Vapoluminescent Behavior and the Single-Crystal-to-Single-Crystal Transformations of Chloroform Solvates of [Au2(μ-1,2-bis(diphenylarsino)ethane)2](AsF6)2

The mono- and di-chloroform solvates of [Au₂(μ-1,2-bis(diphenylarsino)ethane)₂](AsF₆)₂ undergo single-crystal-to-single-crystal transformations that result in gain (over 12 hours) or slow loss (over five years) of only one chloroform molecule. The change in solvation results in changes in the structure and luminescence of the digold cation. The cation consists of a pair of slightly bent As-Au-As units that are connected through the two bridging dpae ligands and by aurophilic interactions with Au⋅⋅⋅Au contacts of 3.05152(15) Å in the disolvate or 2.9570(5) Å in the monosolvate.     

Event-triggered output-feedback tracking of a class of nonlinear systems with unknown time delays

A single function approximation (SFA) approach for event-triggered output-feedback tracker design is presented for uncertain nonlinear time-delay systems in lower-triangular form. Contrary to the existing event-triggered output-feedback control methods dependent on multiple function approximators in the presence of lower-triangular nonlinearities, the proposed SFA approach provides the following advantages: (i) the simple observer structure independent of function approximators; (ii) one event-triggering condition based on only a tracking error; and (iii) the simple control scheme using one function approximator. Thus, the structural simplicity is allowed for implementing the observer and the event-triggering law in the sensor part and the adaptive tracker in the control part. Under the proposed SFA-based event-triggered control scheme, it is shown that the boundedness of closed-loop signals and the existence of a minimum inter-event time are guaranteed regardless of unknown time-delay nonlinearities and unmeasurable state variables.

     

Enhanced output voltage of nano energy harvester with diverse textiles

Abstract

We demonstrate the electrical properties of nano energy harvesters (NEHs) with various textiles for smart textiles that can be applied to the next generation wearable electronics. Output voltages and currents of NEHs with various fabrics, such as a cotton, rayon and wool that have different triboelectricity were measured. Cotton, rayon and wool shows the maximum output voltages of 1.250, 3.313 and 4.063 V, respectively. In addition, output currents of those textiles were 0.75, 4.4, 1.063 μA, respectively. Wool, in particular, which has the highest triboelectricity of 350 V exhibits the highest output voltage.     

How do molecular interactions affect fluorescence behavior of AIEgens in solution and aggregate states?

Molecular interactions are crucial in diverse fields of protein folding,material science,nanotechnology,and life origins.Although mounting experimental research controls luminescent behavior by adjusting molecular interactions in light-emitting materials,it remains elusive to correlate microscopic molecular interactions with macroscopic luminescent behavior directly.Here,we synthesized three red luminogens with subtle structural variation and investigated the influence of molecular interactions on their luminescent behavior in solution and aggregate states.Our results indicate that strongπ-πand D-A interactions in both dilute solution(between luminogen and solvent molecules)and aggregate(between luminogens)states cause the redshift in emission,while weak interactions(e.g.,Van der Waals,C–H…π,and C–H…F interactions)enhance the quantum yield.This work provides a thoughtful investigation into the complicated influence of various molecular interactions on luminescent behavior.     

MXene-based composite electrodes for efficient electrochemical sensing of glucose by non-enzymatic method

A recently discovered 2D transition titanium metal carbides also called as MXenes (Ti₃C₂T_x)-based nanocomposite was prepared with Cu₂O through wet precipitation technique, and these materials were further developed as the electrode for sensing glucose by chronoamperometry technique. The prepared MXene-Cu₂O (Ti₃C₂T_x-Cu₂O) nanocomposite was characterized by XRD, FTIR, UV–Vis spectroscopy, FE-SEM, EDAX, and Raman spectroscopy. Morphological studies of the composites revealed that the micro-octahedral shape of Cu₂O is distributed on the surface of MXene with size larger than bare Cu₂O. Further, the prepared composite material was fabricated as a sensing probe, and the electrochemical activities were examined by cyclic voltammetric analysis (CV) and chronoamperometric (CA) methods. From the CV and CA investigation, the current response was higher for the composite than the bare material (Cu₂O & MXene) in the presence of glucose. The amperometric investigation of MXene-Cu₂O composite for the detection of glucose shows a broad linear range (0.01–30 mM) with a sensitivity of 11.061/μAmM cm^?2 and a detection limit of 2.83 μM. Further, the fabricated sensor exhibits good selectivity with interfering species like NaCl, fructose, sucrose, urea, ascorbic acid, lactose, short response time, stability, good reproducibility, and compatibility with human serum sample. From the investigation, the prepared MXene-Cu₂O composite is a good candidate for the direct detection of glucose molecules and is also well suitable for clinical diagnosis.     

Simplified global fault accommodation control design of uncertain nonlinear systems with unknown time-varying powers

This paper addresses the problem of global robust fault accommodation tracking for a class of uncertain nonlinear systems with unknown powers and actuator faults. It is assumed that the powers of the concerned system are unknown time-varying functions, all system nonlinearities are unknown, and unknown actuator faults depend on the time-varying power of a control input. A fault accommodation state-feedback controller is explicitly constructed based on the nonlinear error transformation technique using time-varying performance functions. Global tracking with the preselected performance bounds is established in the presence of unknown time-varying powers and unexpected actuator faults. Different from the previous results dealing with the problem of unknown time-varying powers, the proposed tracking strategy does not require the knowledge of the bounds of the time-varying powers and the nonlinear bounding functions of system nonlinearities. An underactuated mechanical system is simulated to validate the effectiveness of the proposed theoretical approach.     

Redox‐responsive core cross‐linked micelles of poly(ethylene oxide)‐b‐poly(furfuryl methacrylate) by Diels‐Alder reaction for doxorubicin release

Redox‐responsive core cross‐linked (CCL) micelles of poly(ethylene oxide)‐b‐poly(furfuryl methacrylate) (PEO‐b‐PFMA) block copolymers were prepared by the Diels‐Alder click‐type reaction. First, the PEO‐b‐PFMA amphiphilic block copolymer was synthesized by the reversible addition‐fragmentation chain transfer polymerization. The hydrophobic blocks of PFMA were employed to encapsulate the doxorubicin (DOX) drug, and they were cross‐linked using dithiobismaleimidoethane at 60 °C without any catalyst. Under physiological circumstance, the CCL micelles demonstrated the enhanced structural stability of the micelles, whereas dissociation of the micelles took place rapidly through the breaking of disulfide bonds in the cross‐linking linkages under reduction environment. The core‐cross‐linked micelles showed fine spherical distribution with hydrodynamic diameter of 68 ± 2.9  nm. The in vitro drug release profiles presented a slight release of DOX at pH 7.4, while a significant release of DOX was observed at pH 5.0 in the presence of 1,4‐dithiothreitol. MTT assays demonstrated that the block copolymer did not have any practically cytotoxicity against the normal HEK293 cell line while DOX‐loaded CCL micelles exhibited a high antitumor activity towards HepG2 cells. © 2016 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2016 , 54, 3741–3750