Structural and electronic properties of graphite layers grown on SiC(0 0 0 1)

Photoelectron spectroscopy, low-energy electron diffraction, and scanning probe microscopy were used to investigate the electronic and structural properties of graphite layers grown by solid state graphitization of SiC(0 0 0 1) surfaces. The process leads to well-ordered graphite layers which are rotated against the substrate lattice by 30°. On on-axis 6H-SiC(0 0 0 1) substrates we observe graphitic layers with up to several 100 nm wide terraces. ARUPS spectra of the graphite layers grown on on-axis 6H-SiC(0 0 0 1) surfaces are indicative of a well-developed band structure. For the graphite/n-type 6H-SiC(0 0 0 1) layer system we observe a Schottky barrier height of ?_B,n = 0.3 ± 0.1 eV. ARUPS spectra of graphite layers grown on 8° off-axis oriented 4H-SiC(0 0 0 1) show unique replicas which are explained by a carpet-like growth mode combined with a step bunching of the substrate.     

Determination of ultra-trace gold in natural water by graphite furnace atomic absorption spectrophotometry after in situ enrichment with thiol cotton fiber

A simple method of determining ultra-trace Au in natural water was presented by using graphite furnace atomic absorption spectrophotometry (GFAAS) after in situ enrichment with thiol cotton fiber (TCF). The sample solution was adjusted to pH 1.5-2.0 with HCl, then the water sample was passed through a column packed with 0.10-0.20 g TCF and the flow rate was controlled at 20-40 ml min⁻¹. The effects of interferences, such as complexing and oxidizing agents and other elements adsorbed on TCF were overcome by chemical treatments prior to the desorption of Au. The adsorbed Au was adsorbed with 2.0 ml hot acid, then it was extracted with 1.00 ml methyl isobutylketone (MIBK). For a 5 l water sample, the detection limit of Au is 0.02 ng l⁻¹. The relative standard deviation (R.S.D.) for the determination of 1.44 ng l⁻¹ Au was 9.4%.The method was applied to determine ultra-trace Au both in suspended phase and soluble phase in natural water, the concentrations of total Au in natural water samples range from 0.51 to 67.82 ng l⁻¹. The recovery of added 0.50-6.00 ng l⁻¹ Au was 80-95%. The method is useful in prospecting for Au deposits by means of hydrogeochemical methods. The enrichment is carried out in the field, and then the determination of Au is completed later in the laboratory.     

元素在石墨炉内石墨探针表面上的原子化机理研究：Ⅶ.锗的原子化机理

本文应用Ｘ－射线衍射，Ｘ－射线光电子能谱，俄歇电子能谱和其它一些实验，考察石墨炉升温过程中氟化锗，锗酸钠在石墨探针表面上的形态变化，阐明了它们的原子化机理：ＧｅＦ２与Ｎａ２ＧｅＯ３首先分解为ＧｅＯ２，ＧｅＯ２还原为ＧｅＯ，后者在＞２４００Ｋ热分解产生自由态的锗原子，ＧｅＦ２和Ｎａ２ＧｅＯ３的原子化均源于ＧｅＯ（ｇ）的气相分解。原子化的升温过程中，在１４００－２４００Ｋ ＧｅＦ２和Ｎａ２ＧｅＯ３都产     

钯作基体改进剂FIA－HG－GFAAS法测定锗及其机理研究

采用钯，钯－镁作基体改进剂，ＦＩＡ－ＨＧ－ＧＦＡＡＳ法成功地测定了锗。灵敏度、精密度和分析速度都得到很大的提高。峰值吸收的特征质量８．０ｐｇ，检出限１０．９ｐｇ，相对标准偏差０．３４％，同时探讨了基体改进剂钯的稳定作用机理及锗在石墨管中的原子化机理。     

Au deposits on graphite: On the nature of high temperature desorption peaks in CO thermal desorption spectra

Due to the discovery of Au as a catalyst for low temperature CO oxidation, the adsorption of CO on Au surfaces has attracted a lot of attention recently. On stepped and rough single crystal surfaces as well as on deposited particles two characteristic desorption states above 100 K have been observed via TPD. We have studied Au deposits on graphite in order to elucidate the nature of these desorption peaks in more detail. For this purpose, Au was deposited at 100 K and 300 K on HOPG as a weakly interacting support. In analogy to other supports, we obtain two desorption states (∼140 K and ∼170 K) whose relative intensities depend strongly on the deposition temperature with the high temperature peak being much more pronounced for the 100 K deposits. After annealing to 600 K, both states drastically lose intensity. XP spectra, on the other hand, show virtually no decrease of the Au 4f intensity as would be expected for desorption or significant changes of the particle morphologies. We conclude that both desorption peaks are defect-related and connected with under-coordinated Au atoms that are lost for the most part upon annealing. These sites could be located at the perimeter of dendritic islands or on small, defect-rich particles in addition to larger particles not adsorbing CO at 100 K. Preliminary STM results are in favour of the second interpretation.     

WLY100型顺序扫描ICP光谱仪设计方案的一些考虑

本文对国产ＷＬＹ１００型顺序扫描ＩＣＰ光谱仪在设计中对单色仪，高频发生器，扫描机构，测光系统，短紫外光域的测量，恒温，气流控制与软件编制等方案的选择作了详尽的阐述，稳妥的方案使研制工作顺利进行，保证整机一次成功。     

溶膜预富集-石墨炉原子吸收法测定痕量钯

强酸性条件下 ,钯 (Ⅱ )与 5 [( 5 氯 2 吡啶 )偶氮 ] 2 ,4 二氨基甲苯 ( 5 Cl PADAT)生成紫红色螯合物 ,该螯合物可与十二烷基苯磺酸钠 (SDBS)生成离子缔合物 ,离子缔合物经 0 .3μm孔径的硝化纤维微孔滤膜富集后 ,于小体积 ( 0 .5mL)的浓硫酸中溶膜 ,用石墨炉原子吸收法 (GFAAS)测定 ,富集倍数可达 2 0 0倍 ,钯含量在 4.69× 1 0 - 1 2 ～ 7.0 9× 1 0 - 9mol/L范围内线性良好 ,检出限为 1 .78×1 0 - 1 2 mol/L。方法用于海水中痕量钯的测定。     

Influence of boric acid on the electrochemical deposition of Ni

The electrolytic deposition of Ni onto a paraffin-impregnated graphite electrode from supporting chloride electrolyte (0.5 mol dm⁻³ NaCl) adjusted to the required pH using dilute HCl is investigated. The effect of electrolyte composition on the Ni electrodeposition is studied using linear sweep voltammetry in the cathodic region. An elimination voltammetry procedure was applied to evaluate the polarization curves. The aim of this work was to deduce the mechanism of Ni reduction in the chloride bath as well as the influence of boric acid on this. Positively-charged NiCl⁺ ions were found to be the electroactive particles in the Ni reduction mechanism. The strong competition between the NiCl⁺, Cl⁻ and H⁺ ions for active sites at the electrode is discussed. Kinetically-controlled adsorption/desorption processes of various species were also confirmed using elimination voltammetry with a linear scan. The evolution of gaseous hydrogen, catalyzed by the freshly-deposited Ni, accompanies the electrodeposition process. The presence of boric acid at a sufficiently high concentration inhibits the deposition of Ni and, at the same time, improves the morphology and brightness, as well as the adhesion of the deposited Ni. Elimination voltammetry with a linear scan is an efficient way to evaluate current–potential curves that reflect the electrodeposition of one-component Ni coatings. By eliminating selected currents, additional interesting and useful information can be obtained from voltammetric data.     

A study of the polymerization of styrene initiated by K-THF-GIC system

In this paper, the polymerization of styrene initiated by potassium (K)-tetrahydrofuran (THF)-graphite intercalation compound (GIC) (K-THF-GIC) was studied. The mechanism of the polymerization was determined to be anionic polymerization according to its characteristics. The effect of the concentration of the initiator and monomer was studied. It was found that the polymerization mainly occurred on the surface and edge of the intercalated graphite. It was also shown that the polarity of solvent has little effect on the polymerization yield in this system.     

衬钽管石墨炉中小量氢气的影响及稀土基质激光晶体中铕的测定

通过纯氩中加入小量氢气,研究了保护气体对衬鉏管石墨炉分析性能的影响,结果表明,采用5％H_2-Ar作保护气体,可以显著提离衬鉏管的成品率,明显延长衬鉏管的使用寿命,使衬钽管的测定重现性得到改善,而对测定灵敏度没有明显影响。干扰试验表明,本方法可直接用于稀土基质激光晶体中铕的测定,分析结果与计算值基本一致。