Simulation analysis of one-stage C+L-band erbium-doped fiber ASE source with double-pass bi-directional pumping configuration

A new technique to generate a C+L-band flat amplified spontaneous emission (ASE) source in one-stage erbium-doped fiber (EDF) using bi-directional pumping configuration is analyzed. The simulation results show that the key point of obtaining flat C+L-band ASE spectrum in one-stage EDF is using a laser diode operated at 980 nm as backward pump source. ASE source with nearly 80-nm bandwidth can be obtained by means of selecting suitable fiber length and properly adjusting the ratio of forward to backward pump power.     

High efficiency broad bandwidth erbium-doped superfluorescent fiber source

A practical two-stage double-pass structure using high concentration erbium-doped fiber and 1480-nm pump laser diode is suggested for a high power and broad bandwidth erbium-doped superfluorcscent fiber source. A considerable increase in output power and bandwidth extension is achieved by adding an unpumped fiber and a broadband fiber mirror to make the most of wasted backward amplified spontaneous emission as both pump and input light source simultaneously. Superfluorcscent fiber source with nearly 80-nm bandwidth and 28.6-mW output power is obtained experimentally.     

Characterization of Amplified Spontaneous Emission from Er^3＋-Doped Tellurite Fibre

We present the characterization of amplified spontaneous emission (ASE) from newly fabricated Er^3 -doped tellurite fibres.When pumped at 98Ohm,a very broad erbium ASE in the range 1450-1650nm is observed.The changes of ASE with regard to fibre lengths and pumping power were measured.The output of 2mW from an Er^3 -doped tellurite fibre ASE source is obtained with the pump power of 540mW.     

Mid-IR Dual-Wavelength Difference Frequency Generation Using Fiber Lasers as Pump and Signal Light Sources

A continuous-wave mid-IR difference frequency laser source, which respectively uses an ytterbium-doped fiber laser as the pump source and a multiwavelength erbium-doped fiber laser cascaded with an erbium-doped fiber amplifier as the signal source, is demonstrated. Our experimental results show that two stable mid-IR radiation lines with a spacing of about 5.4nm may be simultaneously emitted by a suitable setting the pump and signal polarization orientations. The number of the mid-IR radiation lines is limited by the quasi-phase-matching acceptance bandwidth. By changing the PPMgLN temperature the two mid-IR radiation lines may be synchronously tuned in the mid-IR range between 3295 and 3356.3nm.     

Linear Cavity Erbium—Doped Fibre Laser with Tunable Wavelength Range of 112nm

We report on a linear cavity erbium-doped fibre laser with a large tuning range of 1509-1621nm.We obtain a 1dB flat tuning range of 1538-1613 nm and a 3dB tuning range of 1516-1621 nm.The threshold at 1580 nm is 6.1mW,the slope efficiency is 0.193 and the output power is 18.2mW,when 100mW pump power at 1480nm is provided.High signal-to-noise ratios of better than 60 dB are achieved within all the tuning ranges.     

Amplified spontaneous emission properties of a single mode Er~(3+)-doped tellurite fiber

Spectral characteristics of the amplified spontaneous emission (ASE) from a novel single mode Er~(3+) doped tellurite fiber with D-type cladding is reported in this letter. When pumped at 980 nm, an ASE source that has nearly a 100-nm flat FWHM bandwidth is obtained with a fiber length of 30-60 cm. Variation of ASE spectra with pump powers and fiber lengths are measured. Output power up to 2.0 mW is obtained with a launched pump power of 660 mW.     

Q-Switched Large-Mode-Area Yb-Doped Fibre Laser Using GaAs as Saturable Absorber

A passive Q-switched large-mode-area Yb-doped fibre laser is demonstrated using a GaAs wafer as the saturable absorber. A high Yb doping concentration double-clad fibre with a core diameter of 30μm and a numerical aperture of 0.07 is used to increase the laser gain volume, permitting greater energy storage and higher output power than conventional fibres. The maximum average output power is 7.2W at 1080nm wavelength, with the shortest pulse duration of 580ns and the highest peak power of 161W when the laser is pumped with a 25W diode laser operating at 976nm. The repetition rate increases with the pump power linearly and the highest repetition rate of 77kHz is obtained in the experiment.     

Gain Characteristics of Er^3＋-Doped Phosphate Glass Fibres

An erbium-doped phosphate glass fibre has been drawn by the rod-in-tube technique in our laboratory. The gain for the Er^3＋-doped phosphate glass fibre with different pump powers and with different input signal wavelengths is investigated. The 2.2-cm-long fibre, pumped by a single-mode 980-nm fibre-pigtailed laser diode, can provide a net gain per unit length greater than 1.SdB/cm. The pump threshold is about 50mW at the wavelength of 1534nm, and below 70roW at 1550nm. The gain linewidth of the Er^3＋-doped phosphate glass fibre is greater than 34 nm and can cover the C band in optical communication networks.     

Laser Characteristics of Cladding-Pumped Short Er^3＋/yb^3＋ Codoped Single Mode Phosphate Glass Fibre

We experimentally investigate the laser characteristics of a series of short pieces of newly-developed Er^3＋/ Yb^3＋ codoped single mode phosphate glass fibres via the cladding pump of a 976nm multimode laser diode. A stable continuous-wave single transverse mode laser with over 85 m W at 1553nm is generated from a 5.5-em-long active fibre. Single mode laser output power per unit length is up to 15 mW/cm. Moreover, the slope efficiency is 11.8% when the pump power is below 940mW and the 3dB linewidth is 0.06nm at the maximum pump power. The numerical simulation results show that the laser emission slope efficiency can exceed 20% by means of increasing the coupling efficiency of the pump to the fibre core further.     

High Efficiency Continuous-Wave Tm：Ho：GdVO4 Laser Pumped by a Diode

We report a high efficiency cw diode-pumped cryogenic Tin(Sat.%), Ho(0.5at.%):GdV04 laser. The pumping source is a fibre-coupled laser diode with fibre core diameter of 0.4 mm and numerical aperture of 0.3, supplying power 14.8 W at 793.6nm. For input pump power of 13.6 W at 794.2nm, the maximum output power of 4.2 W,optical-to-optical conversion efficiency of 31% and slope efficiency 38% have been attained at 2.0485 μm. To our knowledge, the operating performance is the best among the previously reported Tm:Ho:GdVO4 lasers. We also analyse the influence of pump wavelengths (from 792nm to 794.2nm) on the output power, the optical-to-optical conversion efficiency increases with the longer pump wavelength which is closer to the absorption peak of 797nm in Tm,Ho:GdV04.     

Highly Efficient Self-Starting Femtosecond Cr:Forsterite Laser

We report a highly efficient and high power self-starting femtosecond Cr：forsterite laser pumped by a 1064-nm Yb doped fibre laser. Five chirped mirrors are used to compensate for the intra-cavity group-delay dispersion, and the mode-locking is initiated by a semiconductor saturable absorber mirror （SESAM）. Under pump power of 7.9 W, stable femtosecond laser pulses with average power of 760mW are obtained, yielding a pump power slope efficiency of 12.3%. The measured pulse duration and spectral bandwidth （FWHM） are 46 fs and 45 nm; the repetition rate is 82 MHz.     

An Experimental Study of Ultrashort Pulsed Ytterbium-Doped Fibre Laser and Amplifier

We report the generation of ultrashort pulses in ytterbium-doped fibre oscillator emitting around 1.05μm at a repetition rate of 17.6 MHz. A diode laser with single silica fibre at 976nm pumps the ytterbium fibre laser, the all-fibre picosecond pulsed oscillator has excellent stability and compact size, and freedom from misalignment. After amplifying, pulse energy of 3.4 nJ and an average power of 60 m W are obtained. The compression is obtained with a grating pair out of the cavity. The compressor produces 307fs with the peak power 5.47kW. A practical fibre-based source with good performance is thus demonstrated.     

LD-pumped 6 W cw Tm^3＋-Doped Silica Double-Cladding Fibre Laser

We report a thulium-doped silica fibre laser that generates a maximum cw output power of 6 W in a 2 μm wavelength range when cladding-pumped by a laser diode （LD） operating at approximately 791 nm at room temperature. The slope efficiency with respect to the launched pump power is 50% and 38.4%, with and without an output coupler mirror, respectively. The corresponding thresholds are 2.8 W and 4.8 W, respectively. The beam qualities Mx^2 and My^2 are 1.26 and 1.32, respectively. The experimental results are also analysed.     

Fibre-Format Photonic Source Based on Efficient Frequency Doubling of Continuous-Wave Erbium-Fibre Laser Amplifier

We demonstrate a compact photonic device based on efficient and wavelength-tunable doubling of an all fibreformat source. Quasi-phase-matched second-harmonic generation in periodically poled lithium niobate is used to generate 90.6 m W at 775.9 nm with a single-pass conversion efficiency of 14.7%. A t uning bandwidth of 2.1 nm and a tuning temperature range of 150.6 ± 1.7℃ can be achieved. The Er-doped seed fibre source is amplified by a clad-pumped Er^3＋/Yb^3＋-codoped fibre laser with a high output power up to 2.18 W over a tunable wavelength range from 1535nm to 1570nm.     

Experimental study on kilowatt fiber laser in an all-fiber configuration

A high-power fiber laser in an all-fiber format is reported. The system consists of 36 pump ports, which use both counter and forward pump configuration. In the experiment, 1 008-W output power is obtained when 24 pump ports are used with a total pump power of 1477 W. The optical-to-optical conversion efficiency is 68% and the 3-dB bandwidth of laser output increases with output power. Presently, the output power is only limited by the pump source. It can be predicted that the laser power can be further scaled if more pump sources are utilized.     

A l15-W Ytterbium-Doped Fibre Laser

We report a highly efficient ytterbium-doped double-clad fibre laser, one-end pumped by a 975-nm diode stacksource and generating up to 115.6 W of cw output power at 1.1 μm. The maximum optical-to-optical conversionefficiency with respect to the launched pump power is 79% at 65-W output power, and the overall slope efficiencyis about 69%.     

An 88-nm broadband ASE source with bismuth-based erbium-doped fiber

A broadband amplified spontaneous emission (ASE) source of 88 nm is demonstrated using novel bismuth-based erbium-doped fiber (EDF) with the length of only 49.2 cm in a bi-direction pumping scheme. The maximum output power of 14.3 dBm is obtained under total pump power of 162 mW. The fiber loop mirror which     

Dissipative soliton operation in diode pumped ultrafast Yb:GdYSiO5 oscillator

We demonstrate the dissipative soliton mode locking in a diode pumped Yb：GdYSiO~（Yb：GYSO） laser operating in the positive dispersion regime. We obtain stable passively mode-locked pulses with strong positive chirp and with very steep spectral edges. The central wavelength is 1050 nm with bandwidth of about 4 nm, autocorrelation trace shown the typical pulse duration is about 3.5 ps. We obtain the maximum average power of 558 mW for a 3.3-W absorbed pump power, with 22% slope efficiency, and a 78-MHz pulse repetition frequency.     

Stable Dual-Wavelength Fibre Laser with Bragg Gratings Fabricated in a Polarization-Maintaining Erbium-Doped Fibre

A new polarization-independent duai-wavelength fibre laser by fabricating a uniform FBG and a chirped FBG in a polarization-maintaining erbium-doped fibre （PM-EDF） is proposed and demonstrated. The wavelength spacing is 0.18nm and the optical signal-to-noise ratio is greater than 50dB with pump power of 246mW. Chirped FBG is used to make the reflectivity wavelengths of two PM-FBGs match easier. Since both EDF and FBGs are polarization-maintaining without splices and the two wavelengths are polarization-independent, the maximum amplitude variation and wavelength shifts for both lasing wavelength with 3-min intervals over a period of six hours are less than 0.2 dB and 0.005 nm, respectively, which shows stable dual-wavelength output.     

High Power One- and Two-Order Cascaded Raman Lasers Based on Home-Made Phosphosilicate Fibre

One- and two-order cascaded Raman fibre lasers are demonstrated by using home-made P-doped Raman fibres.An output power of 2.8 W at 1245 nm with a slope efficiency of 33.4% and an output power of 2.0 W at 1495 nm with a slope efficiency of 23.5% are obtained with the pump source at 1069. 7nm.