高增益型气体电子倍增微网结构探测器的性能研究

随着微结构气体探测器的不断发展, 不同的探测需求相继提出.为了实现气体探测器在高增益和低打火率的条件下长时间稳定工作, 结合气体电子倍增器(GEM)与微网结构气体探测器(MicroMegas)的探测优势, 成功研制出一种基于GEM作为预放大的MicroMegas探测器, 详细介绍了探测器结构和工作原理, 并利用⁵⁵Fe放射源对探测器增益、打火率、能量分辨和工作稳定性等性能进行了实验测量. 分析结果显示GEM-MicroMegas探测器可以连续工作30 h 以上, 探测器增益可以超过10⁶, 相对于无GEM膜的MicroMegas探测器, 相同增益下打火率可以降低近100倍. 关键词： 微网结构气体探测器 能量分辨率 增益 打火率     

自散焦非局域非线性材料中的光学涡旋孤子

通过数值模拟的方法对非局域非线性自散焦材料中的光学 涡旋孤子的传输特性以及相互作用特性进行了研究. 研究表明, 拓扑荷|m|=1的非局域涡旋孤子是稳定的, 而拓扑荷|m|>1的非局域涡旋孤子均具有拓扑不稳定性. 在微扰存在的情况下以及在近距离相互作用的过程中, |m|>1的涡旋孤子会分裂成一系列的|m|=1的涡旋孤子. 非局域涡旋孤子与局域涡旋孤子具有相同的长距离相互作用模式, 即点涡旋相互作用模式. 但两者的短距离相互作用存在一些差别, 在相同的距离下, 两涡旋间的相互绕转的周期随着材料的非局域响应长度增大而增大. 关键词： 非局域非线性薛定谔方程 自散焦 涡旋孤子     

一类厄尔尼诺海-气时滞振子的渐近解

研究了一类厄尔尼诺-南方涛动机制. 利用奇异摄动理论和方法求出了厄尔尼诺-南方涛动模型的外部解及初始层校正项. 从而得到问题解的渐近展开式, 并讨论了解的渐近性态. 关键词： 非线性 渐近解 厄尔尼诺-南方涛动模型     

Absorption and quantitative characteristics of C-H bond and O-H bond of NIR

The previous study mainly focused on the interpretation of the relationship between absorption characteristics and quantitative contribution in each near-infrared (NIR) frequency range. Furthermore, the absorption characteristics of NIR mainly cover overtones and combinations of molecular vibrations such as CH, OH, SH, and NH bonds. And it has been know that NIR wavelengths of C-H bond and O-H bond are assigned to different radio frequencies. This paper was intended to investigate the absorption characteristics of bond C-H and O-H bonds in NIR spectral range. Water and acetone which correspond to O-H and C-H bonds have been selected as typical solvents, as well as solutes. Calibration models were established using partial least square regression (PLS) and multiple linear regression (MLR). The parameter of the model were optimized by different spectral pretreatment methods. The result showed that the model set by Savitzky-Golay smooth (SG) in the spectral region of 810–1100 nm could successfully make accurate predictions. Short wave-NIR region has been discovered as optimum characteristic absorption of C-H and O-H bonds.     

基于STM32的乐联网的电能监测系统的设计

电能监测系统采用意法(ST)半导体公司STM32F103ZDT6的ARM芯片为核心,以ATT7022C电表芯片对电能参数进行取样,实现电网电压和电流、功率的因数、有功、无功和视在功率等诸多参数的检测,通过W5200A硬件TCP/IP通信芯片进行数据传输,借助乐为物联公司物联网平台,通过网页、博客等方式进行数据发布和管理,参数测量与传输误差在许可范围内,能够投入实际使用;该系统为能耗监测与管理提供了底层硬件平台,提供了数据可靠传输方式,提供了方便、直观的上层管理平台,综合了电能计量与测控、嵌入式系统、物联网、WebServer等多项技术,具有一定的创新性。     

利用纳米力学方法对皮肤进行超声组织定征的研究

纳米力学方法适用于具有离散特性的材料.利用纳米力学方法,得出声波在多层皮肤组织中的波动方程.分别改变黑素瘤皮肤的泊松比、黑素瘤侵袭厚度(Breslow深度)、节间距离,计算多层皮肤结构模型对垂直入射纵声波的反射系数.同时计算了声速和声衰减系数随组织参数的变化.计算结果表明,可综合利用一定频率段内反射系数最小点数、声速和衰减系数的变化来表征正常皮肤和病变皮肤.     

Hilbert genus fields of biquadratic fields

The Hilbert genus field of the real biquadratic field K=Q(δ~(1/2),d~(1/2)is described by Yue(2010)and Bae and Yue(2011)explicitly in the case=2 or p with p=1 mod 4 a prime and d a squarefree positive integer.In this article,we describe explicitly the Hilbert genus field of the imaginary biquadratic field K=Q(δ~(1/2),d~(1/2)),whereδ=-1,-2 or-p with p=3 mod 4 a prime and d any squarefree integer.This completes the explicit construction of the Hilbert genus field of any biquadratic field which contains an imaginary quadratic subfield of odd class number.     

HIGHER RADIAL DERIVATIVE OF BLOCH TYPE FUNCTIONS

In this paper, The integral characterizations of α-Bloch (little α-Bloch) are given in terms of higher radial derivative, and their characterizations of Carleson type measure are obtained.     

一类亚半正定矩阵的左右逆特征值问题

1．引言在工程技术中常常遇到这样一类逆特征值问题：要求在一个矩阵集合S中，找具有给定的部分右特征对（特征值及相应的特征向量）和给定的部分左特征对（特征值及相应的特征向量）的矩阵．文［2］，［3］讨论了S为。x。实矩阵集合的情形．文［4］－［7］对S为nxn实对称矩阵．对称正定矩阵，对称半正定矩阵集合的情形进行了讨论．文【川讨论了S为亚正定阵集合的情形．并提到了对于亚半正定矩阵的情形目下无人涉及，有待进一步研究．本文将对S为nxn亚半正定矩阵集合的情形进行讨论．给出了亚半正定矩阵的左右逆特征值问题有解的充要条件…     

A design study on the CSNS LEBT pre-chopper

The China Spallation Neutron Source (CSNS) front end incorporates a pre-chopper in the Low Energy Beam Transport line (LEBT) that will remove a 530 ns section of beam at approximately 1 MHz rate, which is the RF frequency of the ring at injection. It’s one of the most critical devices for properly controlling the injecting beam loss. Physical designing of the pre-chopper is carried out, and the RFQ itself is used as the beam dump of the chopper system. In order to examine the reliability of the pre-chopper design, the beam study of a similar chopper system is successfully performed. The results of physical design and experiments are presented.