共查询到20条相似文献,搜索用时 93 毫秒
1.
自由曲面光学透镜的图像变换面形测量系统与精度建模 总被引:1,自引:0,他引:1
为了解决自由曲面光学透镜光学表面面形的高精度测量问题 ,提出了一种可用于自由曲面光学透镜面形测量的图像变换光学曲面面形测量系统。从测量系统的测量原理出发 ,分析了测量过程中各种误差对测量精度的影响 ,推导出了自由曲面光学透镜的图像变换面形测量系统的测量误差公式 ,建立了自由曲面光学透镜的图像变换面形测量系统的测量精度数学模型 ,得到了该测量系统具有很高测量精度的结论 ,并且用实验给予验证。 相似文献
2.
3.
4.
5.
介绍了强流重离子加速器装置HIAF(High Intensity heavy-ion Accelerator Facility)项目增强器BRing(Booster Ring)快脉冲二极磁铁的性能指标、测量要求和测量方法,描述了快脉冲二极磁铁稳态磁场测量系统及动态磁场测量系统的构成。在稳态磁场测量中,为提高积分磁场测量精度和测量效率,长线圈测量系统采用了on fly技术;在动态磁场测量中,研制了用于磁场延迟及磁场畸变测量的矩阵线圈。通过样机磁铁的测量,完成了测量系统的性能指标验证和磁铁的稳态磁场测量。实测结果表明,样机磁铁的设计和制造均达到了预期指标,并依据测量数据完成了磁铁的二次削斜。 相似文献
6.
介绍了合肥光源同步光测量系统,包括条纹相机系统、快速光电测量束团长度系统、束团横向截面测量系统和光位置测量系统.利用条纹相机系统和快速光电测量柬团长度系统进行了束团长度测量和束团伸长效应的研究.利用束流截面测量系统进行了六极铁对横向不稳定性抑制效果和横向反馈系统反馈效果的测量研究.光位置测量系统采用丝型光位置检测器和自行研制了对数处理?用于测量光源点的束流位置和角度. 相似文献
7.
8.
9.
10.
11.
12.
13.
研制的永磁组件采用主辅永磁体和匀场技术相结合的改进C型磁路结构,利用计算机仿真技术对组件磁路结构进行验证及优化。仿真分析及实验结果表明:采用这种磁路结构扩大了均匀区的范围,提高了磁场均匀性。按这种结构制造的永磁组件在20 mm气隙、中心平面200 mm120 mm均匀区内气隙磁通密度达到0.75 T,不均匀度为0.67%。另外,也对永磁组件在高低温下的磁性能进行了仿真计算,结果表明:在-55~70 ℃温度范围内均匀区的气隙磁通密度变化为4%左右。 相似文献
14.
提出了宽带雷达散射截面(radar cross section, RCS)减缩人工磁导体复合结构, 通过将多个金属方片周期结构相复合, 进一步拓展了其工作带宽. 测试结果表明, 反射率小于-10 dB的频段为7.7—13.1 GHz, 相对带宽为51.9%. 通过全波仿真研究了其在不同频率的散射特性, 随着频率的增加, 在对角象限平分面上的反射峰逐渐向法线方向靠拢, 但其RCS较金属板的后向RCS仍减小-8 dB以上. 该人工磁导体复合结构具有工作带宽大、设计简单和加工容易等优点, 具有重要的应用前景. 相似文献
15.
J. Z. Shi Y. Yang H. K. Tan S. N. Piramanayagam C. B. Lim H. L. Seet S. L. Ho J. F. Hu 《固体物理学:研究快报》2017,11(2)
Partial crystallization in amorphous magnetic film is observed in this study. The film of Co46Fe46Zr5B3/Ru/Co46Fe46Zr5B3 (CFZB/Ru/CFZB) was prepared on glass substrate by DC magnetron sputtering. The CFZB underlayer (CFZB‐UL) and the CFZB overlayer (CFZB‐OL) were deposited under nominally same sputtering conditions, i.e. target, working gas, working pressure, input power, and deposition duration. The transmission electron microscopy (TEM) images with fast Fourier transform (FFT) patterns revealed that the CFZB‐UL was amorphous while the CFZB‐OL became unexpectedly partially crystallized. The result of X‐ray diffraction (XRD) spectra verified the TEM observation. The cause of the partial crystallization is attributed to the lower concentration of glass formers and the lattice matching between the overlayer and the Ru layer below. 相似文献
16.
提出在典型一阶磁脉冲压缩电路的基础上,测取磁芯在实际工作条件下的动态磁滞回线和饱和磁导率等磁参数,再根据所获得的动态参数指导磁开关设计,进行一阶磁压缩实验。实验选取国内外被广泛应用的非晶磁芯和纳米晶磁芯进行测试,根据实测动态磁参数设计磁开关。实测结果表明:用国产非晶磁芯做磁开关可得到上升沿73 ns、电压幅值28.3 kV、半高宽为503 ns的脉冲,用日本产的纳米晶磁芯做磁开关可得到上升沿30 ns、电压幅值28.4 kV、半高宽为193 ns的脉冲。 相似文献
17.
18.
Giant low-field magnetocaloric effect in EuTi(1-x)NbxO3(x = 0.05, 0.1, 0.15, and 0.2) compounds 下载免费PDF全文
The magnetic properties and magnetocaloric effect(MCE)of EuTi(1-x)NbxO3(x=0.05,0.1,0.15,and 0.2)compounds are investigated.Owing to electronic doping,parts of Ti ions are replaced by Nb ions,the lattice constant increases and a small number of Ti4+(3d^0)ions change into Ti3+(3d^1).It is the ferromagnetism state that is dominant in the derivative balance.The values of the maximum magnetic entropy change(-?SMmax)are 10.3 J/kg·K,9.6 J/kg·K,13.1 J/kg·K,and 11.9 J/kg·K for EuTi(1-x)NbxO3(x=0.05,0.1,0.15,and 0.2)compounds and the values of refrigeration capacity are 36,33,86,and 80 J/kg as magnetic field changes in a range of 0 T–1 T.The EuTi(1-x)NbxO3(x=0.05,0.1,0.15,and 0.2)compounds with giant reversible MCE are considered as a good candidate for magnetic refrigerant working at lowtemperature and low-field. 相似文献
19.
The paper proposes a novel structure for a permanent-magnet-biased radial hybrid magnetic bearing. Based on the air gap between the rotor and stator of traditional radial hybrid magnetic bearings, a subsidiary air gap is first constructed between the permanent magnets and the inner magnetic parts. Radial magnetic bearing makes X and Y magnetic fields independent of each other with separate stator poles, and the subsidiary air gap makes control flux to a close loop. As a result, magnetic field coupling of the X and Y channels is decreased significantly by the radial hybrid magnetic bearing and makes it easier to design control systems. Then an external rotor structure is designed into the radial hybrid magnetic bearing. The working principle of the radial hybrid magnetic bearing and its mathematical model is discussed. Finally, a non-linear magnetic network method is proposed to analyze the radial hybrid magnetic bearing. Simulation results indicate that magnetic fields in the two channels of the proposed radial hybrid magnetic bearing decouple well from each other. 相似文献
20.
对窄缝中气泡在磁性液体中的上升与变形进行了可视化研究。定性分析了纳米磁性颗粒引发的黏度效应及表面活性剂分子依附作用对气泡上升速度与形状的影响。试验工质为体积浓度6.33%的水基Fe_3O_4磁性液体,同时对比了质量浓度25%的四甲基氢氧化铵水溶液、质量分数30%和50%的蔗糖溶液以及水中气泡的上升运动。窄缝间隙分别为1 mm和2 mm,气泡由底部不同直径的圆孔产生。试验结果表明:由于活性剂分子的存在,磁性液体气泡上升过程中由扁椭圆形渐转变为上圆下平的冠状,而其略大于水的黏度使气泡在1 mm窄缝中保持直线上升运动,但窄缝间隙增大到2 mm后,磁性液体中气泡的运动轨迹仍会发生振荡。 相似文献