氧化铝/氮化硅双层膜晶硅钝化的开尔文探针力显微镜研究

对晶体硅(c-Si)太阳能电池而言, 氧化铝(AlOx)是一种广泛使用的钝化材料, 因为它具有优异的沉积保形性和良好的钝化质量. 为了确保AlOx发挥其良好的钝化效果, 在沉积后退火并氢化处理是必不可少的. 通过在AlOx薄膜上沉积氢化氮化硅(SiNx:H)来实现氢化, 利用开尔文探针力显微镜研究了在不同热处理和氢化作用下, AlOx/SiNx:H双层薄膜功函数的变化, 并基于沉积薄膜所含氢与固定电荷展开了讨论. 发现钝化质量和功函数之间有相关性, 影响因素包括薄膜厚度、氢化与热处理顺序.     

Te溶剂Bridgman法CdMnTe晶体核辐射探测器的制备和表征

碲锰镉(CdMnTe)作为性能优异的室温核辐射探测器材料,可用于环境监测和工业无损检测领域。本文中采用Te溶剂Bridgman法生长In掺杂Cd_0.9Mn_0.1Te晶体,制备成10 mm×10 mm×2 mm大小的室温单平面探测器,研究了该探测器对²⁴¹Am@59.5 keV γ射线源的能谱响应。通过表征红外透过率、电阻率以及探测器能谱响应等参数,综合评定了探测器用CdMnTe晶体的质量、电学和探测器性能。结果表明,晶片的红外透过率均在55%以上,最好可达到60%。采用湿法钝化,100 V偏压下的漏电流由钝化前的9.48 nA降为钝化后的7.90 nA,钝化后的电阻率为2.832×10¹⁰ Ω·cm。在-400 V反向偏压下,CdMnTe探测器对²⁴¹Am@59.5 keV γ射线源的能量分辨率在钝化前后分别为13.53%和12.51%,钝化后的电子迁移率寿命积为1.049×10^-3 cm²/V。研究了探测器的能量分辨率随电压的变化特性,当偏压≤400 V时,探测器的能量分辨率主要由载流子的收集效率决定,而当偏压>400 V时,能量分辨率由漏电流决定。本文研究结果表明,Te溶剂Bridgman法生长的CdMnTe晶体质量较好,电阻率和电子迁移率寿命积满足探测器制备需求。     

Surface passivation in n-type silicon and its application in silicon drift detector

Based on the surface passivation of n-type silicon in a silicon drift detector(SDD), we propose a new passivation structure of SiO2/Al2O3/SiO2 passivation stacks. Since the SiO2 formed by the nitric-acid-oxidation-of-silicon(NAOS)method has good compactness and simple process, the first layer film is formed by the NAOS method. The Al2O3 film is also introduced into the passivation stacks owing to exceptional advantages such as good interface characteristic and simple process. In addition, for requirements of thickness and deposition temperature, the third layer of the SiO2 film is deposited by plasma enhanced chemical vapor deposition(PECVD). The deposition of the SiO2 film by PECVD is a low-temperature process and has a high deposition rate, which causes little damage to the device and makes the SiO2 film very suitable for serving as the third passivation layer. The passivation approach of stacks can saturate dangling bonds at the interface between stacks and the silicon substrate, and provide positive charge to optimize the field passivation of the n-type substrate.The passivation method ultimately achieves a good combination of chemical and field passivations. Experimental results show that with the passivation structure of SiO2/Al2O3/SiO2, the final minority carrier lifetime reaches 5223 μs at injection of 5×10¹⁵ cm^-3. When it is applied to the passivation of SDD, the leakage current is reduced to the order of nA.     

Inhibition of the reduction of Cr(VI) at the magnetite–water interface by calcium carbonate coatings

The effect of calcium carbonate coatings on the reduction of aqueous chromate on the magnetite(1 1 1) surface has been investigated using a combination of synchrotron based X-ray photoemission spectroscopy (PES) and X-ray absorption near edge structure (XANES) spectroscopy, along with laboratory-based powder X-ray diffraction (XRD) and scanning electron microscopy (SEM). CaCO₃ coatings (dominantly calcite with minor quantities of aragonite and vaterite) of thicknesses ranging from 10 Å to 20 m were grown on magnetite(1 1 1) surfaces by exposure to supersaturated aqueous solutions followed by evaporation of the solution—a process that mimics pore-water evaporation in vadose zones leading to the formation of caliche and calcium carbonate coatings on mineral grains. Coating thicknesses were determined from attenuation of the Fe 2p photoemission signal by the carbonate coating. For coatings less than 15 Å thick, Cr 2p photoemission and Cr L_II, L_III-edge XANES spectra show that chromate is reduced by the underlying magnetite surface; however, as the minimum coating thickness increases beyond 15 Å, the magnetite surface becomes passivated and further chromate reduction ceases. Our findings suggest that carbonate coatings on natural magnetite grains can significantly reduce or eliminate their ability to reduce Cr(VI), which is a toxic and highly mobile environmental contaminant.     

氢对GaAs薄膜的钝化作用

报导了射频磁控溅射与沉积气氛掺氢相结合制备单层(13~20 nm厚)高质量GaAs多晶态纳米薄膜的方法,研究了氢钝化对薄膜微观结构及光学性质的影响.对GaAs薄膜进行了X射线衍射、原子力显微镜、吸收光谱、光致荧光谱的研究分析.结果表明,衬底温度500℃的掺氢薄膜和520℃的薄膜呈面心立方闪锌矿结构，薄膜的晶团尺寸较大，微观表面较为粗糙，其吸收光谱出现了吸收边蓝移和明显的激子峰，带隙光致荧光峰强明显增加，说明氢在衬底温度500℃~520℃下对薄膜有重要的钝化作用.     

载波钝化和钼酸盐后处理对不锈钢钝化膜性能的影响

一般认为交流电对金属的腐蚀过程具有加速作用,但我们发现,在直流电位基础上叠加适当波形、幅值和频率的交流电对不锈钢进行载波钝化,尔后再进行适当后处理可使钝化膜的稳定性提高,我们曾就不经后处理的载波钝化过程进行过探讨,本文着重探讨钼酸盐后处理对载波钝化膜表面状态和化学稳定性改善的作用机理。     

Adsorptive passivation of iron by organic acid anions

Studies on the iron passivation by organic acid anions in aqueous solutions are briefly reviewed. It is shown that the passivation can be caused only by their adsorption, retarding both the iron dissolution and the formation of oxide films. Earlier, it had been believed that oxide films play a dominant role in the iron passivation in neutral solutions. The recent viewpoint is that such nonoxide iron passivation can occur in solutions of salts of not only aromatic amino acids (sodium phenylantranilate and its substitutes), but other carboxylic acids as well. An important role of chemisorption and hydrophobic properties of anions for the formation of adsorption passive films is emphasized. New possibilities for inhibitor protection of iron against corrosion, which is based on adsorptive passivation, are pointed out.Translated from Elektrokhimiya, Vol. 40, No. 12, 2004, pp. 1503–1507.Original Russian Text Copyright © 2004 by Kuznetsov.     

非晶态Fe－W合金镀层的表面改性

将Ｆｅ－Ｗ非晶态镀层在铬酸盐钝化液中进行化学钝化与电化学钝化，使之形成含铬钝化膜。阳极极化曲线说明，钝化后镀层的孔蚀电位向正向移动了约１．６８Ｖ；Ｆｅ－Ｗ非晶镀层在氯化钠溶液中浸泡近１ｈ表面发生严重腐蚀，而经钝化处理的镀层浸泡１个月，表面无变化，仍具有金属光泽。     

Keggin型杂多酸在镀锌钝化中的应用

比较了H_4SiMo_(12)O_(40)、H_3PW_(12)O_(40)、H_4SiW_(12)O_(40)、H_3PMo_(12)O_(40)及铬酸盐对镀锌层钝化效果。H_3PMo_(12)O_(40)钝化的最佳条件为:H_3PMo_(12)O_(40)5g/L,pH 1.1,钝化时间35秒,温度15℃,空留时间10秒,封闭温度100℃(水)。经扫描电镜、XPS、AES、IR和Raman光谱等测定,表明在锌表面形成了一种含有P、Mo、O及Zn的耐蚀性膜。其中钼以Mo(Ⅵ)、Mo(Ⅴ)和Mo(Ⅳ)存在,P/Mo比为1:3.0。推测锌表面形成了一种形如Zn_x(PMo_3)_rO_z/ZnO/Zn的复杂钝化膜。     

流动注射区域采样法测定镀锌钝化液中高浓度锌

本文建立了流动注射二甲酚橙光度法测定镀锌纯化液中Ｚｎ￣２＋的自动分析方法。利用区域采样技术和调整管路参数自动完成对样品的上千倍稀释，确定了最佳分析条件并研究了干扰离子的影响及消除办法。所建方法仪器简单，分析速度为８４次／小时，变异系数（Ｚｎ￣２＋１６．０ｇ／Ｌ，ｎ＝２０）为１．Ｏ％，用于实际钝化液分析，相对误差小于±１０％。