Theoretical study of structure and stability of fullerene derivative: C50O

A total of eight possible isomers of C₅₀O, an oxide of fullerene C₅₀ (D_5h), have been investigated by B3LYP/3‐21G calculations. The isomer, which has an annulene‐like structure with oxygen bridging across a [5,6] type C? C bond at the site between the pole and the equatorial belt, is found being the ground state of C₅₀O. Four isomers are relatively more stable and the energy differences between them are not large. This result indicates that more than one C₅₀O isomer will coexist once C₅₀O is synthesized. The relative stabilities of the C₅₀O isomers may be determined mainly by the strain release and by the formation of the cyclic phenylene substructure at the equatorial belt of the cage. The calculated nucleus independent chemical shifts (NICS) of the C₅₀O isomers will be useful because from them one can expect outstanding NMR properties that can lead to their identification and characterization. © 2004 Wiley Periodicals, Inc. Int J Quantum Chem, 2005     

猴头菇微量元素含量的分析

用电感耦合等离子体发射光谱仪（ICP-AES）测定了湛江市栽培的猴头茹微量元素的含量，发现其磷、硫、钙、镁、锌、铁、铜等元素的含量都比较丰富，并讨论了这些有益元素与人体健康的关系。     

Flame atomic absorption spectrometric determination of copper, zinc, calcium, magnesium and iron in fresh eggs using microvolume injection

The flame atomic absorption spectrometric determination of copper, zinc, calcium, magnesium and iron in fresh eggs using a microvolume injection technique is described. The capillary tube and glass impact bead were removed from the nebulizer and a polypropylene tube was installed in the inlet of the capillary tube of the nebulizer as the interface for microvolume injection. The injection volume was 10 mul and calibration was carried out using aqueous standards. Beer's law was obeyed in the concentration ranges of 0.1-1.5, 0.1-3.0, 0.2-4.0, 0.5-4.0 and 1.0-6.0 mg 1(-1) for Cu, Zn, Ca, Mg and Fe, respectively, and the detection limits were 0.016, 0.016, 0.035, 0.010 and 0.10 mg 1(-1), respectively. The reliability of the measurements was confirmed by analyzing a certified reference material, GBW 08551 Pork Liver. The precision was 2.6, 2.9, 3.0, 1.3 and 2.5% for Cu, Zn, Ca, Mg and Fe, respectively. The recovery with the standard additions method was good, ranging from 96.2 to 100.0%.     

Immobilized Glucose Oxidase in the Potentiometric Detection of Glucose

Previous work has shown that glucose oxidase can be immobilized on platinum to give an electrode that responds potentiometrically to glucose over the clinically useful range of about 10-250 mg glucose/100 mL. The present studies were carried out with electrochemically pretreated platinum and with gold or porous graphite substituted for the platinum support. The presence of the enzyme gave a significantly enhanced potentiometric response over that obtained with the bare support for both the pretreated platinum and the porous graphite, but not with gold. However, with platinum the potentiometric response became more negative with increasing glucose concentration. With porous graphite, the potential changed in the positive direction as the glucose concentration was increased. Hysteresis was demonstrated for the platinum-enzyme electrode. Mass transfer measurements with a rotating ring-disc electrode (RRDE) showed measurable diffusional resistances to the transport of a model electroactive compound (potassium ferrocyanide) through a matrix of immobilized enzyme attached to the disc of the RRDE. These results are part of a larger study to define the source of the potentiometric response by examining the roles of the support and the mass transfer resistances through the immobilized enzyme matrix.     

Three-phase extraction study of cyanex 923-n-heptane/H(2)SO(4) system

Phase behavior of the extraction system, Cyanex 923–heptane/H₂SO₄–H₂O has been studied. The third phase appeared at different aqueous H₂SO₄ concentration with varying initial Cyanex 923 concentration and temperature affects its appearance. Almost all of H₂SO₄ and H₂O are extracted into the middle phase. The H₂SO₄ concentration in the third phase increases with the increasing aqueous acid concentration (C_H2SO4,b) while the water content first increases and then reaches a constant value at C_H2SO4,b=11.3 mol l⁻¹. In the region of C_H2SO4,b higher than 5.2 mol l⁻¹, the composition of the middle phase is only related to the equilibrium concentration of H₂SO₄ in the bottom phase. H₂SO₄ and H₂O are transferred into the middle phase mainly by their coordination with Cyanex 923 when C_H2SO4,b is less than 11.3 mol l⁻¹. When C_H2SO4,b is higher than 11.3 mol l⁻¹, excess H₂SO₄ is solubilized into the polar layer of the aggregates. In the region considered, the extracted complex changes from C923 · H₂SO₄ to C923 · H₂SO₄ · H₂O and then to C923 · (H₂SO₄)₂ · H₂O.     

甲醛在Ni(110)面上分解的分子轨道研究

本文应用CNDO方法研究了H_2CO在Ni(110)面上的分解反应。证明了金属镍使H_2CO对称禁阻的热分解反应变成了对称允许反应; 讨论了H_2CO在Ni(110)面上的各种吸附模型; 论证了卧式多中心吸附作为H_2CO分解的中间步骤。     

Preparation of Co3O4 Nanofibers via an Electrospinning Technique

Thin PVA/cobalt acetate composite fibers were prepared by using sol-gel processing and electrospinning technique.After calcination of the above precursor fibers,Co3O4 nanofibers with a diameter of 50-150 nm could be successfully obtained.The fibers were characterized by SEM,FT-IR,WAXD,respectively.     

Over 18% binary organic solar cells enabled by isomerization of non-fullerene acceptors with alkylthiophene side chains

Side-chain engineering has been demonstrated as an effective method for fine-tuning the optical, electrical, and morphological properties of organic semiconductors toward efficient organic solar cells (OSCs). In this work, three isomeric non-fullerene small molecule acceptors (SMAs), named BTP-4F-T2C8, BTP-4F-T2EH and BTP-4F-T3EH, with linear and branched alkyl chains substituted on the α or β positions of thiophene as the side chains, were synthesized and systematically investigated. The results demonstrate that the size and substitution position of alkyl side chains can greatly affect the electronic properties, molecular packing as well as crystallinity of the SMAs. After blending with donor polymer D18-Cl, the prominent device performance of 18.25% was achieved by the BTP-4F-T3EH-based solar cells, which is higher than those of the BTP-4F-T2EH-based (17.41%) and BTP-4F-T2C8-based (15.92%) ones. The enhanced performance of the BTP-4F-T3EH-based devices is attributed to its stronger crystallinity, higher electron mobility, suppressed biomolecular recombination, and the appropriate intermolecular interaction with the donor polymer. This work reveals that the side chain isomerization strategy can be a practical way in tuning the molecular packing and blend morphology for improving the performance of organic solar cells.

     

铜（Ⅱ）锌（Ⅱ）－氟哌酸体系电化学行为及示波极谱法研究

铜（Ⅱ）和锌（Ⅱ）分别在０．１ｍｏｌ／ＬＫＨ＿２ＰＯ＿４－Ｎａ＿２ＨＰＯ＿４缓冲溶液（ｐＨ６．５）和０．２５ｍｏｌ／ＬＮＨ＿４Ｃｌ溶液中，与氟哌酸形成良好的络合吸附波，峰电位分别为－０．２６Ｖ和－１．２８Ｖ（ｖｓ；ＳＣＥ）；络合比分别为１：３和１：２；峰电流与铜（Ⅱ）和锌（Ⅱ）的浓度均在４．０×１０￣（－７）～５．０×１０￣（－６）ｍｏｌ／Ｌ范围内呈线性关系，检测限分别为７．０×１０￣（－８）和５．０×１０￣（－８）ｍｏｌ／Ｌ。用线性扫描和循环伏安法等手段研究体系的行为，表明均具吸附性，而铜（Ⅱ）－氟哌酸体系属络合物中铜（Ⅱ）的两电子还原的可逆过程。     

多孔整体固定相的制备与色谱性能

结合连续加料降低聚合体系的放热量,及强化体系的换热能力等措施,实现了无搅拌模式聚合体系中温度分布的均一化。通过单次聚合过程构造了体积为38mL的大体积整体固定相。SEM及孔隙率分布测试证明了整体固定相具有均匀的孔结构,动态容量测定及分离蛋白质的实验,表明所制备的径向流动模式整体柱的容量及分辨率不依赖于流速,同时在高流速下具有低背压的特征,可用于生物大分子的分离制备。