Effect of the Parameters of Three-Mirror Resonators on the Spectral Characteristics of Single-Pulse Laser Generation with Self-Injection of Priming Radiation

Based on a semiclassical theory, investigations were made of the dynamics and spectral composition of pulsed generation with self-injection of priming radiation from the active part of a three-mirror linear resonator, the passive part of which contains an active loss modulator and serves as the output reflector of the laser. It is shown that there exists a range of resonator parameters at which pulsed lasing has virtually a single frequency irrespective of the detuning of the frequencies of the priming radiation and of the nearest eigenmode of the composite resonator. Considering graphically the phase conditions of generation, it is established that among pulsed lasers with self-injection of priming radiation which are constructed on the basis of three-mirror linear and branched resonators, the most efficient for creating single-frequency generation are those in which the length of the main resonator, where generation of the pulse occurs, is larger than the length of the additional one intended for forming the priming radiation. With an inverse ratio of the lengths of the resonators, the conditions of single-frequency pulsed generation becomes dependent on the priming radiation frequency.     

空心阴极灯激发的微波等离子体炬原子/离子荧光光谱研究--钙的原子/离子荧光光谱

用强短脉冲供电技术的空心阴极灯作激发源、微波等离子体炬作原子／离子化器，建立了原子／离子荧光光谱实验装置。详细研究了微波等离子体功率、观察高度、空心阴极灯电流等因素对原子／离子荧光信号强度的影响，测量了系统对Ca的原子／离子荧光光谱的检出限。     

平面火花隙三电极开关研制及性能测试

 研制了一种适用于平行板传输连接的平面火花隙三电极开关，开关正负电极为半圆形状，触发电极为细条状。将之替代立体式（半球形电极）火花隙三电极开关并应用于爆炸箔起爆装置中，装置回路参数将得以优化。实验测试了空气间隙为4.12， 3.14和2.2 mm的平面火花隙三电极开关的性能。结果表明，在开关间隙间距一定的情况下，随着电压的升高，开关间隙的放电时延和分散时间呈指数降低，开关电感小于15 nH；对于不同范围内的应用电压，使用不同间隙间距的开关，其分散时间不大于10 ns。该开关应用于较低充电电压（小于10 kV）的脉冲功率装置中，与立体式火花隙三电极开关相比，回路电感降低了约50 nH，放电周期缩短近1/3，峰值电流增加约1/3。     

强流脉冲离子束辐照靶及其喷发的数值研究

利用拟合实测的TEMP Ⅱ型加速器磁绝缘二极管(MID)电压波形及其焦点附近束流密度曲线，建立了Gaussian分布模型，据此计算了与靶作用的离子的能量及数量，采用Monte Carlo(MC)方法计算了沉积在靶内的能量.并以此作为热源，与流体动力学(HD)模型相结合，对不同的靶状态采用相应的状态方程，模拟计算了靶内压力演化情况; 同时对烧蚀产生的等离子体采用理想气体状态方程, 结合HD方程组, 模拟计算了喷发过程中压力的空间演化过程. 关键词： 强流脉冲离子束 Gaussian模型 HD方程 数值研究     

基于3×3平行排列耦合器的全光光开关的特性分析

提出了一种新型的基于3×3平行排列耦合器的全光光开关。此种光开关具有两个独立的输出端口且具有极好的偏振稳定性,消光比可达20dB。介绍了其工作原理,详细分析了信号光强度、控制光强度、光纤长度及耦合器分光比偏差等因素对各端口消光比的影响。比较了不同种类和长度光纤环的开关性能,首次得到了耦合器分光比偏差对消光比的影响曲线。     

贝塞尔-高斯脉冲光束在色散介质中的时间和光谱特性

 对等衍射长度贝塞尔-高斯脉冲光束在色散介质中的时间和光谱特性作了研究，结果表明，通过选择适当的空间参数，贝塞尔-高斯脉冲光束沿轴上传输时，脉冲宽度不变。传输距离小于无衍射长度时，随衍射角增加，功率谱形状未变，脉冲波形保持不变；传输距离大于无衍射长度时，随衍射角增加，光谱由蓝移变为红移，脉冲展宽。     

Spectral shifts and spectral switches in diffraction of ultrashort pulsed beams passing through a circular aperture

Based on the Fourier transform method, a simple closed-form expression for the on-axis power spectrum of ultrashort Gaussian pulsed beams in diffraction at a circular aperture is derived, which permits us to study spectral changes both analytically and numerically. It is shown that for diffracted pulsed beams there exist spectral red and blue shifts, spectral narrowing, and spectral switches in the near field. The aperture diffraction plays an important role in spectral switching, but both the truncation parameter and bandwidth (or equally, Fourier transform limited pulse duration) affect the behavior of spectral switches.     

Photorefractive Four-Wave Mixing Switches Utilizing Pockels Effect -Longitudinal and Lateral Switches-

We carried out detailed calculations for photorefractive wave-mixing switches based on one of three crystals with high electro-optic coefficients, namely, BaTiO₃, Strontium Barium Niobate (SBN (0.75)), and Potasium Sodium Strontium Barium Niobate (KNSBN). A comparison of results for the three crystals shows that a 0_-cut BaTiO³ crystal is suitable for a longitudinal switch and requires a voltage of about 80 for a 2-mm-thick crystal to induce sufficient phase mismatch. The electrodes must be transparent for the incident and diffracted beams. A 45_-cut SBN (0.75) crystal, however, is suitable for a lateral switch and requires a voltage of about 150 for a 1-mm-wide crystal. The electrodes do not need to be transparent.     

密封容器中后处理制备Tl2Ba2CaCu2Oy高温超导薄膜及其性能研究

以铝酸镧（001）单晶为基片，采用两步法制备Tl2Ba2CaCu2Oy（Tl 2212）高 温超导薄膜.首先，利用脉冲激光沉积（PLD）工艺沉积Ba2CaCu2Ox非晶前驱体薄膜；然后，前驱体薄膜在高温（720—850℃）下密封钢容器里铊化结晶形成Tl 2212薄膜.XRD结果表明Tl2212 薄膜是沿c轴方向生长的，其相组成为Tl 2212，摇摆曲线（0012）的半高宽为0.72° ，SEM图像显示其表面光滑平整，其零电阻温度为106.2K. 关键词： Tl 2212超导薄膜 脉冲激光沉积     

激光限制结晶技术制备nc-Si/SiO2多层膜

在等离子体增强化学气相淀积系统中，采用aSi:H层淀积和原位等离子体氧化相结合的逐层生长技术制备了aSi:H/SiO_2多层膜.在激光诱导限制结晶原理基础上，使用KrF准分子脉冲激光为辐照源，对aSi:H/SiO_2多层膜进行辐照，使纳米级厚度的aSi:H子层晶化.Raman散射谱和电子衍射谱的结果表明，经过激光辐照后纳米Si颗粒在原始的aSi:H子层内形成，晶粒尺寸可以根据aSi:H层的厚度精确控制.还研究了样品的光致发光（PL）特性以及激光辐照能量密度对PL性质的影响. 关键词： 脉冲激光 多层膜 限制结晶