共查询到20条相似文献,搜索用时 421 毫秒
1.
2.
3.
中国科学院高能物理研究所建造了一台基于加速器的硼中子俘获治疗(BNCT)实验装置。射频功率源系统为352.2 MHz射频四极加速器(RFQ)提供高频功率,使束流离开RFQ时,其能量达到3.5 MeV。BNCT射频功率源系统主要包括速调管功率源、数字低电平控制系统、射频传输系统。本文介绍了BNCT射频功率源系统,主要包括物理需求、系统组成、关键设备、安装和调试。目前该装置已进行动物实验,加速器打靶束流功率4.3 kW,加速器射频功率源系统运行稳定。 相似文献
4.
为了进一步提高束流品质并逐步采用双束加速技术, BEPCII直线加速器准备采用带有两个次谐波聚束器的双次谐波聚束系统。目前, 该次谐波聚束系统的物理设计和优化已经基本完成。由于新设计的双次谐波聚束系统很不同于BEPCII现有的聚束系统, 因此, 就要求对聚束系统中存在的各种抖动(jitter)效应重新进行研究。 使用多粒子模拟计算程序PARMELA对电子枪的高压抖动和定时抖动、次谐波聚束器的相位抖动以及功率抖动、聚束器中加速电场相位以及A0加速管(俘获加速节)中加速电场相位的抖动等效应进行了研究, 并最终确定了聚束系统中各部件的物理公差要求。 相似文献
5.
6.
7.
BEPCⅡ重大改造工程要求将对撞机的峰值亮度提高近百倍,并具有高积分亮度,为此必须对作为注入器的直线加速器进行重大改造,提供高能、强流、小发射度和小能散度的正负电子束,达到高注入速率(正电子50mA/min.)的要求.这对直线加速器各系统和束流调试是一个挑战.在成功建造了新电子源、新正电子源、新微波功率源、相位控制系统和束流轨道测量系统等的基础上,着重叙述了束流参数的调试结果,束流能量、能散度、发射度、传输效率均达到(或优于)设计指标.描述了束流参数稳定性的研究、改进和成功地达到稳定运行.最后简述了新建中的次谐波聚束系统,以进一步提高束流性能和注入速率. 相似文献
8.
BEPCⅡ重大改造工程要求将对撞机的峰值亮度提高近百倍, 并具有高积分亮度, 为此必须对作为注入器的直线加速器进行重大改造, 提供高能、强流、小发射度和小能散度的正负电子束, 达到高注入速率(正电子50mA/min.)的要求. 这对直线加速器各系统和束流调试是一个挑战. 在成功建造了新电子源、新正电子源、新微波功率源、相位控制系统和束流轨道测量系统等的基础上, 着重叙述了束流参数的调试结果, 束流能量、能散度、发射度、传输效率均达到(或优于)设计指标. 描述了束流参数稳定性的研究、改进和成功地达到稳定运行. 最后简述了新建中的次谐波聚束系统, 以进一步提高束流性能和注入速率. 相似文献
9.
10.
为满足中国散裂中子源打靶功率提升需求,加速器采用外置天线射频负氢离子源替换此前使用的潘宁表面负氢离子源,为加速器提供高品质和高稳定的束流。文章主要介绍了基于EPICS软件系统和PLC硬件平台的射频负氢离子源控制系统设计方案和具体实现。针对射频功率源的电磁干扰和高压平台打火造成设备损坏,给出了相应的解决措施。此外,为提高离子源长期运行稳定性,设计了放电室高精度注铯控制程序及打靶功率稳定程序。控制系统自投入运行以来,运行稳定可靠,为离子源的高效运行提供了有力保障。 相似文献
11.
加速器驱动次临界装置(ADS)对加速器运行稳定性和失束指标提出了前所未有的要求。对于超导直线加速器的研究发现,超导腔失效是失束的一个较大的来源,故针对超导腔的失效情况,本文提出分段补偿新方法,以提高高功率超导直线加速器的运行稳定性。提出的分段补偿方法与已有的全局补偿和局部补偿的方法相比,在保证加速器出口束流品质与无束损束流传输的同时,分段补偿束流能量,优化了参与能量补偿的超导腔数量,降低超导腔的备份功率源需求。论文最后针对CiADS的超导直线加速器的物理设计,做了分段补偿的多粒子模拟。结果表明,采用了分段补偿方法实现超导腔失效补偿的前提下,参与补偿过程中改变腔压的超导腔数量比例为48%,对功率源总的功率备份冗余需求小于20%。The accelerator driven subcritical system (ADS) has put forward unprecedented demands on the stability and beam trip of the accelerator operation. Depending on analysis, failure of the superconducting cavities is a major cause for beam trip of the superconducting cavity. Therefore, a new method of piecewise compensation is proposed to improve the stability of high power superconductivity linac. The piecewise compensation scheme proposed in this paper is compared with the existing global compensation and local compensation technology. While guaranteeing the beam quality of the accelerator and without beam loss transmission, the piecewise compensation method can optimize the number of superconducting cavities involved in energy compensation and reduce the demand for the backup redundancy of power sources of the superconducting cavities. At the end of the paper, the multi-particle simulation of piecewise compensation aims at the physical design of CiADS superconducting linac. The result shows that 48% of superconducting cavities modify the cavity's Epeak during the compensation process and the demanded redundancy of total power sources is less than 20% under the premise of successful compensation for the failure of superconducting cavities through the piecewise compensation method. 相似文献
12.
Xiongwei Zhu 《International Journal of Infrared and Millimeter Waves》2004,25(4):667-671
The effect of high spatial harmonics on beam dynamics in a axisymmetric radio frequency linear accelerator (RF linac) is examined. The high spatial harmonics forms the second order ponderomotive focusing for the relativistical particle beam when the transverse motion is averaged over the period of RF structure, the beam transverse envelop equation is obtained including the ponderomotive focusing force which is useful for the design of RF gun and linac. Under a certain of high spatial harmonics coefficients, the high spatial harmonics increase the energy spread due to the stochasitical beam energy diffusion. 相似文献
13.
ADS注入器Ⅰ高频四极场(RFQ)功率源系统将为325MHz RFQ提供连续波功率,使束流离开RFQ时,其能量达到几MeV。功率源系统除了补偿RFQ腔耗外,还必须提供足够的功率以保证RFQ中的加速电场。ADS注入器ⅠRFQ功率源系统主要包括600kW连续波速调管、80kV/18A基于脉冲步进调制技术的PSM电源、环流器以及相应的波导传输系统等。根据ADS总体指标和RFQ的相关技术参数,提出了功率源的总体布局、技术指标以及设计要求等,在此基础上完成系统安装与调试,并通过专家组测试与验收。 相似文献
14.
15.
《中国物理C(英文版)》2015,(9)
The ADS accelerator in China is a Continuous-Wave(CW) proton linac with 1.5 Ge V beam energy,10 m A beam current, and 15 MW beam power. To meet the extremely low beam loss rate and high reliability requirements, it is very important to study the beam halo caused by beam mismatch, which is one major sources of beam loss. To avoid envelope instability, the phase advances per period are all smaller than 90 degrees in the main linac design. In this paper, simulation results of the emittance growth and the envelope oscillations caused by mismatch in the main linac section are presented. To meet the emittance growth requirement, the transverse and longitudinal mismatch factors should be smaller than 0.4 and 0.3, respectively. 相似文献
16.
17.
中国散裂中子源一期工程的直线加速器,共有8套数字化射频低电平控制单元,射频低电平的本地控制属于EPICS的异构系统,无法直接与EPICS客户端进行通信。通过在射频低电平本地控制上位机程序中嵌入一个C#类型的EPICS服务器程序,实现了使用EPICS客户端对射频低电平系统的远程控制, 从而把射频低电平控制系统接入基于EPICS框架的控制系统中。直线射频低电平远程控制投入在线运行以来,运行稳定可靠。 相似文献
18.
针对质子治癌直线加速器功耗少、长度短的要求,设计了一台工作频率为324 MHz的漂移管型质子直线加速器(DTL)。该DTL把粒子从2.5 MeV加速到7 MeV,功耗为265 kW, 总长1.9 m。横向聚焦采用FODO结构,漂移管内放置永磁铁。提出一种新的束流匹配方案,在射频四极场加速器(RFQ)与DTL之间不设束运线,而是以 DTL入口处的4个单元为匹配段,把RFQ出口处相椭圆匹配到DTL周期结构入口处的相椭圆。 用PARMILA程序对该DTL进行了动力学模拟,结果表明该方案的束流发射度增长很小。 相似文献
19.
20.
The China ADS(C-ADS) project proposes to build a 1000 MW Accelerator Driven sub-critical System around 2032. The accelerator will work in CW mode with 10 mA in beam current and 1.5 GeV in final beam energy. The linac is composed of two major sections: the injector section and the main linac section. There are two diferent schemes for the injector section. The Injector-scheme is based on a 325 MHz RFQ and superconducting spoke cavities of the same RF frequency and the Injector-scheme is based on a 162.5 MHz RFQ and superconducting HWR cavities of the same frequency. The main linac design will be diferent for diferent injector choices. The two diferent designs for the main linac have been studied according to the beam characteristics from the diferent injector schemes. 相似文献