亚细胞器诱导的2,4,6-三硝基甲苯阴离子自由基的ESR研究

本文在无氧条件下利用ESR分别观察了肝脏和晶状体的微粒体及线粒体酶在NADPH存在下还原三硝基甲苯(TNT)的过程,检测到参数为g=2.0048±0.0005,A_对位~N=1.215mT,A~N=0.800±0.010mT,A~H=0.122±0.0206mT的自由基信号,并通过电子计算机对ESR谱的模拟证明该自由基信号为TNT硝基阴离子自由基,根据其超精细分裂常数认为,其不配对电子的电子云密度主要分布在对位硝基上。     

具有一对零态射的Morita Context环(II)

设$(A,B,V,W,\psi,\phi)$是一个Morita Context,具有一对零态射$\psi=0$, $\phi=0$, $C =\left ( \begin{array} {cc}A & V \\W & B \end{array}\right)$是对应的Morita Context环.本文给出了$C$与$A,B,V,W$之间关于环的$\pi$-正则性、semiclean性、Mophic性和环的Exchgange性、Potent性、GM性的关系.     

PINNING EFFECT OF LEAD LANTHANUM TITANATE THIN FILMS DEPOSITED ON DIFFERENT SUBSTRATES

Pinning effect of lead lanthanum titanate (PLT) ferroelectric thin films with excess PbO of 20 mol% has been studied for deposition on diffe rent substrates. Silicon, sapphire and quartz were used as substrates on which P t/Ti or LaNiO₃ thin films were deposited as bottom electrodes. Electron probe analysis results showed that there was still a certain amount of excess Pb in PLT films after annealing at 550 ℃ for 1 h, and the amount of it was dependent on the substrate used. The distribution of excess Pb in the films was investig ated by Auger electron spectroscopy depth profile. It was shown that the substrates and the bottom electrodes had significant effects on the content and distrib ution of excess Pb in PLT films. The excess Pb and its accumulation at the inter face between the film and bottom electrode may act as pinning centers and have a pinning effect on domains, which can be observed by abnormal P-E hysteresis loops and abnormal C-V curves. The excess Pb content in the films and the accumulation of Pb at the interface were high in PLT films deposited on Pt/Ti/S i, and considerable pinning effect was observed. As LaNiO₃ would absorb most part of the excess Pb in PLT films, the content of excess Pb in the films deposited on LaNiO₃/Si was very low and the pinning effect was hardly observed.     

管肋式辐射器排热特性的数值分析与优化设计

为得到按单面辐射方式布置的管肋式空间辐射器的排热特性，建立了相应的数学模型．采用数值模拟方法分析了管内流体温度、肋片几何尺寸和等效热沉温度对辐射器排热特性的影响，得到了不同参数值下辐射器单位面积排热量以及特定参数范围内的辐射器肋片最佳宽度和肋片效率．数值模拟结果对辐射器的工程结构设计以及空间站热管理方案的优化分析具有一定的参考价值．     

Measurement of small-signal and large-signal responses of packaged laser modules at high temperature

In this paper, the pulsed injection method is extended to measure the chip temperature of various packaged laser modules, such as the DFB laser modules, the FP laser modules, and the EML laser modules. An optimal injection condition is obtained by investigating the dependence of the lasing wavelength on the width and period of the injection pulse in a relatively wide temperature range. The small-signal frequency responses and large-signal performances of packaged laser modules at different chip temperature are measured. The adiabatic small-signal modulation characteristics of packaged LD are first extracted. In the large-signal measurement, the effects of chip temperature, bias current and driving signal on the performances of the laser modules are discussed. It has been found that the large-signal performances of the EML modules depend on the different red-shift speeds of the DFB and EAM sections as chip temperature varying, and the optimal characteristics may be achieved at higher temperature.     

Local chemical distribution and electronic structure of Ge1−xTx DMS single crystals (T=Cr,Mn, Fe)

The spatial concentration distribution and local electronic structure of ferromagnetic Ge_1−xT_x (T=Cr, Mn, Fe) DMS single crystals have been investigated by using scanning photoelectron microscopy (SPEM), X-ray absorption spectroscopy (XAS), and photoemission spectroscopy (PES). It is found that doped T ions in Ge_1−xT_x crystals are chemically phase-separated, suggesting that the observed ferromagnetism arises from the phase-separated T-rich phases in Ge_1−xT_x.     

A Fully Vectorial Effective Index Method for Accurate Dispersion Calculation of Photonic Crystal Fibres

A fully vectorial effective index method is developed for accurate dispersion calculation of photonic crystal fibres （PCFs）. In order to improve the accuracy of the model, different values for the effective core radius are used when PCFs have different fibre parameters. The accuracy of our approach is demonstrated by comparing our results with other numerical and experimental results reported in literature. It is found that the accuracy of the fully vectorial effective index method is improved and our results agree well with accurate numerical results obtained by other methods as well as the previously reported experimental data.     

Preparation and Characterization of a Cobalt‐Containing Mono‐Phosphine Ligand and its Coordinated Molybdenum Complex

A cobalt‐containing monodentate phosphine [(μ₂‐PPh₂CH₂PPh₂‐κ²P)Co₂(CO)₄][μ₂‐η²‐PhC≡CP(i‐Pr)₂] 2f , was prepared from the reaction of (μ₂‐PPh₂CH₂PPh₂‐κ²P)Co₂(CO)₆ 1 with PhC≡CP(i‐Pr)₂. It was accompanied by an oxidized compound, [(μ₂‐PPh₂CH₂PPh₂‐κ²P)Co₂(CO)₄][μ₂‐η²‐PhC≡CP(=O)(i‐Pr₂)] 2fo during the chromatographic process. Further reaction of 2f with Mo(CO)₆ resulted in the formation of a 2f ‐ligated molybdenum complex 4 , [(μ₂‐PPh₂CH₂PPh₂‐κ²P)Co₂(CO)₄][μ₂‐η²‐PhC≡CP(i‐Pr₂)‐κP]‐Mo(CO)₅.     

对流扩散方程带罚函数项的有限体积格式及其分析

1引言 有限体积方法[l]一l’]作为守恒型的离散技术，被广泛应用于工程计算领域.文【2，3} 基于分片常数和分片常向量函数空间，对二维驻定对流扩散方程提出了一类非协调混合 有限体积(Covolume)格式，证明了格式具有。(hl/2)收敛精度.但该格式要求对偶剖分 比较规则，即采用重