Low power Electro-optical filter: Constructed using silicon nanobeam resonator and PIN junction

In this paper, a high tunable Electro-optical filter is designed and simulated with low electric power consumption. A silicon nanobeam resonator based on one-dimensional photonic crystal in the form of Fabry–Perot structure, silicon-on-insulator waveguide, is proposed with a PIN junction. In designing nanobeam resonator, “deterministic design method” is used to achieve the high quality factor and high-transmission rate. Tuning of the resonant wavelength in the output channel of the filter is achieved by manipulating the refractive index of the active area by using the free-carrier dispersion effect. The output wavelengths of designed device can be tuned for the telecom-friendly 1.55 µm range. The device shows a wavelength shift higher than 3 nm for a power consumption of only 0.9 mW. Finally, the simulation results show that the provided device can be considered as a narrowband and tunable Electro-optical filter that is suitable for DWDM communication system.     

Multi parameter optimization of Raman Fiber Amplifier using genetic algorithm for S band dense wavelength division multiplexed system

A simple genetic algorithm is implemented to perform multi parameter optimization of Raman Fiber Amplifier for 100 channel S band dense wavelength division multiplexed system at 25 GHz interval. A cost effective system using single Raman pump is investigated aiming at maximum average gain. The single counter propagating pump is optimized to frequency of 211.528 THz and 652.93 mW power level with optimum Raman fiber length of 44.064 Km. There is evidence to show that the optimum solution presents a small gain variation (less than 3 dB) over an effective bandwidth covering 197–199.475 THz. The optimized configuration enabled an adequate system performance in terms of acceptable Q-factor (19.52 dB) and BER (1.46 × 10⁻²¹).     

Investigations on order and width of RZ super Gaussian pulse in different WDM systems at 40 Gb/s using dispersion compensating fibers

In optical wavelength division multiplexed (WDM) systems the dispersion management is a key issue. In optical systems a lot of research is going on to reduce dispersion by selecting proper dispersion compensating techniques and proper modulation format for input data. One way to reduce dispersion is by using dispersion compensating fibers in the WDM systems. This paper analyzes the use of RZ super Gaussian pulse inputs for different WDM systems i.e. for conventional, dense and ultra dense WDM systems employing dispersion compensating fibers. The pulse width and the order of the RZ super Gaussian pulse was varied to evaluate the performance at 40 Gb/s. The experiment showed that to get minimum BER, pulse width of 7.5 ps and 10 ps along with third-order RZ super Gaussian pulse were found suitable and recommended to be used.     

Advanced Optical Network

The following article describes an advanced dense wavelength division multiplexing (DWDM) Optical Network developed by L-3 Photonics. The network, configured as an amplified optical bus, carries traffic simultaneously in both directions, using multiple wavelengths. As a result, data distribution is of the form peer-to-multi-peer, it is protocol independent, and it is scalable. The network leverages the rapid growth in commercial optical technologies, including wavelength division multiplexing (WDM), and when applied to military and commercial platforms such as aircraft, ships, unmanned and other vehicles, provides a cost-effective, low-weight, high-speed, and high noise-immune data distribution system.     

DWDM用薄膜窄带滤光片的容差特性模拟分析

讨论了用于DWDM系统的薄膜窄带滤光片在镀制过程中的监控方法及误差产生的机理,利用自行建立的计算机膜厚容差模拟程序,分析了多FabryPerot腔窄带滤光片的容差特性.发现多腔窄带滤光片各腔的误差灵敏度与腔的位置有关,且各腔间隔层组成材料不同,其对误差最敏感的膜层位置也不相同.     

一种不等带宽光学梳状滤波器

提出了一种新型—Michelson—三面镜FabryPerot型50GHz不等带宽光学梳状滤波器设计方案,分析和模拟表明:该器件将一路信道间隔为50GHz的输入信号分离成信道间隔为100GHz的奇偶两路输出信号,其中在3dB处,奇数信道带宽大于30GHz用于10Gb/s传输,偶数信道带宽大于60GHz用于40Gb/s传输对于将来的40Gb/s系统,该器件具有优势.     

Cost-Effective Migration from Sub-Lambda to Wavelength-Based Metro Networks

This article will discuss the importance of hybrid coexistence of sub-lambda grooming with wavelength-based services for driving down costs and maximizing the use of metro bandwidth, as well as enabling next-generation lambda-based services. The article will also address migration to all optical metro networks.     

基于法布里-珀罗腔反射光相位特性设计的梳状滤波器

提出了一种用于设计密集波分复用全光网络中梳状滤波器的方法，该器件利用法布里-珀罗腔反射光相位的非线性性质，结合光的相位在一定光程差下随频率呈线性周期变化的特点，通过使这样两束相位匹配的光发生干涉，得到所需滤波特性。运用江膜特征矩阵对模型进行了模拟计算，并分析了计算结果，论证了这种结构的可行性。     

光互联网的抗毁性设计研究

由于互联网层叠模型中多层都存在重复的保护与恢复机制，致使互联网的实现极其复杂，造成网络传输效率较低，而且拥塞。随着密集波分复用（DWDM）的广泛使用和网络底层性能的大幅度提高，已经不需要再对网络中多层进行重复保护与恢复。在此基础上，采用了未来光互联网3层 (应用层、IP层和光互联层) 协议模型，并对其中的光互联层的保护进行了深入的研究，提出了部分共享备用路径保护(P-SPP)方法。此模型能充分利用IP层电子的灵活恢复机制与光互联层的快速保护与恢复机制，提高光互联网的传输性能，以适应目前高速发展的互联网对传输带宽的要求。     

在线滤波技术在光纤马赫-德尔交叉复用器中的应用

为构造出与理想梯形滤波器接近的滤波形状，在单级光纤马赫-德尔交叉复用器的基础上，引入在线滤波技术；通过增加干涉级数和调整2对干涉臂的干涉长度和耦合器的耦合比，实现了逼近宽带陡沿的滤波输出。通过与梯形滤波器傅里叶展开式的比较，计算得到了器件的最佳参数，器件的滤波性能以及温度稳定性相对于单级结构得到了明显提高。根据理论计算，成功制作出通道间隔为50GHz的样品器件。其输出为-0.5dB，带宽大于0.185nm，相邻通道隔离度大于30dB，满足了DWDM系统指标要求。