电泳法制备的致密氧化锡薄膜及其在高稳定性钙钛矿太阳能电池中的应用

在平面型钙钛矿太阳能电池中常采用SnO₂作为电子传输层材料,相应的SnO₂薄膜常采用溶液旋涂法制备。但是由于前驱液中的纳米颗粒可能会发生部分团聚、基底和溶液难以完全避免灰尘等杂质颗粒混入,且最佳的SnO₂电子传输层的厚度通常仅有约20 nm,所以这种方法制备的电子传输层难以保证严格致密和无纳米针孔。在本工作中,我们报道了一种电泳沉积制备致密SnO₂薄膜的方法,并用其有效地提高了钙钛矿太阳能电池的光电转换效率和工况稳定性。通过电泳法,表面带负电荷的SnO₂纳米颗粒在电场的作用下沉积到氧化铟锡(ITO)阳极表面,这种方法得到的薄膜比旋涂法制备的更为致密。将其应用于n-i-p结构的钙钛矿太阳能电池中,能够使得暗电流降低并抑制载流子的非辐射复合,从而提高电池的短路电流和开路电压,进而实现更高的光电转换效率(从18.17%提高到19.52%),且能消除迟滞效应。更重要的是,长期工况稳定性测试表明基于电泳-旋涂法制备的器件在1个太阳的光照下、最大功率点处连续工作960 h后,仍然能够保持71%的初始效率;然而基于旋涂法制备的器件在工作100 h后即降低到初始效率的70%。本工作提供了一种全新的SnO₂电子传输层的制备方法,显著地提高了器件性能和工况稳定性,后续有望应用于制备大面积器件和电池模组。     

一类时滞非局部扩散SVIR模型单稳行波解的稳定性

利用加权能量法结合连续性方法建立了一类时滞非局部扩散SVIR模型单稳行波解的指数稳定性。特别地，初始扰动只需在x=+∞处一致有界而不必趋于0。     

荧光分光光度法测定硫酸阿米卡星的含量

阿米卡星本身在激发波长295nm,发射波长367nm处有微弱荧光。它在NaNO2存在下,氨基亚硝化为硝基,然后在弱酸条件下水解为还原糖后与乙二胺在磷酸盐缓冲液中反应会产生强荧光物质。据此建立了阿米卡星含量测定的新方法。阿米卡星在2.0×10-5～5.0×10-6 mol/L的范围内与其产物荧光强度呈现良好的线性关系,相关系数r=09952,检出限为4.2×10-7mol/L。该方法用于市售硫酸阿米卡星注射液含量的测定。     

Sputtered SnO2 as an interlayer for efficient semitransparent perovskite solar cells

SnO₂ is widely used as the electron transport layer (ETL) in perovskite solar cells (PSCs) due to its excellent electron mobility, low processing temperature, and low cost. And the most common way of preparing the SnO₂ ETL is spin-coating using the corresponding colloid solution. However, the spin-coated SnO₂ layer is sometimes not so compact and contains pinholes, weakening the hole blocking capability. Here, a SnO₂ thin film prepared through magnetron-sputtering was inserted between ITO and the spin-coated SnO₂ acted as an interlayer. This strategy can combine the advantages of efficient electron extraction and hole blocking due to the high compactness of the sputtered film and the excellent electronic property of the spin-coated SnO₂. Therefore, the recombination of photo-generated carriers at the interface is significantly reduced. As a result, the semitransparent perovskite solar cells (with a bandgap of 1.73 eV) based on this double-layered SnO₂ demonstrate a maximum efficiency of 17.7% (stabilized at 17.04%) with negligible hysteresis. Moreover, the shelf stability of the device is also significantly improved, maintaining 95% of the initial efficiency after 800-hours of aging.     

Silica encapsulated ZnO quantum dot-phosphor nanocomposites:Sol-gel preparation and white light-emitting device application

ZnO quantum dots(QDs) as an eco-friendly and low-cost material has bright fluorescence, which makes it promising material for healthy lighting and displaying. However, the low fluorescence efficiency and poor stability of ZnO QDs impede their applications in lighting application. In this work, silica encapsulated ZnO QD-phosphors nanocomposites(ZSPN) have been prepared through a sol-gel synthesis process, where yellow-emitting ZnO QDs and blue-emitting BaMgAl_(10) O_(17):Eu~(2+) are employed as the luminescence cores and silica as link between two luminescence materials. Tunable photoluminescence of ZSPN and the white light emission have been achieved through changing mass ratio of both of ZnO QDs and commercial phosphors. The PLQY of the ZSPN can reach 63.7% and they can maintain high luminous intensity even the ambient temperature up to 110?C and after 35 h of UV irradiation. In addition, they can keep stable for 40 days. By coating the ZSPN phosphors onto a ultraviolet chip, WLEDs with luminous efficiency of 73.6 lm/W and the color coordinate, correlated color temperature, and color rendering index can reach(0.32, 0.34), 5580 K, and 87, respectively,indicating the bright prospect of the ZSPN phosphors used in healthy lighting.     

时均流激声发动机声场特性实验研究

时均流激声发动机利用流体诱导声振荡效应把自然界的风和管道气体的动能转化为声场能,可驱动热声制冷机制冷或驱动发电机和换能器发电,为风能利用提供了新思路。在国内首次搭建了正十字型时均流激声发动机实验台,以一台高压风机提供的气流模拟自然风,获得了稳定的驻波声场。在此基础上,揭示了时均流速、平均压力、斯特劳哈尔数等对时均流诱导声振荡的影响。在平均压力为106.19 kPa、时均流速为50.52 m/s、谐振管长度为0.96 m的条件下,该正十字型时均流激声发动机谐振管内的压力振幅达6.20 kPa,约为平均压力的5.80%,为时均流激声发动机驱动发电装置和热声制冷研究奠定了实验基础。