纳米结构TiO2／SiO2的逐层自组装

采用逐层自组装方法在二氧化硅球表面交替组装了十二烷基硫酸钠单分子膜和 二氧化钛纳米粒子膜，该复合多层膜经高温假烧后得到了核壳型纳米结构二氧化钛 ／二氧化硅复合颗粒．利用XRD，SEM，X射线能谱等对复合颗粒进行了表征．结果 表明：二氧化肽在复合颗粒表面排列紧密、均匀，粒径在50nm左右，为锐钛矿型结 构．复合颗粒中二氧化肽的含量随组装层数的增加而均匀增加．     

MeOH-H~2O-NaOAc体系(278.2~318.2K)的电导研究

本文测定了278.2~318.2K间的五个温度下七种浓度的NaOAc分别在10, 20,30, 40, 50, 60, 70, 80, 90及100%MeOH-H~2O体系中的摩尔电导Λ, 并应用FOS,Pitts, L-W, F-78等四个电导方程对实验数据进行了拟合处理, 得到了三个拟合参数Λ~O, K~Λ及R(或α)。最后, 对四个方程与实验的吻合程度, 温度、溶剂组成等对Λ~O、K~Λ的影响规律及溶质-溶剂相互作用进行了讨论。     

Structural and photocatalytic properties of the new solid photocatalyst In2BiTaO7

In₂BiTaO₇ was synthesized using the solid-state reaction method and its photocatalytic properties were investigated. The results of powder X-ray diffraction (XRD) indicated that the compound crystallizes in the pyrochlore-type structure, cubic system with space group Fd-3m. The lattice parameter is 10.6972(1) ?. In addition, the compound shows strong optical absorption in the visible region (λ > 420 nm) and the band gap of In₂BiTaO₇ was estimated to be about 2.47 eV. For the photocatalytic reaction, H₂ or O₂ evolution was observed from CH₃OH/H₂O or AgNO₃ solution respectively with In₂BiTaO₇ as the photocatalyst under visible light irradiation, indicating that In₂BiTaO₇ is responsive to visible light for splitting water. Furthermore, the catalyst remained photoactive in the wavelength range up to 510 nm. Photocatalytic degradation of methylene blue (MB) dye over the compound was further investigated under visible light irradiation. The results showed that complete removal of aqueous MB could be achieved after irradiation for 135 min over In₂BiTaO₇. Furthermore, under visible light irradiation In₂BiTaO₇ showed markedly higher catalytic activity compared to P-25 for MB photocatalytic degradation.     

Drastic change of rheological behaviour of Precipitated Calcium Carbonate (PCC) formulations induced by water sorption onto mineral filler surface

The water sorption properties of Precipitated Calcium Carbonate (PCC) formulations have been studied in relation to the rheological behaviour. Uncoated mineral fillers (median diameter 0.85 μm) have been dispersed in an organic liquid used as plasticizer, a dioctylphthalate (DOP), at a concentration of 25% by weight (volume fraction of about 11%). Water sorption isotherms onto PCC in air and in the organic matrix have been constructed. Measurement of water concentration in the DOP permits a complete evaluation of water exchanges at the inorganic (mineral)/organic (plasticizer) interface. Evolutions of yield stress, storage modulus and loss modulus have been determined as functions of the water activity in the system. A drastic change of rheological properties has been observed for water activities above 0.3.     

Sorption characteristics of water,oil and diesel in cellulose nanofiber reinforced corn starch resin/ramie fabric composites

Nowadays, utilisation of biodegradable materials has become necessary in order to maintain global environmental and ecological balance. Fully biodegradable nano 'Green' textile composites have been prepared from cellulose nanofibers reinforced corn starch resin and ramie fabric. Nanofibers having dimensions of approximately 1 μm long and 20–30 nm in diameter are used in the study. The nanofibers were incorporated in corn starch resin via ball mill mixing using ceramic balls. Textile composites were fabricated by pasting the reinforced resin onto the ramie fabric and by hot compression molding technique. Interactions at the fiber–matrix interface and the compatibility between cellulose and corn starch resin molecules will affect the properties of the system. The well dispersed cellulose nanofibers contribute higher interfacial area and good fiber networking within the matrix resin. This will lead to better barrier properties. Sorption characteristics of water, oil and diesel in the textile composites were analysed and the influence of nano fibers and macro fibers on the transport phenomena was investigated. The kinetics of sorption-diffusion process was investigated. Kinetic parameters such as n, k, diffusion coefficient, permeability, solubility parameter, % swelling index, etc., were analysed. The presence of cellulose nanofibers influences the sorption mechanism. The water sorption mechanism in the nanocomposites was found to exhibit slight deviation from Fickian mode. Structure–property relationships of the nanocomposites were evaluated.     

LaI3.6C11H12ON2的合成和表征

用溶解度等温法研究了LaI3-C11H12ON2(安替比林)-H2O三元体系在0℃时的相平衡,体系中有组成为LaI3.6C11H12ON2的二元复合物生成。本文还确定了该复合物的制备条件,测定了它的一些性质,并对其结构作了初步分析。     

苯甲酸在水-乙醇混合物溶剂中的电离焓

本文测定了苯甲酸在水-乙醇混合溶剂中的电离焓, 并就此进行了讨论。     

微乳液的热力学性质 I: 芳烃类的侧链链长对微乳液热力学函数影响

本文研究以非离子型表面活性剂-正辛醇-水-芳烃类所组成的微乳液, 探讨醇从油相转移到界面相时的自由能变化, 以及温度对自由能的影响。计算出熵和焓的变化, 发现在实验范围内, 上述热力学函数的对数值与芳烃侧链的碳原子数(n)呈线性关系。这些关系式对微乳液的构成和稳定性的讨论是重要的, 还对几种芳烃异构体所构成的微乳液的热力学函数进行了实验和讨论。     

铬天青S的液/液界面离子转移过程

本文研究了酸性染料显色剂铬天青S的液/液界面离子转移行为, 用循环伏安法和电流扫描计时电位法研究了铬天青S在水/硝基苯和水/1,2-二氯乙烷两种界面上的离子转移过程, 根据铬在青S在溶液中的离解平衡和电化学性质, 讨论了界面离子转移机理,研究了基础电解质和溶剂对铬天青S转移性能的影响, 在Britton-Robinson缓冲溶液中测得半波电位PH曲线与理论公式相一致, 由本法所得离解常数与文献值接近, 计算了转移离子的标准转移电位和标准吉布斯转移能。     

含有十二烷基酚聚氧乙烯(10)醚的溶致液晶体系的研究

本文以非离子表面活性剂十二烷基酚聚氧乙烯(10)醚(TX-10)/苯乙烯/水组成的三元体系为研究对象, 绘制了三元相图, 选取液晶区域作为研究对象, 配制系列样品, 摄制了纹理照片, 用小角X光衍射法测定了液晶中各种组分变化时间的层间距, 并结合^2H NMR谱图和纹理照片的对照以及互为补充的分析, 为精确区分液晶结构提供了新的途径。这不仅对于基础理论研究, 同时对于日用化工和帮次采油都具有一定指导意义。