Simultaneous determination of digoxin and digitoxin by micellar electrokinetic chromatography and application to drug formulations

A simple micellar electrokinetic chromatographic method is described for simultaneous determination of digoxin and digitoxin. The simultaneous analysis of digoxin and digitoxin was performed in Tris buffer (10 mM; pH 9) with 90 mM sodium dodecyl sulfate and 10% isopropyl alcohol as an anionic surfactant and organic modifier. Under these conditions, good separation with high efficiency is achieved in short analysis times. Several parameters affecting the separation of the drugs were studied, including the pH and concentrations of the Tris buffer and sodium dodecyl sulfate. The linear range of the method for the determination of digoxin and digitoxin was over 0.01–0.3 mg/mL; the detection limit (signal to noise ratio = 3; injection 3.5 kPa 3 s) was 4 and 6 μg/mL, respectively. Application of the proposed method to the determination of digoxin in commercial tablets and in injections proved to be feasible.     

Diffusion behavior of pharmaceutical O/W microemulsions studied by dynamic light scattering

Dynamic light scattering experiments have been performed at various concentrations, of pharmaceutical oil-in-water microemulsions consisting of Eutanol G as oil, a blend of a high (Tagat O2) and a low (Poloxamer 331) hydrophilic–lipophilic balance surfactant, and a hydrophilic phase (propylene glycol/water). We probe the dynamics of these microemulsions by dynamic light scattering. In the measured concentration range, two modes of relaxation were observed. The faster decaying mode is ascribed classically to the collective diffusion D _c (total droplet number density fluctuation). We show that the slow mode is also diffusive and suggest that its possible origin is the relaxation of polydispersity fluctuations. The diffusion coefficient associated with this mode is then the self-diffusion D _s of the droplets. It was found that D _c and D _s had opposite volume fractions of oil plus surfactants (ϕ) dependence and a common limiting value D ₀ for ϕ=0. Average hydrodynamic radius (R _h=10.5 nm) of droplets was calculated from D ₀. R _h is supposed to compose the inner core, a surfactant film including possible solvent molecules, which migrate with the droplet. The concentration dependence of diffusion coefficients reflects the effect of hard sphere and the supplementary repulsive interactions which arises due to loss of entropy, when absorbed chains of surfactant intermingle on the close approach of the two droplets. This mechanism could also explain the observed stability of our systems. The estimated extent of polydispersity is 0.22 from the amplitude of slower decaying mode. The polydispersity in microemulsion systems is dynamic in origin. Results indicate that the time scale for local polydispersity fluctuations is at least three orders of magnitude longer than the estimated time between droplet collisions.     

Small molecules as inhibitors of cyclin-dependent kinases

Cell division (mitosis) is one of the basic requirements for multicellular oranisms. The capability of a cell to replicate enables a complex assembly to be created. Faulty regulation of the control mechanism in the cell cycle leads to an excessive cell proliferation and is the cause of cancer. The key position of the cyclin-dependent kinases (CDKs) and their direct partners, as well as the fact that the majority of malign illnesses show defects in at least one of these key players of the cell cycle, is of great interest for the development of low-molecular-weight CDK inhibitors. In this Review an overview of the different structural classes of ATP-competitive inhibitors of CDKs are given, whose devlopment was aimed at battling cancer. The Review shows how far the development of selective CDK inhibitors has progressed and to what extent the expectations for such drugs have so far been fulfilled.     

Effect of drug-loading methods on drug load, encapsulation efficiency and release properties of alginate/poly-L-arginine/chitosan ternary complex microcapsules

The drug-loaded alginate/poly-L-arginine/chitosan ternary complex microcapsules were prepared by mixing method, absorption method and the combined method of mixing and absorption, respectively. The effect of drug-loading methods on drug load, the encapsulation efficiency and the release properties of the complex microcapsules were investigated. The results showed that the absorption process is a dominating factor to greatly increase the drug load of Hb into microcapsules. Upon loading Hb into microcapsules by combined method of mixing and absorption, the drug load (19.9%) is up to the maximum value, and the encapsulation efficiency is 93.8%. Moreover, the drug release is a zero-order kinetics process for the ternary complex microcapsules made by mixing. For the complex microcapsules made by absorption, the drug release is a first-order kinetics. However, for the complex microcapsules made by combining the mixing and the absorption, the drug release obeys a first-order kinetics during the first eighteen hours, changing afterwards to a zero-order kinetics process. Effect of drug-loading methods on drug load and encapsulation efficiency of alginate/poly-L-arginine/chitosan ternary complex microcapsules.     

Polymorphism and stability of norfloxacin, (1-ethyl-6-fluoro-1,4-dihydro-4-oxo-7-(1-piperazinil)-3-quinolinocarboxylic acid

Norfloxacin was studied by thermal methods (TG and DSC), X-ray powder diffraction, and by FT-IR, UV-VIS and NMR spectroscopy. The drug substance can be prepared in two different crystalline forms and in amorphous state, depending on the experimental conditions of preparation. DSC examinations were carried out at various heating rates and by cycling the samples in the temperature range 50°–250°C. The unstable crystalline form undergoes two irreversible solid-solid phase transitions at 176.5° and 197.6°C. The polymorph melts in the temperature range 218.5°–220.0°C.

---

Zusammenfassung Norfloxacin wurde mittels thermischer Methoden (TG und DSC), weiterhin mittels der Debye-Scherrer-Methode und FTIR-, UV-VIS-und NMR-Spektroskopie untersucht. Je nach den experimentellen Bedingungen bei der Herstellung kann die Wirkstoffsubstanz in zwei verschiedenen kristallinen und in einer amorphen Form hergestellt werden. Die DSC-Untersuchungen wurden bei zahlreichen Aufheizgeschwindigkeiten und durch abwechselnden Temperaturwechsel zwischen Raum- und Schmelztemperatur durchgeführt. Die unstabile kristalline Form unterliegt zwei irreversiblen Feststoff-Feststoff-Umwandlungen bei 176.5° und bei 195.6°C. Das polymorphe Material schmilzt im Temperaturbereich 218.5°–220.0°C.

     

生物催化在绿色化学和新药开发中的应用

近年来生物技术领域有了突破性进展，如: 公共基因数据库(GenBank)和蛋白质数据库(PDB)中序列的指数增长，高效基因克隆和表达平台的建立，可有效改进生物催化剂专一性、选择性和稳定性的酶定向进化技术的应用。这些进展使生物催化在化学合成中日趋重要[1]。本文综述了生物催化在如下领域的成功应用：在药物生产中用于开发经济的化学酶法合成工艺，在绿色化学领域中最大程度的减少废物的产生和危险试剂的应用，在天然化学领域中对天然产物进行修饰以发现具有更好生物活性的新药物。     

(R)-2-羟基-4-苯基丁酸乙酯的合成

综述了血管紧张素转化酶抑制剂类治疗高血压和充血性心力衰竭药物的关键中间体（R）－2－羟基－4－苯基丁酸乙酯的合成方法。参考文献25篇。     

Preparation, characterization, and application of multistimuli-responsive microspheres with fluorescence-labeled magnetic cores and thermoresponsive shells

Novel functional microspheres with multistimuli-responsive properties have been prepared and characterized. The as-prepared microspheres respond to an external magnetic field, environmental temperature, and ultraviolet radiation. The in vitro drug-loading efficiency and drug-release behavior of these microspheres demonstrated that they could be used as drug carriers for drug controlled release. The results of in vivo distribution investigations of these microspheres showed that they exhibit a high magnetic-targeting effect, which holds promise for applications in various fields such as magnetic drug targeting and tissue labeling, among others.