形状记忆合金椭圆孔口问题的有限单元法

基于Lagoudas形状记忆合金(SMA)三维本构模型,假设材料为各向同性,推导了SMA平面应力状态的增量型本构方程,继而编写了ABAQUS用户自定义材料(UMAT)子程序,研究了在双向拉伸情况下,外载荷、温度、椭圆孔口长短轴之比对超弹性SMA椭圆孔口板中应力诱发马氏体相变区的影响。数值结果表明:应力诱发马氏体相变首先发生在椭圆孔口长轴端点部位,在外加载荷作用下逐渐扩展到板内,并由内向外形成马氏体相区、相变混合区和奥氏体相区;SMA板内应力诱发马氏体完全相变区面积与施加外载荷成正相关,与温度成负相关;随着椭圆孔口长短轴之比增大,SMA板内应力诱发马氏体完全相变区面积呈现出先减小后增大的趋势;拉应力差值相同时,相较于拉应力沿椭圆孔口长轴方向较大的情况,当拉应力沿椭圆孔口短轴方向较大时,SMA板内完全相变区面积较大,椭圆孔口周边应力集中现象更明显。     

The Active Sites of a Rod‐Shaped Hollandite DeNOx Catalyst

The identification of catalytically active sites (CASs) in heterogeneous catalysis is of vital importance to design and develop improved catalysts, but remains a great challenge. The CASs have been identified in the low‐temperature selective catalytic reduction of nitrogen oxides by ammonia (SCR) over a hollandite manganese oxide (HMO) catalyst with a rod‐shaped morphology and one‐dimensional tunnels. Electron microscopy and synchrotron X‐ray diffraction determine the surface and crystal structures of the one‐dimensional HMO rods closed by {100} side facets and {001} top facets. A combination of X‐ray absorption spectra, molecular probes with potassium and nitric oxide, and catalytic tests reveals that the CASs are located on the {100} side facets of the HMO rods rather than on the top facets or in the tunnels, and hence semi‐tunnel structural motifs on the {100} facets are evidenced to be the CASs of the SCR reaction. This work paves the way to further investigate the intrinsic mechanisms of SCR reactions.     

Fixed-time disturbance observer-based robust fault-tolerant tracking control for uncertain quadrotor UAV subject to input delay

Nonlinear Dynamics - This study focuses on the design of a fixed-time disturbance observer-based robust fault-tolerant tracking control scheme for an uncertain quadrotor unmanned aerial vehicle...     

<Emphasis Type="SmallCaps">l</Emphasis>-Tryptophan-capped carbon quantum dots for the sensitive and selective fluorescence detection of mercury ion in aqueous solution

l-Tryptophan-capped carbon quantum dots (l-CQDs) were facilely synthesized through “green” methodology, and the obtained material was utilized as a sensitive and selective fluorescence sensor for mercury ion (Hg²⁺) in pure aqueous solutions. Carboxyl-functionalized CQDs were first green synthesized by a one-step hydrothermal route, and l-tryptophan was then attached to CQDs via direct surface condensation reaction in aqueous solution at room temperature. The as-synthesized l-CQDs had an average size of ca. 5 nm with a good dispersity in water, and exhibited a favorable selectivity for Hg²⁺ ions over a range of other common metal cations in aqueous solution (10 mM PBS buffer, pH 6.0). Upon the addition of Hg²⁺, a complete fluorescence quenching (ON–OFF switching) of l-CQDs was evident from the fluorescence titration experiment, and the fluorescence detection limit of Hg²⁺ was calculated to be 11 nM, which indicated that the obtained environmentally friendly l-CQDs had sensitive detection capacity for Hg²⁺ in aqueous solution.     

基于β-环糊精接枝聚L-谷氨酸星型聚合物的可注射水凝胶的制备与表征

采用Gadelle-Defaye法制备了全-6-氨基-β-环糊精[β-CD-(NH2)7],并用"Grafting-from"接枝法得到不同分子量的星型结构β-环糊精-g-聚L-谷氨酸(β-CD-g-PLGA).对β-CD-g-PLGA进行酰肼化改性后与醛基化海藻酸钠(ALG-CHO)通过席夫碱交联反应制备β-CD-g-PLGA/ALG水凝胶.研究了前驱体浓度以及β-CD-gPLGA分子量对β-CD-g-PLGA/ALG水凝胶性能的影响,并以疏水性辛伐他汀(SIM)为模型药物,研究了水凝胶对SIM的控制释放行为.     

Effect of partial crosslinking on morphology and properties of the poly(β-hydroxybutyrate)/poly(d,l-lactic acid) blends

Poly(β-hydroxybutyrate) (PHB) is a bio-based and biodegradable aliphatic polyester, however its application is limited by some disadvantages such as high price, brittleness, poor processability and low melt-strength due to serious thermal degradation. Partial crosslinking initiated by dicumyl peroxide (DCP) was applied in this work to improve the performance of poly(β-hydroxybutyrate)/poly(d,l-lactic acid) (PHB/PDLLA) blends. The partial crosslinking of the blends and its effect on the properties, morphology, rheology and thermal behavior of the blends were investigated. The tensile strength and impact toughness of the PHB were increased by incorporation of the PDLLA, which were improved further after the partial crosslinking because of an increased compatibility between the PHB and the PDLLA phases. The rheological study revealed that the storage modulus (G′) and complex viscosity (η*) of the blends were increased after addition of the DCP. On the other hand, the crystallization of PHB in the blends was restricted to a certain extent by the formation of partially crosslinked network while its crystal form was not modified.     

Effects of Nb substitution for Zr on the phases,microstructure and magnetic properties of Co80Zr18−xNbxB2 melt-spun ribbons

The phases, microstructure, and magnetic properties of Co₈₀Zr_18−xNb_xB₂ (x=1, 2, 3, and 4) melt-spun ribbons were investigated. The small substitution of Nb for Zr in the Co–Zr–B melt-spun ribbons resulted in the improvement of magnetic properties, especially the coercivity. The main effect of added Nb on the coercovity of Co–Zr–Nb–B melt-spun ribbons, originated from modification of the grain size of Co₁₁Zr₂ phase. The coercivity of the Co–Zr–Nb–B melt-spun ribbons depends on the annealing temperature. The optimal magnetic properties of H_c=5.1 kOe, and (BH)_max=3.4 MGOe were obtained in the Co₈₀Zr₁₅Nb₃B₂ melt-spun ribbons annealed at 600 °C for 3 min.     

Do Eu dopants prefer the precipitated LaF3 nanocrystals in glass ceramics?

Previous experimental results, using techniques associated with transmission electron microscopy (TEM), suggested that rare‐earth dopants prefer the precipitated fluoride nanocrystals to the glass matrix. By contrast, this work shows that contradicting results can be obtained under different experimental conditions. In the silicate glass containing LaF₃ nanocrystals, the Eu dopants distribute indistinguishably in the precipitated LaF₃ and the silicate glass matrix. However, electron beam exposure during the measurement can relocate Eu, leading to the false conclusion that apparently Eu prefers the precipitated LaF₃ nanoparticles to the glass matrix. Fortunately, the artefact can be avoided by shortening the exposure time. (© 2012 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

搜索区传递2-（q，4，1）设计

对于区传递但非旗传递的可解2-（q，4，1）设计，Camina指出，当q=13，37，61，109，157，181时有具体的例子，但是否有更多的q产生具体例子有待研究。主要结果：设q是素数幂且q=13（mod24），则对于每个q〈2000，总存在区传递但非旗传递的2-（q，4，1）设计。