污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能研究

亚甲基蓝和环丙沙星是水体中2种污染物, 对生态环境有潜在危害. 本文以市政剩余活性污泥为原料, 氯化锌为活化剂热解制备污泥基吸附剂, 研究盐酸酸洗浓度、氯化锌浓度、热解温度、热解时间等对污泥基吸附剂吸附水中亚甲基蓝和环丙沙星性能的影响. 结果表明 (1)污泥基吸附剂对亚甲基蓝的吸附性能随盐酸酸洗浓度的增大而增加, 对环丙沙星的吸附性能则随盐酸酸洗浓度的增大呈先降后增趋势, 两者均在1.500mol·L-1盐酸浓度下取得最优值. (2)污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能随氯化锌浓度和热解温度的增加呈先升后降趋势, 在氯化锌浓度为4.0mol·L-1、热解温度为500℃时有最优值; 随着热解时间的延长, 污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能分别在500℃热解70min和80min时有最优值. (3)污泥基吸附剂的最佳制备条件为 氯化锌4.0mol·L-1活化2h、500℃热解70min和80min、1.500mol·L-1盐酸酸洗; 以此制得的污泥基吸附剂对亚甲基蓝和环丙沙星的去除率分别为97.7%和96.4%, 平衡吸附量分别为97.9mg·g-1和3.9mg·g-1, 且污泥基吸附剂对亚甲基蓝和环丙沙星的吸附过程均符合准二级动力学方程.     

CCSD(T) study on the structures and chemical bonds of AnO molecules (An = Bk–Lr)

The molecular geometries and dissociation energies of AnO (An = Bk–Lr) molecules were first obtained at thecoupled-cluster single-, double-, and perturbative triple-excitations [CCSD(T)] level of theory. Four hybrid functionals,B3LYP, M06-2X, TPSSh, and PBE0, were also employed in the calculations for the sake of comparison. In comparison ofthe CCSD(T) results, B3LYP, TPSSh, and PBE0 functionals can obtain more appropriate results than M06-2X and MP2.The analyses on molecular orbitals show that the 7s, 6d, and 5f atomic orbitals of actinide (An) atoms participate in thebonding of An–O bonds. The partial covalent nature between An and O atoms is revealed by QTAIM analyses.     

Virtual Field Characterization for Ratcheting Effect Under Cyclic Loading

Experimental Mechanics - Ratcheting is an important mechanical behavior of metals and alloys, which is caused by the repeated accumulations of tensile and compressive strain in circle load....     

多级孔芳香骨架材料的合成及固载硫脲催化剂的研究

合成了一种多级孔芳香骨架材料(PAF-70); 使用由氨基修饰过的单体, 应用该合成策略得到了同样具有窄分布介孔的含有氨基活性位点的PAF材料, 并通过硫脲单体与其氨基活性位点的反应, 将硫脲基团引入PAF-70材料中, 获得了含有硫脲催化位点的材料(PAF-70-thiourea). 氮气吸附-脱附测试结果显示, PAF-70存在孔径分布较窄的介孔, 介孔孔径为3.8 nm, 与模拟计算值(约3.7 nm)吻合. 热重分析结果表明, PAF-70具有很高的热稳定性. PAF-70在大多数溶剂中可以稳定存在, 具有良好的化学稳定性. 将PAF-70-thiourea作为催化剂, 应用在N-溴代琥珀酰亚胺(NBS)氧化醇类的反应中, 其表现出较高的催化活性、 较高的稳定性和广泛的底物适用性. 与含有相同硫脲催化位点的金属有机框架(MOF)材料(IRMOF-3-thiourea)作为催化剂对比, 进一步证实PAFs材料非常适合作为催化有机反应的固载平台.     

富晶格位错的多孔铋纳米花高效电还原二氧化碳制甲酸盐※

二氧化碳转化已成为现今世界研究的热点. 本工作采用原位电化学转化的策略, 将简单溶剂热法合成的层状甲酸氧铋纳米花(BiOCOOH NFs)还原为带有大量晶格位错的多孔铋纳米花(p-Bi NFs). 研究结果表明, p-Bi NFs电催化二氧化碳转化为甲酸盐具有较小的过电位(436 mV). 在–1.8 V(相对饱和甘汞电极, vs. SCE)时, 甲酸盐的分电流密度(j_formate)高达24.4 mA•cm^-2, 法拉第效率(FE_formate)为96.7%, 且在超过500 mV的宽电位窗口内FE_formate超过90%, 并具有很好的稳定性. 该催化剂的高催化性能可归因于前驱体晶格坍塌和重构而形成特殊的多孔粗糙的微纳多级结构, 其表面富含晶格位错和缺陷等高本征活性位, 且具有较强的电子传递能力. 本研究为设计合成高性能的电催化二氧化碳还原产甲酸催化剂提供了新的思路.     

The Synergistic Photocatalytic Effect of H3PW12O40 and Pt Nanoparticles Comodified UiO-66-NH2 on the Reduction of Aqueous Cr(VI) under Original pH

Kinetics and Catalysis - A ternary synergistic photocatalyst H3PW12O40/Pt/UiO-66-NH2 was successfully fabricated for the first time through a simple solvothermal synthetic strategy. We found that...     

High-efficient surface tailoring via reverse atom transfer radical polymerization and reversible addition-fragmentation chain-transfer polymerization in an aqueous system initiated by a monocenter redox pair

The commonly used multi-center initiation methods always lead to the formation of quantities of homopolymer in the surface tailoring based on reverse atom transfer radical polymerization (ATRP) and reversible addition-fragmentation chain-transfer (RAFT) polymerization. In this study, a monocenter redox pair constructed of silica bearing tert-butyl hydroperoxide groups and ascorbic acid (SiO₂-TBHP/AsAc) was applied to substitute the commonly used initiation method of R-supported RAFT grafting polymerization. All the propagating radicals were restricted on the surface of solid particles during the whole procedure theoretically, resulting in a higher grafting efficiency of 95.1% combined with the “controllable” feature at 10 h. This redox pair was also used to initiate the reverse ATRP in miniemulsion successfully with a grafting efficiency of 86.3% at 10 h. The grafting efficiency obtained under this monocenter initiation method was significantly higher than that of the frequently reported surface modification by reverse ATRP and RAFT polymerization. In addition, the high-efficient surface tailoring was traced and confirmed by nuclear magnetic resonance, Fourier transform infrared, X-ray photoelectron spectroscopy, thermogravimetric analysis, transmission electron microscopy, and other analysis tests. The advantage of this monocenter redox pair will open a new avenue for the potential “high-efficient” surface tailoring of various materials.     

A systematic study for the structures and properties of phosphorylated pulp fibers prepared under various conditions

Cellulose - A bleached softwood kraft pulp was phosphorylated with (NH4)2HPO4 and urea at 150 ℃ for 0‒40 min, and the structures and properties of the resulting...     

Characterization of diterpene metabolism in rats with ingestion of seed products from Euphorbia lathyris L. (Semen Euphorbiae and Semen Euphorbiae Pulveratum) using UHPLC-Q-Exactive MS

Previous pharmacological studies have indicated that diterpenoids are the primary effective chemical cluster in the seeds of Euphorbia lathyris L. The seed products are used in traditional Chinese medicine in the forms of Semen Euphorbiae (SE) and Semen Euphorbiae Pulveratum (SEP). However, the metabolism of the plant's diterpenoids has not been well elucidated, which means that the in vivo metabolite products have not been identified. The current study screened the physiological metabolites of six diterpenes [Euphorbia factor L₁ (L1), L₂ (L2), L₃ (L3), L_7a (L7a), L_7b (L7b), and L₈ (L8)] in feces and urine of rats after oral administration of SE and SEP using UHPLC-Q-Exactive MS. A total of 22 metabolites were detected in feces and 8 in urine, indicating that the major elimination route of diterpenoids is via the colon. Hydrolysis, methylation, and glucuronidation served as the primary metabolic pathways of these diterpenoids. In sum, this study contributed to the elucidation of new metabolites and metabolic pathways of SE and SEP, and the new chemical identities can be used to guide further pharmacokinetic studies.