共查询到20条相似文献,搜索用时 171 毫秒
1.
2.
3.
4.
5.
6.
7.
8.
多股流换热器的(火积)耗散热阻分析 总被引:1,自引:0,他引:1
在分析多股流换热器特点的基础上,考虑流体在通道出口非等温混合产生的(米积)耗散,将板翅式多股流换热器的(火积)耗散分为通道换热(火积)耗散和混合(米积)耗散两部分,定义了多股流换热器的(米积)耗散热阻。通过对不同通道排列下的多股流板翅式换热器的计算,发现多股流换热器换热量与其(米积)耗散热阻一一对应,(米积)耗散热阻越小,换热量越大。在对多股流板翅式换热器的通道进行排列时,应采用冷热通道间隔布置的形式,并使冷热通道的换热负荷相近。 相似文献
9.
10.
11.
The enhancement of the heat transfer assisted by ultrasound is considered to be an interesting and highly efficient cooling technology, but the investigation and application of ultrasound in minichannel heat sinks to strengthen the flow boiling heat transfer are very limited. Herein, a novel installation of ultrasound transducers in the flow direction of a minichannel heat sink is designed to experimentally study the characteristics of heat transfer in flow boiling and the influence of operation parameters (e.g., heat flux, mass flux rate) and ultrasound parameters (e.g., frequency, power) on the flow boiling heat transfer in a minichannel heat sink with and without ultrasound field. Bubble motion and flow pattern in the minichannel are analyzed by high-speed flow visualization, revealing that the ultrasound field induces more bubbles at the same observation position and a forward shift of the onset of nucleation boiling along the flow direction, as ultrasonic cavitation produces a large number of bubbles. Moreover, bubbles hitting the channel wall on the left and right sides are found, and the motion speed of the bubbles is increased by 31.9% under the ultrasound field. Our results demonstrate that the heat transfer coefficient obtained under the ultrasound field is 53.9% higher than in the absence of the ultrasound field under the same conditions, and the enhancement ratio is decreased in the high heat flux region due to the change of the flow regime with increasing heat flux. This study provides a theoretical basis for the application of an ultrasound field in minichannel heat sinks for the enhancement of flow boiling heat transfer. 相似文献
12.
This article presents the experimental results of an evaluation of the influence of internal flow patterns on the heat transfer performance of a closed-loop oscillating heat pipe with check valves. It was found that the internal flow patterns could be classified according to four flow patterns: dispersed bubble flow, bubble flow, slug flow, and annular flow, respectively. The main regime of each flow pattern can be determined from a flow pattern map. The map can be used to predict the trend of the heat transfer rate in the closed-loop oscillating heat pipe with check valves. 相似文献
13.
为满足固体激光器用微通道冷却器的换热要求, 根据冷却器结构分别建立了二维和三维物理模型, 利用计算流体力学方法首先对比研究两者的流动特性, 然后考察雷诺数和玻片生热量对微通道流动和传热特性的影响。结果表明:对于类似大平板间的矩形微通道层流流动区域, 其流动及传热特性可直接采用二维简化模型进行模拟分析;对于重点关注的转捩区, 采用三维模型模拟分析更好;当雷诺数增大到转捩点, 流体的传热效果得到明显增强;随着雷诺数的增大, 玻片生热量对通道内最低压力需求的影响逐渐减小;不同玻片生热量对微通道流动影响不可忽略, 对努赛尔数和通道总压降基本无影响。 相似文献
14.
为了研究改变翅片材料对套片式翅片管换热器性能的影响,分别对采用铝翅片和黄铜翅片的套片式翅片管换热器(结构参数基本相同)进行传热特性与空气流动阻力特性的试验。试验得到了试件在一系列试验工况下的传热数据与管外空气流动阻力数据,通过计算得出了相应的传热准则关系式与管外空气流动阻力准则关系式,绘制了传热系数和管外空气流动阻力的有关图线。结果表明:黄铜翅片套片式换热器与铝翅片套片式换热器相比,换热性能优势明显,其原因主要是铝材比铜材软,与铜管胀接后的接触热阻大,因此换热性能更弱。 相似文献
15.
IGCC系统中新一代先进燃气轮机透平通流部分处于高温高湿的工作环境,因此其内部流动存在固有的复杂的流热耦合问题。为指导燃气轮机透平叶片冷却系统设计必须开展对流热耦合问题的试验与数值研究。本文在一平板气膜冷却流热耦合实验台上开展了模拟新一代燃气轮机透平通流部分高温高湿工作条件的流热耦合机理研究,并进行了数值模拟。研究工作... 相似文献
16.
In this article, an experimental investigation is performed to measure the boiling heat transfer coefficient of water flow in a microchannel with a hydraulic diameter of 500 μm. Experimental tests are conducted with heat fluxes ranging from 100 to 400 kW/m2, vapor quality from 0 to 0.2, and mass fluxes of 200, 400, and 600 kg/m2s. Also, this study has modified the liquid Froude number to present a flow pattern transition toward an annular flow. Experimental results show that the flow boiling heat transfer coefficient is not dependent on mass flux and vapor quality but on heat flux to a certain degree. The measured heat transfer coefficient is compared with a few available correlations proposed for macroscales, and it is found that previous correlations have overestimated the flow boiling heat transfer coefficient for the test conditions considered in this work. This article proposes a new correlation model regarding the boiling heat transfer coefficient in mini- and microchannels using boiling number, Reynolds number, and modified Froude number. 相似文献
17.
竖直圆管中超临界压力CO2对流换热实验研究 总被引:5,自引:1,他引:4
本文对超临界压力CO2在竖直加热圆管内的对流换热进行了实验研究,比较了不同流向、不同热流密度等对流动和换热的影响。实验结果表明,管内径为2mm时,在低进口Re条件下,由于浮升力影响导致层流向湍流提前转变, 对流换热增强;与向上流动相比,向下流动更易由层流转变为湍流;向下流动的换热要强于向上流动,表明浮升力对换热有很大影响。对于管内径为0.27 mm的微细圆管,当进口Re高于104时,浮升力的影响可以忽略,对流换热系数的变化完全由物性的变化尤其是cp的变化导致。 相似文献
18.
19.