Elemental analysis of particulate matter in a metal workshop and of biological samples from exposed workers

During metal welding and cutting, large amounts of particulate matter (PM) are produced that might represent a significant health risk for the exposed workers. In the present pilot study, we performed an elemental analysis of fine PM collected in a metal workshop. Also, elemental analysis of the hair and nail samples collected from workers exposed to the workshop dust and control group was done. Concentrations of 15 elements in PM were measured with X‐Ray Fluorescence (XRF) and Particle Induced X‐ray Emission (PIXE), whereas inductively coupled plasma mass spectrometry (ICP‐MS) was used to determine 12 elements in hair and nail samples. Mean 8‐hr concentrations of PM_2.5, Fe, and Mn in the vicinity of welders were up to 1803, 860, and 30 μg/m³, respectively, whereas in the nearby city, daily PM_2.5 concentrations are on average 11 μg/m³. We found that several elements, especially Fe and Mn, had substantially higher concentrations in hair and nail samples of exposed workers than in the control group, which indicates the accumulation of metals in workers' tissues, although limit values were not exceeded.     

MCNOs/CdS双效光催化剂的制备及其性能研究

水热合成法制备了不同磁性纳米洋葱碳(MCNOs)负载量(0%、1%、3%、5%)的MCNOs/CdS光催化剂。并通过X射线衍射分析(XRD)、扫描电子显微镜(SEM)、傅里叶红外光谱(FT-IR)、X射线光电子能谱(XPS)、紫外可见光光谱(UV-Vis)、磁滞回线测定仪(VSM)对其进行表征,探究了MCNOs负载比例对催化剂在可见光下降解RhB性能及机理的影响。结果表明,MCNOs能有效提高CdS的光催化效果,复合3%MCNOs后降解率为96%,与纯CdS相比降解率提高了30%,磁性分析表明,其具有良好的顺磁性并能实现催化剂的有效回收。MCNOs/CdS在可见光下催化降解RhB的一级反应动力学直线有较好的拟合度,表明制备的催化剂有较好的催化活性。     

The Evolution of Quantum Discord and Entanglement in the XXZ Heisenberg Spin Chain under Ornstein-Uhlenbeck Noise

International Journal of Theoretical Physics - The dynamics of entanglement measured by concurrence and quantum correlation described by quantum discord under Ornstein-Uhlenbeck noise are...     

Majorana Representation for a Composite System

International Journal of Theoretical Physics - The Majorana representation, which provides an intuitive way to represent the quantum state by stars on the Bloch sphere, has drawn considerable...     

Development of an improved divergence‐free‐condition compensated coupled framework to solve flow problems with time‐varying geometries

In this article a coupled version of the improved divergence‐free‐condition compensated method will be proposed to simulate time‐varying geometries by direct forcing immersed boundary method. The proposed method can be seen as a quasi‐multi‐moment framework due to the fact that the momentum equations are discretized by both cell‐centered and cell‐face velocity. For simulating time‐varying geometries, a semi‐implicit iterative method is proposed for calculating the direct forcing terms. Treatments for suppressing spurious force oscillations, calculating drag/lift forces, and evaluating velocity and pressure for freshly cells will also be addressed. In order to show the applicability and accuracy, analytical as well as benchmark problems will be investigated by the present framework and compared with other numerical and experimental results.     

坚硬顶板爆破切顶在沿空留巷中的应用研究

当煤层上方为坚硬顶板时,在工作面回采期间容易出现大面积悬顶,导致巷旁充填体出现大变形破坏,极大威胁采煤安全.为解决这一问题,以某矿1205工作面沿空留巷为工程背景,分析了爆炸围岩裂隙范围和坚硬顶板破断特征,建立了切顶卸压围岩结构力学模型,研究表明,相邻炮孔爆炸后,炮孔间裂隙互相贯穿,降低了顶板强度,同时当切顶角为15°时,巷道稳定性较好.工程实践结果表明:采用爆破切顶技术后,顶板下沉量减小了62.3%,较好地保证了围岩稳定性.     

基于XPS对硫铁矿去除SeO2-3的机理研究

硒是动植物及人体生长必需的十五种微量元素之一，具有清除体内自由基、抗氧化、增强免疫力等功能，但其安全剂量的范围却很窄。利用扫描电子显微镜（SEM）和X射线衍射仪（XRD）对湿法球磨制备的硫铁矿形貌进行了表征。SEM观测发现加乙醇助磨后的硫铁矿为粒径大小较均匀的球形颗粒团聚体，粒径范围在17～200 nm之间，平均粒径138 nm。XRD衍射图谱中的特征峰与FeS₂衍射图谱中各峰位置基本一致，因此判定硫铁矿中主要化学组分为FeS₂，且图谱中基本没有杂峰，表明制备过程中并未混入杂质，样品纯度较高。实验结果表明，该法制备的硫铁矿具有颗粒粒径小、比表面积大、反应活性高等优点。研究中利用X射线光电子能谱仪（XPS）对硫铁矿去除水体中SeO2-₃的机理进行了研究。研究结果表明, （1）在较为广泛的实验pH范围（pH 2.2～11.5），硫铁矿均能有效去除水体中SeO2-₃，去除效率（除pH值7.8以外）均达到90%以上；（2）硫铁矿与SeO2-₃发生反应后，其主要组成元素的XPS特征峰结合能有所减小，表明硫铁矿表面发生了一定化学变化；（3）酸碱环境下硫铁矿去除SeO2-₃的机理不完全相同，酸性环境下，硫铁矿对SeO2-₃的去除是单纯的氧化还原过程，即硫铁矿中被酸活化的S2-₂将SeO2-₃还原为单质Se(0)，并且酸性越强，SeO2-₃去除效果越好；碱性环境下，SeO2-₃的去除过程中氧化还原与络合反应并存，硫铁矿表面有络合态Fe(OH)SeO₃和单质Se(0)两种存在形态，且碱性越强，络合态Fe(OH)SeO₃含量越高。以上研究结果为硫铁矿去除固定水体和土壤中以SeO2-₃为代表的可变价金属阴离子提供重要理论依据和应用基础。     

Flow-induced shear stress and deformation of a core–shell-structured microcapsule in a microchannel

A numerical model was developed and validated to investigate the fluid–structure interactions between fully developed pipe flow and core–shell-structured microcapsule in a microchannel. Different flow rates and microcapsule shell thicknesses were considered. A sixth-order rotational symmetric distribution of von Mises stress over the microcapsule shell can be observed on the microcapsule with a thinner shell configuration, especially at higher flow rate conditions. It is also observed that when being carried along in a fully developed pipe flow, the microcapsule with a thinner shell tends to accumulate stress at a higher rate compared to that with a thicker shell. In general, for the same microcapsule configuration, higher flow velocity would induce a higher stress level over the microcapsule shell. The deformation gradient was used to capture the microcapsule's deformation in the present study. The effect of Young's modulus on the microcapsule shell on the microcapsule deformation was investigated as well. Our findings will shed light on the understanding of the stability of core–shell-structured microcapsule when subjected to flow-induced shear stress in a microfluidic system, enabling a more exquisite control over the breakup dynamics of drug-loaded microcapsule for biomedical applications.     

多孔离子液体的构筑及应用

多孔液体(Porous Liquids, PLs)是一类结合了多孔固体永久性孔隙与液态流动性优势的新材料. 自2007年, PLs的概念被首次提出以来, 其在合成策略与应用领域方面均取得了较大的突破. 然而, 传统的PLs因高黏度、高密度、高熔点与高原材料成本等缺陷极大程度制约了其在流动工业系统中的大规模应用. 因此, 迫切需要寻求理想的位阻溶剂用于制备先进的多孔液体. 离子液体(Ionic Liquids, ILs)因独特的可调节物理特性、非挥发性、高稳定性、易获得、经济性高、低再生能耗等特性, 使其成为构筑PLs中最具有应用前景的理想溶剂之一. 在过去的5年间, 基于多种ILs与先进多孔固体(如有机笼、金属有机框架、中空碳、沸石、多孔聚合物等)制备的多孔离子液体(Porous Ionic Liquids, PILs)被陆续报道. PILs独特的永久性孔隙、无溶剂挥发、再生能力强、黏度可调、低熔点、高稳定性等特性加快了其在气体吸附、分离、催化、萃取、分子分离等领域的快速发展. 本综述围绕PILs的构筑策略、特性、应用领域等阐述了其研究进展. 最后, 对PILs在制备中存在的挑战与未来的研究方向进行了归纳与展望.     

Bicomponent Cocatalyst Decoration on Flux-assisted CaTaO2N Single Crystals for Photocatalytic CO2 Reduction under Visible Light

Cubic-like CaTaO₂N photocatalysts with high crystallinity and uniform particle size were successfully prepared by the flux-assisted nitridation method. The growth of CaTaO₂N single crystals under different synthesis conditions was systematically investigated to understand the effects of the crystallinity and optical property on photocatalytic performance of CO₂ reduction. Moreover, the modification of CaTaO₂N single crystals with core-shell Ni−Ag bicomponent cocatalyst by two-step decoration process gave a 2.4 times higher amount of CO evolution than the deposition of sole Ag cocatalyst, because of the synergistic effects of bicomponent cocatalyst on the interfacial electron transfer and surface catalytic process. This study provides a valuable way to construct high-crystalline photocatalysts with effective bicomponent cocatalyst for visible-light-driven CO₂ reduction with H₂O.