基于XPS对硫铁矿去除SeO2-3的机理研究

硒是动植物及人体生长必需的十五种微量元素之一，具有清除体内自由基、抗氧化、增强免疫力等功能，但其安全剂量的范围却很窄。利用扫描电子显微镜（SEM）和X射线衍射仪（XRD）对湿法球磨制备的硫铁矿形貌进行了表征。SEM观测发现加乙醇助磨后的硫铁矿为粒径大小较均匀的球形颗粒团聚体，粒径范围在17～200 nm之间，平均粒径138 nm。XRD衍射图谱中的特征峰与FeS₂衍射图谱中各峰位置基本一致，因此判定硫铁矿中主要化学组分为FeS₂，且图谱中基本没有杂峰，表明制备过程中并未混入杂质，样品纯度较高。实验结果表明，该法制备的硫铁矿具有颗粒粒径小、比表面积大、反应活性高等优点。研究中利用X射线光电子能谱仪（XPS）对硫铁矿去除水体中SeO2-₃的机理进行了研究。研究结果表明, （1）在较为广泛的实验pH范围（pH 2.2～11.5），硫铁矿均能有效去除水体中SeO2-₃，去除效率（除pH值7.8以外）均达到90%以上；（2）硫铁矿与SeO2-₃发生反应后，其主要组成元素的XPS特征峰结合能有所减小，表明硫铁矿表面发生了一定化学变化；（3）酸碱环境下硫铁矿去除SeO2-₃的机理不完全相同，酸性环境下，硫铁矿对SeO2-₃的去除是单纯的氧化还原过程，即硫铁矿中被酸活化的S2-₂将SeO2-₃还原为单质Se(0)，并且酸性越强，SeO2-₃去除效果越好；碱性环境下，SeO2-₃的去除过程中氧化还原与络合反应并存，硫铁矿表面有络合态Fe(OH)SeO₃和单质Se(0)两种存在形态，且碱性越强，络合态Fe(OH)SeO₃含量越高。以上研究结果为硫铁矿去除固定水体和土壤中以SeO2-₃为代表的可变价金属阴离子提供重要理论依据和应用基础。     

蓝宝石R面上ZnO薄膜的NH3掺杂研究

以NH₃为掺杂源,利用金属有机化学气相沉积(MOCVD)系统在蓝宝石R面上生长出掺氮ZnO薄膜。通过XRD,SEM测量优化了其生长参数,在610℃和在80sccm的NH₃流量下生长出了〈1120〉单一取向的ZnO薄膜。经Hall电阻率测量,得知该薄膜呈现弱p型或高电阻率,并对其光电子能谱进行了研究。     

Study on the Superhydrophilicity of the SiO2-TiO2 Thin Films Prepared by Sol-Gel Method at Room Temperature

Nanoscale SiO₂-TiO₂ composite thin films with the thickness of about 100 nm were prepared by sol-gel method at room temperature in air. The chemical states of the elements on the surface and near the surface were measured by XPS. The results showed that the Ti on/near the surface of the thin films existed not only as TiO₂ but also as Ti₂O₃. Part of the TiO₂ was changed to Ti₂O₃ after UV irradiation. The crystalline structure of the TiO₂ in the SiO₂-TiO₂ thin films was anatase with the crystallite size of 14–20 nm. It was found that the thin film prepared at room temperature in air has good superhydrophilic property and has strong adherence to the substrate.     

Quantitative Depth Profiling of K-Doped Fullerene Films Using XPS and SIMS

 Phenomena accompanying electrochemical doping of solid fullerene films with potassium were studied by sputter ion depth profiling (XPS and SIMS). The potassium distribution was determined, and artifacts associated with possible damage of the layer composition caused by ion impact were investigated and discussed. To compare the charge transfer while reductive doping is taking place at fullerene/solution interface with doping from gas phase, model layers were prepared and doped by potassium under UHV conditions. It was found that sputtering by Ar⁺ primary ions yields both accurate information on the alkaline metal distribution and on its concentration. Sputtering by O⁺ ions led to an enrichment of potassium, apparently due to the reactivity of oxygen with the fullerene matrix. It is shown that the reductive doping starts at the fullerene/solution interface. The concentration of potassium in the doped films was found to be lower than expected from the charge transferred during the electrochemical reduction. Other phase transformations such as hydrogenation are discussed. Received March 4, 2002; accepted July 26, 2002     

Electron attenuation lengths in fullerene and fullerides

Using X-ray photoemission measurements, we have determined the attenuation length of C 1s photoelectrons in C₆₀ film to be 21.5 Å with the incident photon energy of Mg Kα radiation. The inelastic mean free path calculated with the TPP-2M algorithm coincides fairly well with the experimentally determined attenuation length, indicating the validity of the algorithm to fullerene and fullerides. The inelastic mean free paths for some fullerides, i.e. K₃C₆₀, K₆C₆₀, Ba₄C₆₀, Sm_2.75C₆₀ and Sm₆C₆₀ are calculated to help the quantitative analyses of the photoemission spectra for these compounds.     

Electronic structure of Ti metal and TiO2 powder studied by hard and soft (Cu Kα1 and Al Kα1) X-ray photoelectron and Auger spectroscopy

High-energy X-ray photoelectron spectroscopy (XPS) is of particular importance for minimizing the effects of surface contamination by increasing photoelectron escape depths. In this study high-resolution high-energy Cu Kα₁ and soft Al Kα₁ XPS and Auger electron spectroscopy were used to compare the electronic structure of Ti in TiO₂ powder and Ti metal. The Ti 1s in TiO₂ XPS line is narrower and more symmetric than in Ti metal. A comparison of the relative intensities of the L₂₃M₂₃M₄₅ and L₂₃M₂₃M₂₃ Auger transitions in Ti metal and TiO₂ is consistent with the expected transfer of Ti 3d electrons away from the Ti site in the oxide. The satellites accompanying the Ti 1s XPS line excited by Cu Kα₁ X-rays occur at the same energies as the satellites accompanying the Ti 2s and 2p XPS lines excited by Al Kα₁ X-rays indicating that they do not depend on the core-level, the experimental resolution or inelastic scattering processes.     

Characterization of iron surface modified by 2-mercaptobenzothiazole self-assembled monolayers

A self-assembled monolayer of 2-mercaptobenzothiazole (MBT) adsorbed on the iron surface was prepared. The films were characterized by electrochemical impedance spectroscopy (EIS), X-ray photoelectron spectroscopy (XPS), Fourier transform infrared reflection spectroscopy (FT-IR) and scanning electron microscopy (SEM). Besides, the microcalorimetry method was utilized to study the self-assembled process on iron surface and the adsorption mechanism was discussed from the power-time curve. The results indicated that MBT was able to form a film spontaneously on iron surface and the presence of it could protect iron from corrosion effectively. However, the assembling time and the concentration influence the protection efficiency. Quantum chemical calculations, according to which adsorption mechanism was discussed, could explain the experimental results to some extent.     

Photoelectron spectroscopic study of Li oxides on Li over-deposited V2O5 thin film surfaces

The Li oxides species formed on Li over-deposited V₂O₅ thin film surfaces have been studied by using X-ray and UV induced photoelectron spectroscopy (XPS and UPS). The photoelectron spectroscopic data show that the Li over-deposited V₂O₅ system itself is not stable. Further chemical decomposition reactions are taken place even under UHV conditions and lead to form Li₂O and Li₂O₂ compounds on the surface. The formation of Li₂O₂ causes to arise an emission line at about 11.3 eV in the valence band spectra.     

Mathematical topographical correction of XPS images using multivariate statistical methods

For rough heterogeneous samples, the contrast observed in XPS images may result from both changes in elemental or chemical composition and sample topography. Background image acquisition and subtraction are frequently utilized to minimize topographical effects so that images represent concentration variations in the sample. This procedure may significantly increase the data acquisition time. Multivariate statistical methods can assist in resolving topographical and chemical information from multispectral XPS images. Principal component analysis (PCA) is one method for identification of the highest correlation/variation between the images. Topography, which is common to all of the images, will be resolved in the first most significant component. The score of this component contains spatial information about the topography of the surface, whereas the loading is a quantitative representation of the topography contribution to each elemental/chemical image. The simple‐to‐use self‐modelling mixture analysis (Simplisma) method is a pure variable method that searches for the source of most differences in the data and therefore has the potential to distinguish between chemical and topographical phases in images. The mathematical background correction scheme is developed and validated by comparing results to the experimental background correction for samples with differing degrees of topography. Copyright © 2004 John Wiley & Sons, Ltd.     

Metallic nanoparticles on plasma treated carbon nanotubes: Nanohybrids

Multi-wall carbon nanotubes (MWCNTs) were decorated with metal clusters by thermal evaporation. Transmission electron microscopy (TEM) shows that the nature and extent of metal coverage can be varied by plasma treating the MWCNT surface. The metal clusters on oxygen plasma treated arc-discharge MWCNTs have a more dense distribution than the clusters evaporated on as-synthesized arc-discharge MWCNTs. In contrast, the plasma treatment did not affect the cluster distribution on CVD MWCNTs. Analyses of the valence band and the core levels by X-ray photoelectron spectroscopy suggest poor charge transfer between gold clusters and MWCNTs; on the contrary suggest good charge transfer between Ni clusters and MWCNTs.