Low-threshold, high-efficiency, high-repetition-rate optical parametric generator based on periodically poled LiNbO3

We report a high-repetition-rate optical parametric generator (OPG) with a periodically poled lithium niobate (PPLN) crystal pumped by an acousto-optically Q-switched CW-diode-end-pumped Nd:YVO_4 laser. For the maximum 1064nm pump power of 970mW, the maximum conversion efficiency is 32.9% under the conditions of 250℃, 1064nm pulse repetition rate of 22.6kHz and pulse width of 12ns, and the PPLN OPG threshold in the collinear case is less than 23.7μJ. The output power increases with the increase of the crystal temperature. The 1485－1553nm signal wave and 3383－3754nm idler wave are obtained by changing the temperature and the angle of the PPLN crystal.     

Photocatalytic Synthesis of Oxygenates from Gaseous CO2 and CH4 over Semiconductor

Photoinduced synthesis of CO2 and CH4 was investigated using a batch reaction system on several photoactive materials supported on silicon dioxide. Single semiconductor showed higher selectivity to C1 compounds. The production of C2-C3 oxygenates took place preferentially on composite semiconductor photocatalysts. In particular, it was found that acetone was the primary product over Cu/CdS-TiO2/SiO2.     

Power scaling of printed-circuit-board preionized TEA CO2 laser up to 3.6 kW

A high average power, high-repetition-rate TEA CO₂ laser employing printed-circuit-board preionizer is described. The power scaling of this preionization configuration has been demonstrated. The average output power reaches 3.6 kW at pulse repetition rate of 180 pps. Furthermore, the scaling-up ability of the rotating spark gap as high-voltage switch for high-average-power gas laser has been validated.     

Experimental 511 W Composite Nd：YAG Ceramic Laser

We demonstrate a 511 W laser diode pumped composite Nd：YAG ceramic laser. The optical pumping system is consisted of five laser diode stacked arrays arranged in a pentagonal shape around the ceramic rod whose size is φ6.35×144mm. When the pumping power is 1600 W, the cw laser output up to 511 W at 1064nm can be obtained with a linear piano-piano cavity, and the optical-to-optical efficiency is 31.9%. To our knowledge, this is the highest value of laser output by using a newly invented composite Nd：YAG ceramic rod as the gain medium.     

Na离子和Cl离子引起He原子直接多重电离过程的研究

利用2～8 MeV的Naq+、Clq+(q=2,3,4,5)轰击氦原子,对碰撞的直接多重电离过程进行研究.实验采用反冲离子-散射离子飞行时间符合技术,通过反冲离子飞行时间谱区分不同价态反冲离子;利用静电偏转和位置灵敏探测技术区分不同电荷态散射离子;结合CAMAC-PC多参数获取系统得到一定价态散射离子所对应的反冲离子电荷态分布谱;经分析该谱得到直接多重电离截面与直接单电离截面之比R21.讨论了R21随入射离子速度和电荷态的变化关系.     

大米中硒的FI-HG-AAS测定方法研究

研究了原子化器温度、载气流速、KBH4 浓度等条件对流动注射 氢化物发生 原子吸收光谱法 (FI-HG -AAS)测定硒时的影响。建立了FI-HG -AAS测定大米中硒的分析方法。在优化的工作条件下 ,测定硒的最低检测浓度为 0 3 3 μg·L- 1,线性范围为 0～ 5 0 μg·L- 1,相对标准偏差小于 4% ,加标回收率为 94%～ 1 0 2 %。本法克服了传统的间断氢化物发生 原子吸收光谱法分析速度慢、样品耗量大、操作繁琐且因手工进样在进样速度和进样体积上容易带来误差等缺点。方法操作简便、快速 ,灵敏度及自动化程度高 ,已广泛应用于大米及富硒大米中微量硒的测定     

流动注射原子吸收光谱法测定富硒天麻、葡萄及大米中的硒

建立了流动注射氢化物发生-原子吸收光谱法测定富硒天麻、葡萄及大米中硒的方法。测定硒的线性范围为0．33μg/L-50μg/L，相对标准偏差小于3％，加标回收率为93％-106％。方法已广泛应用于实际样品中微量硒的测定。     

Temperature anomaly of the Cd hyperfine field in a trivacancy complex in Ni

The temperature dependence of the Cd hyperfine field in a trivacancy complex in Ni between 25 and300 K is reported. It was found that, unlike the Cd substitutional field in Ni which follows the temperature dependence of the magnetization, the Cd hyperfine field in a trivacancy complex is essentially temperature independent. This temperature anomaly is compared with other temperature anomaly of impurity hyperfine fields in ferromagnetic hosts.     

多元整系数多项式因式分解的一种理论和算法

本文将ｔ（ｔ是大于２的整数）元整系数多项式看成为系数为ｔ－２元整系数多项式的二元多项式，建立了多元整系数多项式因式分解的一种新理论，进而得到了分解多元整系数多项式的一个有力的算法。     

期刊发稿动力学系统

发稿库库存量是影响稿件发表时间的关键因素之一,文章分析了影响发稿库库存量的两个指标:一是二审库稿件进入发稿库的入库率,二是发稿库中排队时间为x的稿件的刊登率.最后给出了研究问题的数学描述.