一种新型双吡啶悬臂Mn(Ⅱ)配合物的合成、晶体结构及DNA结合能力研究

通过3,3′-((乙烷-1,2-二基双(2-甲基吡啶杂氮二基)双(亚甲基))双(2-羟基-5-甲基苯甲醛)与2-羟基-1,3-丙二胺的缩合反应得到一种具有双吡啶悬臂的双核锰配合物。通过X射线单晶衍射确定了该配合物结构,结果显示其分子式为[Mn₂(C₃₇H₄₃N₆O₆)]·(ClO₄)₂。该配合物属于单斜晶系,P2₁/c空间群,晶胞参数为:a=1.096 50(19) nm, b=1.419 5(3) nm, c=3.109 4(5) nm, β=108.153(5)°。进一步分析表明两个二价锰离子分别与(N_amine)₂(N_imine)₂O₃和(N_imine)₂O₄体系配位,它们与配位原子形成的几何构型分别是十面体和扭曲的八面体。两个中心锰离子距离为0.331 6 nm,由酚氧原子和醋酸根共同桥联。另外,本文也利用伏安法和黏度法对该配合物与小牛胸腺DNA的结合能力进行研究,实验结果表明它们之间的结合方式为弱的插入作用。     

Te溶剂Bridgman法CdMnTe晶体核辐射探测器的制备和表征

碲锰镉(CdMnTe)作为性能优异的室温核辐射探测器材料,可用于环境监测和工业无损检测领域。本文中采用Te溶剂Bridgman法生长In掺杂Cd_0.9Mn_0.1Te晶体,制备成10 mm×10 mm×2 mm大小的室温单平面探测器,研究了该探测器对²⁴¹Am@59.5 keV γ射线源的能谱响应。通过表征红外透过率、电阻率以及探测器能谱响应等参数,综合评定了探测器用CdMnTe晶体的质量、电学和探测器性能。结果表明,晶片的红外透过率均在55%以上,最好可达到60%。采用湿法钝化,100 V偏压下的漏电流由钝化前的9.48 nA降为钝化后的7.90 nA,钝化后的电阻率为2.832×10¹⁰ Ω·cm。在-400 V反向偏压下,CdMnTe探测器对²⁴¹Am@59.5 keV γ射线源的能量分辨率在钝化前后分别为13.53%和12.51%,钝化后的电子迁移率寿命积为1.049×10^-3 cm²/V。研究了探测器的能量分辨率随电压的变化特性,当偏压≤400 V时,探测器的能量分辨率主要由载流子的收集效率决定,而当偏压>400 V时,能量分辨率由漏电流决定。本文研究结果表明,Te溶剂Bridgman法生长的CdMnTe晶体质量较好,电阻率和电子迁移率寿命积满足探测器制备需求。     

电感耦合等离子体原子发射光谱法(ICP-AES)测定铜磁铁矿中铜、锰、铝、钙、镁、钛和磷的含量

通过样品处理、干扰实验、方法检出限、准确度和精密度实验,确定了最佳实验条件,建立了电感耦合等离子体-原子发射光谱法(ICP-AES)测定铜磁铁矿中铜、锰、铝、钙、镁、钛和磷含量的方法。试料经盐酸、硝酸、氢氟酸、高氯酸分解,用盐酸溶解盐类,过滤,采用电感耦合等离子体原子发射光谱法同时测定滤液中铜、锰、铝、钙、镁、钛和磷的含量。方法检出限为锰、钛和磷小于0.00085%,其它元素小于0.0054%,分析结果与分光光度法、X射线荧光光谱法(XRF)和原子吸收光谱法(AAS)分析结果一致,8个实验室对5个水平样品进行协同实验给出了方法的精密度。     

三元素氢氧化物中镍钴锰含量的测定

采用仪器分析方法和化学分析方法相结合测定三元前驱体Ni0.33Co0.33Mn0.33(OH)2中镍、钴、锰主含量,分别采用电感耦合等离子体原子发射光谱(ICP-AES)内标法测定镍、钴、锰的摩尔比例,EDTA滴定法测定镍、钴、锰的摩尔总量,计算得到各元素的含量。通过优化实验条件,进行了准确度和精密度实验,加标回收率为99.2%~101%,相对标准偏差小于0.65%。方法准确、快速,已用于实际的检测工作中。     

CoMn@NC催化5-羟甲基糠醛常压氧化为2, 5-呋喃二甲酸二甲酯

Dimethyl furan-2, 5-dicarboxylate (DMFDCA) is a valuable biomass-derived chemical that is an ideal alternative to fossil-derived terephthalic acid as a monomer for polymers. The one-step oxidation of 5-hydroxymethylfurfural (HMF) to DMFDCA is of practical significance. It not only shortens the reaction pathway but also avoids the separation process of intermediates; thus, reducing cost. In this work, non-noble bimetallic catalysts supported on N-doped porous carbon (CoMn@NC) were synthesized via a one-step co-pyrolysis procedure using different pyrolysis temperatures and proportions of metal precursors and additives. We employed the prepared CoMn@NC catalysts in the aerobic oxidation of HMF under mild reaction conditions to obtain DMFDCA. High-yield DMFDCA was obtained by screening the prepared catalysts and optimizing the reaction conditions, including the strength and amount of the base, as well as the reaction temperature. The optimized yield of DMFDCA was 85% over the Co₃Mn₂@NC-800 catalyst after 12 h at 50 ℃ using ambient-pressure oxygen. The physicochemical properties of the catalysts were determined using a variety of characterization techniques, the factors affecting the performance of each catalyst were investigated, and the relationship between the physicochemical properties and performance of the prepared catalysts was elucidated. A porous structure with a high surface area had a positive effect on mass transfer efficiency. Cobalt nanoparticles (NPs) and atomically dispersed Mn were coordinated to N-doped carbon to form M―N_x (where M = Co or Mn). Based on the Mott-Schottky effect, there was significant electron transfer between each metal and the N-doped carbon, additionally, the metal NPs supplied electrons to the carbon atoms. The electron-deficient metal site in the pyridinic N-rich carbon was beneficial for the activation of HMF and oxygen. The activation of oxygen produced reactive oxygen species (such as superoxide radical anions) to ensure high selectivity to DMFDCA through dehydrogenative oxidation of the hemiacetal intermediate and hydroxymethyl group of 5-hydroxymethyl-2-methyl-furoate. The existence of disordered and defective carbons increased the number of active sites. Subsequently, we performed a series of control experiments. Based on our current experimental results and previous studies, we propose a simple mechanism for the aerobic oxidation of HMF to DMFDCA. The catalyst was stable, its performance decreased slightly after two cycles, and it was tolerant to SCN⁻ ions and resistant against N or S poisoning. Furthermore, the use of this catalytic system can be expanded to various substituted aromatic alcohols, such as benzyl alcohols with different substituents, furfuryl alcohol, and heterocyclic alcohols. Simultaneously, the product type was further extended from methyl esters to ethyl esters with a high yield when the substrate reacted with ethanol. In conclusion, this catalytic system can be applied in the production of carboxylic esters for polymers.     

锰离子氧化沉淀法实现锂离子电池LiNi0.8Co0.05Mn0.15O2材料的回收和利用

以浓盐酸为浸出剂,以NaOH和NH₄HCO₃为沉淀剂,利用Mn²⁺在碱性条件下的氧化反应改变离子的沉淀次序进而分步回收的方案,探究了浓盐酸酸浸处理三元正极材料LiNi_0.8Co_0.05Mn_0.15O₂的最佳条件。在分步沉淀过程中,Mn²⁺被氧化为不溶于非还原性酸的MnO （OH）₂,并在酸性条件下回收。Ni、Co则在碱性条件下利用NaOH回收,而Li则利用NH₄HCO₃回收。该方法中Mn的回收率达到85.1%,产品纯度达到98.6%; Li的回收率达到95.0%,产品纯度达到99.3%。由回收材料重新合成的三元正极组装的软包电池的首圈放电比容量达到了175 mAh·g^-1,可以以超过99.5%的库仑效率稳定循环50圈。     

N-杂环卡宾-吡啶锰配合物/四丁基碘化铵催化CO2和环氧化物合成环状碳酸酯(英文)

该工作发展了一类二齿N-杂环卡宾(NHC)-吡啶锰配合物催化CO₂和环氧化物偶联反应的方法.锰配合物和四丁基碘化铵(TBAI)构成的二元催化体系对环氧化物和CO₂合成环状碳酸酯的反应表现出了较高的活性.该二元催化体系适用于广泛的底物范围,例如端环氧化物和高位阻的内环氧化物.通过紫外-可见光谱、红外光谱和高分辨质谱的研究对反应机理进行了阐述.     

基体分离-电感耦合等离子体原子发射光谱法 测定精铋中10种杂质元素

试验采用电感耦合等离子体发射光谱法测定精铋中Cd、Co、Cu、Fe、Mg、Mn、Ni、Pb、Ti、Zn十种杂质元素,样品用优级纯硝酸溶解,往60℃左右的溶液中,滴加氨水(1+1),控制pH值在3.0~4.0。考察了温度、酸度、沉降时间对铋的去除率和对检测结果的影响。根据分析线的选择原则,结合待测元素的检测范围,选择无干扰、峰形对称、灵敏度适中的谱线作为分析线Cd 228.802nm、Co 237.862nm、Cu 324.754nm、Fe 259.940nm、Mg 279.553nm、Mn 257.610nm、Ni 231.604nm、Pb 182.205nm、Ti 323.452nm、Zn 213.856nm。各元素的质量浓度在一定范围内与其发射强度呈线性,校准曲线的线性相关系数均大于0.9997,方法中各元素检出限为0.002μg/g~0.253μg/g。?按照实验方法测定精铋实际样品,结果的相对标准偏差(RSD,n=9)为2.5%~9.8%,加标回收率为95.0%~102.2%,满足检测要求。