Lipid-soluble and water-soluble arsenic compounds in blubber of ringed seal (Pusa hispida)

High concentrations of arsenic were observed in the blubber of ringed seals (Pusa hispida) in our previous study. To better understand the arsenic accumulation in blubber of marine mammals, arsenicals in the blubber of ringed seal were characterized using high performance liquid chromatography–inductively coupled plasma mass spectrometry (HPLC–ICPMS). The most predominant water-soluble arsenical in the blubber was dimethylarsinic acid (DMA), in spite of the predominance of arsenobetaine in other tissues. Lipid-soluble fraction was hydrolyzed under mild (tetraethylammonium hydroxide (TEAH) hydrolysis) and strong (NaOH hydrolysis) conditions, and then an aliquot of hydrolysate was injected onto HPLC–ICPMS. Both TEAH-labile and TEAH-stable/NaOH-labile lipid-soluble fractions contained precursors of DMA. These results suggest that the blubber might be the pool of DMA and DMA-containing precursors in ringed seals.     

Development and application of a simple routine method for the determination of selenium in serum by octopole reaction system ICPMS

The aim of the study was to develop an inductively coupled plasma mass spectrometry (ICPMS) method for robust and simple routine determination of selenium in serum. Polyatomic interferences on ⁷⁶Se, ⁷⁷Se, and ⁷⁸Se were removed by applying an octopole reaction system ICPMS with the reaction cell pressurized with H₂ gas. We developed a novel simple optimization routine for the H₂ gas flow based on a signal-to-noise ratio (SNR) calculation of the selenium signal measured in a single selenium standard. The optimum H₂ flow was 2.9 mL min^–1. The selenium content in serum was determined after a 50-fold dilution with 0.16 M HNO₃ and quantified by using addition calibration and gallium as an internal standard. The method detection limit was 0.10 g L^–1 for ⁷⁶Se and ⁷⁸Se and 0.13 g L^–1 for ⁷⁷Se. Human serum samples from a case-control study investigating if selenium was associated with risk of colorectal adenoma were analyzed. The average selenium concentration for the control group (n=768) was 137.1 g L^–1 and the range was 73.4–305.5 g L^–1. The within-batch repeatability (a batch is ten samples) estimated from 182 replicate analyses was 6.3% coefficient of variation (CV), whereas the between-batch repeatability was 7.4% CV estimated from 361 replicates between batches. The method accuracy was evaluated by analysis of a human serum certified reference material (Seronorm Serum level II, Sero A/S, Norway). There was a fairly good agreement between the measured average of 145±3 g L^–1 (n=36) and the certified value of 136±9 g L^–1. In addition the method was successfully applied for analysis of zinc serum concentrations without further optimization. For the Seronorm certified reference material a value of 911±75 g L^–1 (n=31) for zinc was obtained, which corresponds well to the certified zinc value of 920±60 g L^–1.     

Direct determination of δ44/42Ca isotope ratio by ion chromatography/low‐resolution multicollector ICPMS

High‐precision on‐line procedure for measurement of calcium isotopic ratio by coupling ion chromatography to multicollector inductively coupled plasma mass spectrometry was developed. Calcium separation from the sample matrix was achieved on an ion chromatography column—IonPac CS16—ID 3 mm connected with CERS 500 2 mm suppressor and followed by multicollector inductively coupled plasma mass spectrometry calcium isotopic ratio determination. Dry plasma mode was used with Aridus II desolvation system. To sustained samples with high level of total dissolved salts as well as account capacity of applied analytical column, the method has been optimized regarding calcium isotope ratio measurements with low‐resolution mass spectrometry. Mass discrimination and instrument drift were corrected by sample‐standard bracketing method using the ⁴⁴Ca/⁴²Ca isotope ratio of SRM 915a as a standard. Good accuracy and reasonable precision of calcium isotope ratio (generally 0.20‰ [2SD]) were achieved, which are comparable to off‐line Ca separation and continuous measurement. The reproducibility of the proposed analytical procedure was verified by measuring the SRM 915a standard as a sample randomly over 3 months (n = 56). Applicability of the protocol was demonstrated for matrix‐rich natural water samples, coral samples, and bone standard reference materials.     

Optimisation of ICPMS collision/reaction cell conditions for the simultaneous removal of argon based interferences of arsenic and selenium in water samples

The optimisation of ICPMS collision/reaction cell conditions for the simultaneous analysis of arsenic and selenium is described. A mixture of 3.8 mL min⁻¹ of H₂ and 0.5 mL min⁻¹ of He was found to be suitable for the removal of both ArAr⁺ and ArCl⁺ interferences. Detection limits down to 30 ng (element) L⁻¹ in total analysis, and between 81 and 230 ng (element) L⁻¹ in speciation analysis were achieved in chloride matrix (1 g L⁻¹ NaCl). After validation, the method was applied to commercially available mineral waters.     

Determination of cadmium in grains by isotope dilution ICP–MS and coprecipitation using sample constituents as carrier precipitants

A coprecipitation method using sample constituents as carrier precipitants was developed that can remove molybdenum, which interferes with the determination of cadmium in grain samples via isotope dilution inductively coupled plasma mass spectrometry (ID-ICPMS). Samples were digested with HNO₃, HF, and HClO₄, and then purified 6 M sodium hydroxide solution was added to generate colloidal hydrolysis compounds, mainly magnesium hydroxide. Cadmium can be effectively separated from molybdenum because the cadmium forms hydroxides and adsorbs onto and/or is occluded in the colloid, while the molybdenum does not form hydroxides or adsorb onto the hydrolysis colloid. The colloid was separated by centrifugation and then dissolved with 0.2 M HNO₃ solution to recover the cadmium. The recovery of Cd achieved using the coprecipitation was >97%, and the removal efficiency of Mo was approximately 99.9%. An extremely low procedural blank (below the detection limit of ICPMS) was achieved by purifying the 6 M sodium hydroxide solution via Mg coprecipitation using Mg(NO₃)₂ solution. The proposed method was applied to two certified reference materials (NIST SRM 1567a wheat flour and SRM 1568a rice flour) and CCQM-P64 soybean powder. Good analytical results with small uncertainties were obtained for all samples. This method is simple and reliable for the determination of Cd in grain samples by ID-ICPMS. Figure Overview of a coprecipitation method using sample constituents     

封闭压力酸溶-ICP-MS法分析地质样品中47个元素的评价

对封闭压力酸溶－ICP－MS法同时测定地质样品中47个元素的效果和适用范围进行了实测评价。并对溶样条件进行了优化。实验结果表明，HF－HNO3高温高压酸溶是一种有效的样品分解方法，在所测定的47个元素中，大部分元素如Li,Be,Ti,V,Mn,Co,Ni,Cu,Zn,As,Zr,Nb,Mo,Cd,In,Sn,Sb,Hf,Ta,W,Tl,Pb,Bi等在大多数标样中在三种取样量下都可以得到满意的回收率。而Sc,Cr,Ga,Y,REE,Rb,Cs,Sr,Ba,Th,U等元素在大部分样品中则随取样量减少，回收率上升，在一些样品中，当取样量降至25mg时，可以获得满意的回收率。用王水代替HNO3复溶残渣，利用氯离子的络合作用促进复溶，使许多元素的回收率有了明显的提高。     

Speciation of arsenic by ion chromatography inductively coupled plasma mass spectrometry using ammonium eluents

A method based on ion chromatography (IC) and inductively coupled plasma MS (ICP-MS) was developed for the speciation of arsenic in water and soil extracts. An anion-exchange column (G3154A/101) was used to separate As(III), As(V), dimethylarsinic acid (DMA), and monomethylarsonic acid (MMA) with excellent resolution. Various ammonium salts, including NH4H2PO4, (NH4)2HPO4, (NH4)2CO3, and NH4HCO3, were examined as eluents to reduce matrix interference from chloride and to solve clogging problems. The best arsenic speciation was obtained within 9 min with excellent resolution and without interference from high chloride concentrations using an eluent containing 7.5 mM (NH4)2HPO4 at pH 7.9. The detection limits for the target arsenic species ranged from 0.1 to 0.4 microg/L with direct injection of sample without matrix elimination. The proposed method was effectively demonstrated by determining arsenic species in contaminated waters and soils of Bangladesh.     

Determination of selenium in sediment by isotope-dilution inductively coupled plasma mass spectrometry with an octapole reaction cell

A method is described for determination of selenium in sediment by isotope-dilution inductively coupled plasma mass spectrometry with an octapole reaction cell (ID–ICP–ORCMS). Sediment samples were digested with HNO₃, HClO₄, and HF, and the digestion included an elaborate evaporation process to remove bromine from the digested solution. Simple strong cation-exchange disk filtration was used to remove rare earth elements (REE) from the digested solution, because REE²⁺ seriously interfere with Se isotopes (i.e. ¹⁵⁶Gd²⁺ with ⁷⁸Se⁺, ¹⁶⁰Gd²⁺ with ⁸⁰Se⁺). Addition of acetic acid to the filtrate was examined to improve the sensitivity of ICP–ORCMS measurement of Se⁺ by means of a carbon-enhancement effect. The interfering for selenium isotopes were almost eliminated by use of H₂ as reaction gas. Interference from BrH⁺ formed in the reaction cell was negligible because the Br was removed in the evaporation process. Approximately 99.5% of REE were removed by cation-exchange disk filtration yet more than 99% of Se remained in the filtrate solution. The intensity for Se⁺ was enhanced approximately fourfold by addition of 5% (v/v) of acetic acid whereas that for was barely enhanced. Measured ⁸⁰Se/⁷⁸Se ratios in unspiked digested solutions of the sample were in good agreement with that for an Se standard solution. The analytical results for Se in the certified reference materials MESS-3 and PACS-1 were in good agreement with their certified values, with small uncertainties.      

Development and application of an ultratrace method for speciation of organotin compounds in cryogenically archived and homogenized biological materials

An accurate, ultra-sensitive and robust method for speciation of mono, di, and tributyltin (MBT, DBT, and TBT) by speciated isotope-dilution gas chromatography-inductively coupled plasma-mass spectrometry (SID-GC-ICPMS) has been developed for quantification of butyltin concentrations in cryogenic biological materials maintained in an uninterrupted cryo-chain from storage conditions through homogenization and bottling. The method significantly reduces the detection limits, to the low pg g(-1) level (as Sn), and was validated by using the European reference material (ERM) CE477, mussel tissue, produced by the Institute for Reference Materials and Measurements. It was applied to three different cryogenic biological materials-a fresh-frozen mussel tissue (SRM 1974b) together with complex materials, a protein-rich material (whale liver control material, QC03LH03), and a lipid-rich material (whale blubber, SRM 1945) containing up to 72% lipids. The commutability between frozen and freeze-dried materials with regard to spike equilibration/interaction, extraction efficiency, and the absence of detectable transformations was carefully investigated by applying complementary methods and by varying extraction conditions and spiking strategies. The inter-method results enabled assignment of reference concentrations of butyltins in cryogenic SRMs and control materials for the first time. The reference concentrations of MBT, DBT, and TBT in SRM 1974b were 0.92 +/- 0.06, 2.7 +/- 0.4, and 6.58 +/- 0.19 ng g(-1) as Sn (wet-mass), respectively; in SRM 1945 they were 0.38 +/- 0.06, 1.19 +/- 0.26, and 3.55 +/- 0.44 ng g(-1), respectively, as Sn (wet-mass). In QC03LH03, DBT and TBT concentrations were 30.0 +/- 2.7 and 2.26 +/- 0.38 ng g(-1) as Sn (wet-mass). The concentration range of butyltins in these materials is one to three orders of magnitude lower than in ERM CE477. This study demonstrated that cryogenically processed and stored biological materials are a promising alternative to conventional freeze-dried materials for organotin speciation analysis, because these are, at present, the best conditions for minimizing degradation of thermolabile species and for long-term archival. Finally, the potential of the analytical method was illustrated by analysis of polar bear (Ursus maritimus) and beluga whale (Delphinapterus leuca) liver samples that had been collected in the Arctic and archived at the Marine Environmental Specimen Bank. Significant concentrations of butyltin compounds were found in the samples and provide the first evidence of the presence of this class of contaminant in the Arctic marine ecosystem. Figure Eye catch image.     

H,C, N and S stable isotopes and mineral profiles to objectively guarantee the authenticity of grated hard cheeses

In compliance with the European law (EC No. 510/2006), geographical indications and designations of origin for agricultural products and foodstuffs must be protected against mislabelling. This is particularly important for PDO hard cheeses, as Parmigiano Reggiano, that can cost up to the double of the no-PDO competitors.