Femtosecond Transform-Limited Pulse Generation by Compensating for the Linear Chirp of SPM Spectra in Dispersion Shifted Fibers

A simple technique of pulse compression, based on the linear chirp compensation of self-phase modulation (SPM) spectra in dispersion shifted fibers, is demonstrated. The optimization procedure is carried out, for a short span of a single-mode fiber, using a parabolic law, which describes the behavior of the squared output pulse width versus the pump peak power in the case of Gaussian pulses. The experimental results give a minimum pulse duration of 233 fs, which is in good agreement with the model. Shorter and coherent pulses, down to 90 fs, have been obtained by inserting an interference filter at the optical output.     

Sorting of bending magnets for the SSRF booster

The Shanghai Synchrotron Radiation Facility(SSRF)booster ring,a full energy injector for the storage ring,is deigned to accelerate the electron beam energy from 150MeV to 3.5GeV that demands high extraction efficiency at the extraction energy with low beam loss rate when electrons are ramping.Closed orbit distortion(COD)caused by bending magnet field uniformity errors which affects the machine performance harmfully could be effectively reduced by bending magnet location sorting.Considering the affections of random errors in measurement,both ideal sorting and realistic sorting are studied based on measured bending magnet field uniformity errors and one reasonable combination of bending magnets which can reduce the horizontal COD by a factor of 5is given as the final installation sequence of the booster bending magnets in this paper.     

Soliton squeezing generated in an all-fiber contiguration

We experimentally demonstrate amplitude squeezed soliton utilizing intensity-dependent self-phase modulation in an asymmetric Sagnac interferometer.The system.whose components are connected via ferrule connector/physical connection(FC/PC)fiber connectors,constitutes all-fiber configuration to generate squeezed soliton.Soliton amplitude reduction measured by homodyne detection is near 4.0 dB below the shot-noise level.Optimal squeezing fields in both simple and compact all-fiber configuration are obtained.     

Propagation of light in(2+1)-dimensional nonlinear optical media with spatially inhomogeneous nonlinearities

The(2 1)-dimensional nonlinear Schr(o)dinger(NLS)equation with spatially inhomogeneous nonlinearities is investigated,which describes propagation of light in(2 1)-dimensional nonlinear optical media with inhomogeneous nonlinearities.New types of optical modes and nonlinear effects in optical media are presented numerically.The results reveal that the regular split of beam can be obtained in (2 1)-dimensional nonlinear optical media with inhomogeneous nonlinearities,by adjusting the guiding parameter.Furthermore,the stability of beam regular split is discussed numerically,and the results reveal that the beam regular split is stable to the finite initial perturbations.     

A novel pose and illumination robust face recognition with a single training image per person algorithm

In the real-world application of face recognition system, owing to the difficulties of collecting samples or storage space of systems, only one sample image per person is stored in the system, which is so-called one sample per person problem. Moreover, pose and illumination have impact on recognition performance. We propose a novel pose and illumination robust algorithm for face recognition with a single training image per person to solve the above limitations. Experimental results show that the proposed algorithm is an efficient and practical approach for face recognition.     

Testifying experiment of the multi-pulse phenomena of capillary discharge soft-X-ray laser

In a capillary discharge experiment for the neon-like argon lasing, we have proposed an experimental scheme to verify that the multi-spike of X-ray diode (XRD) signal is a multi-pulse laser or is a reflection of the laser pulse in the XRD.The ceramic capillary has an inner diameter of 3mm and a length of 200mm.At the gas pressure of 28Pa and discharge current of 27kA, stable lasing has been realized.The experimental results prove that the multi-spike of XRD signal is a reflection of the electromagnetic signal produced by the laser pulse in the XRD.The improved electrocircuit scheme of the XRD to minimize the reflection phenomena is also found.     

Optical system and lens design for Blu-ray disc optical pick-up

During the design process of Blu-ray disc optical pick-up (BD OPU), the optical system and the collimator lens design is especially important. This paper designs an optical system and some lenses for the BD OPU, including collimator lens, beam shaping lens for laser beam shaping, and cylinder lens for signal detecting. In this OPU, we use a triplet lens to collimate the laser beam. At the same time, we build a series of assembly jigs to make sure that each lens can be put into the OPU basement properly. At last, we get the reading spot image and S-curve photo of OPU, which can be used to read Blu-ray disc (BD).     

Stable anticipation synchronization in mutually coupled vertical-cavity surface-emitting lasers system

Two vertical-cavity surface-emitting lasers(VCSELs) are mutually coupled through a partially transparent mirror (PTM) placed in the pathway. The PTM plays the role of external mirror,which controls the feedback strength and coupling strength.We numerically simulate this system by establishing a visible SIMULINK model.The results demonstrate that the anticipation synchronization is achieved and it can tolerate some extent frequency detuning.Moreover,the system shows similar chaos-pass filtering effect on unidirectionally coupled system even both VCSELs are modulated.This system allows simultaneously bidirectional secure message transmission on public channels.     

Terahertz optical asymmetric demultiplexer based tree-net architecture for all-optical conversion scheme from binary to its other 2n radix based form

To exploit the parallelism of optics in data processing,a suitable number system and an efficient encoding/decoding scheme for handling the data are very essential.In the field of optical computing and parallel information processing,several number systems like binary,quaternary,octal,hexadecimal,etc.have been used for different arithmetic and algebraic operations.Here,we have proposed an all-optical conversion scheme from its binary to its other 2n radix based form with the help of terahertz optical asymmetric demultiplexer (TOAD) based tree-net architecture.     

The transient suppression for piezoelectric ceramic emission transducer

A transient suppression method for piezoelectric ceramic transducer is presented. By adding some special pedestal pulses to the original transmitted signal, the transient effects in the output of the transducer can be just precisely transmission by use of a narrowband transducer. canceled, thereby achieving the broadband The experimental results show that the transient responses of the sinusoid pulses and coded signals are suppressed successfully and the acoustic waveforms radiated into the surrounding water are improved significantly.     

Broadcasting, Scalability, and Reconfigurability Aspects in an All-Optical Network Architecture

All-optical networks are a sound answer to the huge data traffic demand expected for the forthcoming information society. Interesting networking aspects are the broadcasting, scalability, and reconfiguration in an all-optical environment. These issues are addressed in the present article for an all-optical network called MATRIX, which is time slotted and uses packet switching. The architecture enables the all-optical interconnection of a large number of nodes with both a small number of wavelengths and wavelength continuity based on a consequent exploitation of wavelength-division multiplexing and space-division multiplexing (i.e., multiple fibers per cable are used). For an efficient use of the resources, each node is equipped with multiple transmitters and receivers, respectively. Two different broadcasting schemes are investigated. An analytical model is developed, and the corresponding simulation results are in good agreement. It is further shown how different networks of arbitrary size can be interconnected to larger all-optical network clusters, thereby providing scalability not only with respect to the number of nodes but also to the geographical extension. Finally, wavelength reassignments allow change of optical paths through the network in case of changing traffic patterns or network failures in order to best exploit the available network resources. The total number of possible configurations is determined by the theory of Latin Squares.     

A new tuning procedure for the DTL RF field pattern

The DTL tank is a multi-cell cavity.In a fabricated tank,the measured average axial field E0 for each cell may obviously deviate from the designed value.It is generally thought the deviation is due to the errors in fabrication and assembly.But it is not always true.In this paper,it is shown that the deviation may already exist before fabrication in some cases.It is partly due to the imperfection of the current design procedures.A new design method is introduced to reduce the deviation in the design stage.     

Monte-Carlo simulation of a compact gamma-ray detector using wavelength-shifting fibers coupled to a YAP scintillation crystal

The production and transportation of fluorescent light produced in wavelength-shifting fibers (WSFs) coupled to YAP scintillation crystal is simulated using the GEANT4 codes.An advantage of the wavelength-shifting fiber readout technique over a direct readout with a position-sensitive photo-sensor is the reduced requirement for position sensitive photomultiplier tube photocathode area.With this gamma-ray detector,the gamma camera is small and flexible and has larger effective field of view and low cost.Simulation results show that a) a mean 12 of photons per 59.5 keV gamma ray interaction is produced in the WSF located nearest to the incident gamma ray,and a spatial resolution of 3.6 mm FWHM is obtained,b)a mean 27 of photons per 140 keV gamma ray interaction is produced and a spatial resolution of 3.1 mm FWHM is obtained.Results demonstrate the feasibility of this concept of a compact gamma-ray detector based on wavelength-shifting fibers readout.However,since the very low photoelectron levels,it is very important to use a photon counting device with good single photo-electron response to readout the WSFs.     

Massive and massless neutrinos on unbalanced seesaws

The observation of neutrino oscillations requires new physics beyond the standard model (SM).A SM-like gauge theory with p lepton families can be extended by introducing q heavy right-handed Majorana neutrinos but preserving its SU(2)L x U(1)y gauge symmetry.The overall neutrino mass matrix M turns out to be a symmetric (p+q) x (p+q) matrix.Given p＞q,the rank of M is in general equal to 2q,corresponding to 2q non-zero mass eigenvalues.The existence of (p-q) massless left-handed Majorana neutrinos is an exact consequence of the model,independent of the usual approximation made in deriving the Type-I seesaw relation between the effective p x p light Majorana neutrino mass matrix M,and the q x q heavy Majorana neutrino mass matrix MR.In other words,the numbers of massive left- and right-handed neutrinos are fairly matched.A good example to illustrate this "seesaw fair play rule"is the minimal seesaw model with p ＝ 3 and q ＝ 2,in which one masslese neutrino sits on the unbalanced seesaw.     

Exploitation of the Fiber Capacity in Optical Networks Using Time, Frequency, and Space Division Multiple Accesses

In this work we investigate how to obtain very high capacity transmissions in optical networks taking into account the limitations due to the physical channel. We consider both the case in which all the users are connected by a star coupler and the case in which the users are directly connected by the network topology. As a reference, we consider a ring network and a Shuffle Multihop Network (SMN). The use of optical systems to implement high-capacity networks is numerically investi gated by means of numerical simulations taking into consideration the channel limitations due to the chromatic dispersion, the Kerr effect, and the amplified spontaneous emission (ASE) noise of the optical amplifiers. In our model, we consider that the signal, during the routing process that is performed at the user position, undergoes only an attenuation. We suppose the use of intensity modulated signals and receivers with direct detection. Packet switching and digital transmission are assumed with soliton and conventional nonreturn to zero signals. Both wave length and time division multiple accesses are considered. The results show that, in the case of the Time Division Multiple Access (TDMA) technique, the use of a star coupler to connect the users reduces the capacity of a network with respect to the case in which a direct connection of the users is used. This is due to the strong power fluctuations that are present during the signal propagation and to the large quantity of accumulated ASE noise. On the other hand, the use of a star coupler shows the advantage to being easily reconfigurable. The Wavelength Divison Multiple Access (WDMA) technique permits us to achieve higher capacities with respect to the TDMA. This is due to the fact that in the propagation conditions, due to the presence of a star coupler, high bit rate signals are strongly degraded. On the other hand, several low bit rate signals operating at different wavelengths can propagate with a low power level, avoiding strong degradation due to the Four Wave Mixing (FWM) effect. Among the topologies considered in this work, the SMN is the one that generally permits us to reach the highest throughput because in the SMN the signal hops in a limited number of Network Interface Units (NIUs) before reaching the final destination.     

Research on identifying the order of fringe pattern traces using angular scan and zone search method

A method for automatically identifying the order of fringe pattern traces is presented. It uses the simplified Otsu algorithm for obtaining the threshold, the angular scan in the range of 45~ for searching the trace positions, and the zone search technique for identifying different traces. Experimental results show that the proposed method may reliably obtain the order of fringe pattern traces orientating from almost 45° to 90°.