LDS751染料的受激喇曼散射

报道了用532nm激光抽运LDS751染料产生720—780nm可调谐染料激光输出的同时,观察到喇曼频移为102和45cm-1的反斯托克斯线,前者谱线较强,后者较弱.与这两条强线对应的斯托克斯线未能观察到.另外,还观察到喇曼频移为34cm-1的一级和二级斯托克斯线与反斯托克斯线 关键词： LDS751染料 受激喇曼散射 喇曼位移 斯托克斯线 反斯托克斯线     

GS-221高速摄影测量仪测角信息的采集与处理

在GS-221高速摄影测量仪中,测角信息采集与处理速度的快慢是重要性能指标之一。本文讨论了如何在尽可能短的时间内对测角信息进行采集和处理的软件实现方法。     

吹气孔直径对RH精炼过程钢液流动和混合特性的影响

针对90t RH精炼装置,以水力学模拟研究了吹气孔直径对真空循环精炼过程中钢液流动和混合特性的影响.模型和原型的相似比为15.模型吹气孔直径分别为0.8 mm和1.2 mm.结果表明,1.2 mm孔径下环流量和主要工艺参数间的关系为Ql Q80.26Du0.69Dd0.80;在给定的吹气量和插入管内径下,增大吹气孔直径并不显著改变精炼过程中钢液流动特征,环流量随吹气孔直径的增大而略有增大,其关系式为Ql=2.40Q 0.23gD0.72u D0.88d d0.13in;相应地,混合时间稍有缩短;0.8和1.2 mm孔径下,τm与搅拌能密度的关系分别为τm ε5和τm ε0.49.     

长脉冲相对论速调管中束流脉冲缩短的研究

介绍L波段长脉冲相对论速调管放大器研究中，长脉冲强流相对论电子束(IREB)经过输入腔和中间腔间隙后的脉冲缩短问题.分析了造成束流脉冲缩短的主要机理之一是高频系统的角向非均匀模式与电子束相互作用而使得束流扩散形成的，并经过实验参数的调节，减轻了长脉冲IREB的脉冲缩短问题，得到了较强的基波调制电流.从长脉冲加速器引出500 kV，3.5 kA，1.3 μs的电子束，经过输入腔和两个群聚腔的调制后，得到了2.0 kA的基波调制电流，束流脉冲宽度由0.3 μs增加到1 μs，束流脉冲缩短问题得到明显减轻. 关键词： 相对论速调管放大器 脉冲缩短 高功率微波 长脉冲强流相对论电子束     

一种新型有机电致微腔结构的双模发射

采用结构Glass／DBR／ITO／NPB／NPB：Alq／Alq／Al制作了有机微腔电致发光器件。将空穴传输材料与发光材料以一定比例混合作为发光层，为了便于对比，在不改变有机层的膜厚的情况下同时制作了传统的异质结微腔器件，发现两种器件的发光光谱有很大不同，器件的复合效率与传统的异质结器件相比也得到了很大提高，这是因为将两种有机材料混合能消除界面势垒，提高器件的复合效率，从而提高了器件的发光性能，实现了微腔双模发射，且两个模式的半峰全宽分别为8nm和12nm。通过进一步优化器件结构可以实现微腔白光发射。     

随机参数Duffing系统中的随机混沌及其延迟反馈控制

研究了谐和激励下含有界随机参数Duffing系统(简称随机Duffing系统)中的随机混沌及其延迟反馈控制问题.借助Gegenbauer多项式逼近理论，将随机Duffing系统转化为与其等效的确定性非线性系统.这样，随机Duffing系统在谐和激励下的混沌响应及其控制问题就可借等效的确定性非线性系统来研究.分析阐明了随机混沌的主要特点，并采用Wolf算法计算等效确定性非线性系统的最大Lyapunov指数，以判别随机Duffing系统的动力学行为.数值计算表明，恰当选取不同的反馈强度和延迟时间，可分别达到抑制或诱发系统混沌的目的，说明延迟反馈技术对随机混沌控制也是十分有效的. 关键词： 随机Duffing系统 延迟反馈控制 随机混沌 Gegenbauer多项式     

Multiparametric Evaluation of Dysphonic Severity

SUMMARY: In recent years, the multiparametric approach for evaluating perceptual rating of voice quality has been advocated. This study evaluates the accuracy of predicting perceived overall severity of voice quality with a minimal set of aerodynamic, voice range profile (phonetogram), and acoustic perturbation measures. One hundred and twelve dysphonic persons (93 women and 19 men) with laryngeal pathologies and 41 normal controls (35 women and six men) with normal voices participated in this study. Perceptual severity judgement was carried out by four listeners rating the G (overall grade) parameter of the GRBAS scale. The minimal set of instrumental measures was selected based on the ability of the measure to discriminate between dysphonic and normal voices, and to attain at least a moderate correlation with perceived overall severity. Results indicated that perceived overall severity was best described by maximum phonation time of sustained /a/, peak intraoral pressure of the consonant-vowel /pi/ strings production, voice range profile area, and acoustic jitter. Direct-entry discriminant function analysis revealed that these four voice measures in combination correctly predicted 67.3% of perceived overall severity levels.     

Phenylene vinylene‐based electroluminescent polymers with electron transport block in the main chain

We report a new route for the design of soluble phenylene vinylene (PV) based electroluminescent polymers bearing electron‐deficient oxadizole (OXD) and triazole (TZ) moieties in the main chains with the aryloxy linkage. Both series of the PV‐based polymers were prepared by Wittig reaction. By properly adjusting the OXD and/or TZ content through copolymerization, we can achieve an enhanced balance of hole‐ and electron injections, such that the device efficiency is significantly improved. Light‐emitting diodes fabricated from P1, P2, P3, P4, P5, P6, and P7 with the configuration of Indium–Tin Oxide (ITO)/Poly (styrene sulfonic acid) doped poly (ethylenedioxythiophene) (PEDOT)/polymer/Ca/Al, emit bright green light with the maximum peak around 500 nm. For the device using the optimal polymer (P4) as emitting layer, a maximum brightness of 1300 cd/m² at 20 V and a maximum luminance efficiency of 0.325 cd/A can be obtained. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3469–3478, 2006