共查询到20条相似文献,搜索用时 62 毫秒
1.
介绍了高纯二氧化锆中痕量杂质元素Fe,Na,Si,Ti的ICP-AES测定方法。样品以浓H2SO4及(NH4)2SO4溶解,采用空白背景校正法消除基体Zr的光谱干扰,以基体匹配法补偿基体效应。各元素平均回收率为95%-106%,相对标准偏差为1.3%-3.0%。 相似文献
2.
ICP-AES法同时测定纯铁中八种杂质元素 总被引:10,自引:1,他引:9
本文研究了用ICP-AES法同时测定纯铁中8种杂质元素:Cr、Cu、Mg、Mn、Mo、Ni、Ti、V的分析方法。研究了铁基体地被测元素光谱线的光谱干扰与物理干扰,采用背景扣除法与基体匹配法进行校正。被测元素的检出限为0.4-3.0μg/L,合成试样的回收率为91-110%,杂持元素含量为0.0003-0.05%时,测量的相对标准偏差〈9%,方法简便、准确、结果满意。 相似文献
3.
陈俊芬 《光谱学与光谱分析》1996,(3)
本文应用DCP-AES法测定地质样品中微量锂。讨论了基体效应和阴离子效应、基体(Fe、Al、Ca、Mg、K和Na)对Li元素谱线产生不同程度的增强效应。在待测溶液中加入一定量的基体元素,能有效地降低或消除这种影响。基体元素产生的增强效应主要是阳离子的作用。还讨论了分析线的线性状况。方法简便可靠,Li的测定范围为1~1500μg/g,相对标准偏差为3.1~6.3%。 相似文献
4.
电感耦合等离子体质谱法测定高纯镉中的杂质元素 总被引:3,自引:0,他引:3
采用电感耦合等离子体质谱法测定高纯镉中的杂质元素。讨论了镉基体的谱线干扰,比较了镉基体产生的多原子离子的干扰程度,该干扰按CdH、CdO、CdO2 、CdAr、CdOH和CdOH2 顺序递减。研究了不同浓度镉基体对分析物信号的抑制或增强效应,镉的浓度大于0.25g·L- 1 时,对质量数小于100的分析物的信号强度产生抑制,而对质量数大于150 的分析物的信号强度产生增强,采用89Y和209 Bi作内标分别克服基体的抑制和增强效应。测定了高纯镉的As、Be、Co、Cu、Ga、Ge、Mn、Mo、Pb、Ni、Sr、Au、Tl、Th、V 和U 等16 个杂质元素,方法的检测限0.005~0.052 μg·L- 1 ,标准加入回收率82% ~108% 。 相似文献
5.
本文采用ICP-AES法同时测定了掺质Ca3(VO4)2,晶体中Ca,V,Nd,Yb,Ge的含量,选择了合适的分析谱线和积分时间,试样用硝酸溶解后直接测定,方法简便,准确,快速,合成试样中各被测元素的回收率为98%-104%,相对标准偏差〈4.0%,Nd,Yb,Ge的检出限为0.0002-0.018μg/mL。 相似文献
6.
本文报道了用ICP-AES法同时测定硝酸锶晶体中掺杂元素Ag、Ca、Ce、Cu、Fe、La、Mg、Mn、Na、Zn的分析方法。本方法采用基体匹配法与背景扣除法对基体干扰及光谱干扰进行校正,被测元素检出限为0.1-16ng/mL,合成样品的回收率为90%-116%。相对标准偏差均小于13%。本法简便、快速、准确。 相似文献
7.
8.
本文用电化学现场表面增强拉曼散射光谱(SERS)技术研究了MTU在HClO4、H2SO4和HNO3介质中分别与一种或两种无机阴离子的共吸附行为,发现ClO-4、SO2-4和NO-3等弱吸附无机阴离子均能被MTU诱导物理吸附在其质子化了的氨基(NH+3)上,这三种无机阴离子被MTU诱导物理吸附的强弱顺序是:在电极电位位于-0.2V~-0.7V区间时,SO2-4>ClO-4>NO-3,在电位位于-0.8V~-1.2V区间时,ClO-4>SO2-4>NO-3。 相似文献
9.
非晶态Fe0.5Al0.5PO4表面上激光促进甲烷直接氧化合成甲醇的研究 总被引:1,自引:0,他引:1
用溶胶-凝胶法合成了非晶态Fe0.5Al0.5PO4。用XRD和TPR表征了其结构和晶格氧的活性;用IR和TPD表征了CH4在其表面上的吸附行为;用LSSR方法考察了CH4直接氧化合成CH3OH的反应规律。结果表明,Fe0.5Al0.5PO4具有非晶态的结构,FePO4和AlPO4的微区被均匀地相互隔离,导致固体本身不具有长程有序性。非晶态的Fe0.5Al0.5PO4与晶态的Fe0.5Al0.5P 相似文献
10.
ICP-AES法测定钛合金中的6种元素 总被引:4,自引:1,他引:3
用HCl分解钛合金样品,直接用ICP-AES法测定其中的Cr、Mo、Fe、Si、Al及Zr6种元素,方法简便、快速、测定各元素含量范围为0.28%-6.51%,相对标准偏差为0.72%-5.07%,回收率为97.4%-102%。 相似文献
11.
The coulometric titration curve for lithium intercalation in polyacetylene has been determined using poly(ethylene oxide) based solid electrolyte. The plateaus observed suggest the existence of stages, comparable to graphite. This interpretation seems also supported by the cyclic voltammetry scans on polyacetylene. Lithium intercalation appears as a very slow process with estimated at ? 10-13cm2.s-1. 相似文献
12.
13.
14.
P. Bunton M. Binkley G. Asbury 《Applied Physics A: Materials Science & Processing》1997,65(4-5):411-417
Received: 21 May 1997/Accepted: 4 July 1997 相似文献
15.
A lithium isotope separation was performed using a laser isotope separation method. It was found that the lithium atoms with a natural isotopic abundance enhanced its6Li concentration up to over 90% by tuning the laser wavelength to the2
P
1/2 of6Li. Too high power, however, leads to a loss of enrichment due to the power broadening effect which was analysed by the equation of motion of density matrices. 相似文献
16.
17.
18.
19.
Youbao Wan Junhao Chu Shaoling Guo Lingxian Bo Tianyan Yu Bingkun Yu 《International Journal of Infrared and Millimeter Waves》2001,22(1):197-205
The potassium lithium niobate crystals have been grown up. The shapes of solid-melt interfaces which maintaining the steady growth of the potassium lithium niobate crystals have been described. The optical transmission spectrum of the crystal has been surveyed. The perfected crystals showed good Second Harmonic Generation properties. 相似文献
20.
Dedryvère R. Uhrmacher M. Lohstroh A. Picard-Garcia A. Olivier-Fourcade J. Jumas J.-C. 《Hyperfine Interactions》2001,136(3-8):479-484
The electrochemical insertion of lithium into β-In2S3 at different concentrations has been investigated by means of γγ-Perturbed Angular Correlations measurements using implanted
radioactive 111In nuclei. The study of the hyperfine interactions of the 111Cd nuclei during the decay 111In(EC)111Cd allowed to determine the evolution of the three observed electric field gradients at different temperatures and lithium
contents. This study reveals a great difference of behavior between the three indium sites of the structure, and shows the
mobility of indium ions and their partial reduction after lithium insertion. In2S3 is good model material to study the properties of more complex materials based on this structure, which may be used as electrodes
for lithium-ion batteries.
This revised version was published online in September 2006 with corrections to the Cover Date. 相似文献