 退火温度为600℃时,几乎所有的非晶硅都转化为多晶硅,其平均晶粒尺寸约为15μm.     

电子辐照诱发固态相变导致的氮化硼纳米结构生长

报道了N+离子轰击产生的氮化硼(BN)纳米结构,及在电子辐照时结构演化的高分辨透射电子显微镜的原位测定结果.应当强调的是,这种类富勒烯和发夹结构的演化,实际上是电子辐照诱发固态相变的发展,观察中发现的一些BN颗粒、卷曲物,可以被认为是类富勒烯等纳米结构形成的前体或早期阶段.提出了一种类富勒烯等结构的电子辐照动力学模型,并进行了讨论. 关键词： 氮化硼 电子辐照 透射电子显微镜 氮化硼纳米形成物