Polymeric Carbon Nitride-based Single Atom Photocatalysts for CO2 Reduction to C1 Products

Photocatalytic CO₂ reduction to C₁ fuels is considered to be an important way for alleviating increasingly serious energy crisis and environmental pollution. Due to the environment-friendly, simple preparation, easy formation of highly-stable metal-nitrogen(M-N_x) coordination bonds, and suitable band structure, polymeric carbon nitride-based single-atom catalysts(C₃N₄-based SACs) are expected to become a potential for CO₂ reduction under visible-light irradiation. In this review, we summarize the recent advancement on C₃N₄-based SACs for photocatalytic CO₂ reduction to C₁ products, including the reaction mechanism for photocatalytic CO₂ reduction to C₁ products, the structure and synthesis methods of C₃N₄-based SACs and their applications toward photocatalytic CO₂ reduction reaction(CO₂RR) for C₁ production. The current challenges and future opportunities of C₃N₄-based SACs for photoreduction of CO₂ are also discussed.     

不同退火条件对PEALD制备的Ga2O3薄膜特性的影响

利用等离子增强原子层沉积技术(PEALD)在c面蓝宝石衬底上制备了氧化镓(Ga₂O₃)薄膜,研究了退火气氛(v(N₂)∶v(O₂)=1∶1(体积比)、空气和N₂)及退火时间对Ga₂O₃薄膜晶体结构、表面形貌和光学性质的影响。研究结果表明,退火前的氧化镓处于亚稳态,不同退火气氛下退火后晶体结构发生明显改变,而且退火气氛中N₂比例增加有利于Ga₂O₃重结晶。在N₂气氛下退火达到30 min,薄膜结构已由亚稳态转变成择优取向的β-Ga₂O₃。而且表面形貌分析表明,退火30 min后表面形貌开始趋于稳定,表面晶粒密度不再增加。另外实验样品在 400~800 nm的平均透射率几乎是100%,且光吸收边陡峭。采用N₂气氛退火,对于富氧环境下沉积的Ga₂O₃更利于薄膜表面原子迁移,以及择优取向Ga₂O₃重结晶。     

A Criterion of Nonparabolicity by the Ricci Curvature

A complete manifold is said to be nonparabolic if it does admit a positive Green’s function. To ?nd a sharp geometric criterion for the parabolicity/nonparbolicity is an attractive question inside the function theory on Riemannian manifolds. This paper devotes to proving a criterion for nonparabolicity of a complete manifold weakened by the Ricci curvature. For this purpose, we shall apply the new Laplacian comparison theorem established by the ?rst author to show the existence of a non-constant bounded subharmonic function.     

射频等离子制备石墨烯负载Co3O4催化剂及其析氧性能研究

氢能的引入能有效提升配电网的供电可靠性,而电解水制氢是实现低碳转型的关键技术,开发高效的电解水催化剂势在必行。过渡金属氧化物储量大、催化活性高,是具有广阔应用前景的析氧反应催化剂。本文通过射频等离子体处理制备石墨烯上负载Co₃O₄析氧催化剂,XRD、Raman和XPS测试结果显示,二维结构石墨烯的引入加速表面电子迁移,增大了反应面积。等离子体处理促进了纳米粒子在石墨烯上的负载,利用等离子体刻蚀作用在催化剂表面制造出大量碳结构缺陷和氧空位结构,改善了活性位点分布,有效调控Co₃O₄电子结构,提高析氧催化活性。电化学测试表明,本文中合成的Co₃O₄@rGO在电流密度为50 mA·cm^-2时的过电位为410 mV,动力学反应速率较快,表现出优于商业IrO₂的析氧催化活性。     

水热法制备二氧化锡/钨酸铋复合光催化材料及其催化活性研究

本文用水热法制备了正交晶系的纳米球状结构的二氧化锡和正交晶系的由片状聚集成球状结构的钨酸铋,并且对二者进行了复合,制备出了二氧化锡/钨酸铋复合光催化材料。采用X射线衍射(XRD)、扫描电子显微镜(SEM)、比表面积测试仪(BET)、紫外可见分光光度计等技术对复合样品的结构、形貌、比表面积、孔容孔径和光学性质进行了表征。用碘钨灯模拟太阳光,分别以二氧化锡、钨酸铋和二氧化锡/钨酸铋复合材料为催化剂降解罗丹明B(RhB),研究所制备的二氧化锡/钨酸铋复合材料的光催化活性。光催化90 min时二氧化锡、钨酸铋和二氧化锡/钨酸铋对罗丹明B的降解率分别是9%、22%和30%。实验结果表明,在可见光下,二氧化锡/钨酸铋复合材料的光催化活性要高于单一的二氧化锡和钨酸铋。     

基于抛光基材的热蒸镀铜箔生长高平整单层石墨烯薄膜

在石墨烯的化学气相沉积工艺中,铜箔是决定石墨烯薄膜质量的重要因素。传统铜箔由于制备工艺的限制,存在大量的缺陷,导致石墨烯薄膜的成核密度较高。本工作选用抛光铝板、抛光不锈钢板、微晶玻璃和SiO₂/Si作为基材,用热蒸镀法制备了不同粗糙度的铜箔,并详细讨论了以该系列铜箔生长高平整度石墨烯薄膜的条件及铜箔对石墨烯薄膜品质的影响。实验结果表明,铜箔以(111)取向为主,与基材分离后,表面具有纳米级平整度。在生长石墨烯后,从SiO₂/Si剥离的铜箔成核密度是4种基材中最小的。同时,从SiO₂/Si剥离的铜箔晶体结构变化最不明显,具有良好的结晶性,表面几乎不存在铜晶界缺陷。当压强为3 000 Pa,氢气和甲烷流速分别为300 mL/min和0.5 mL/min时,可以获得约1 mm横向尺寸的石墨烯单晶晶畴。     

Designing Covalent Organic Frameworks with a Tailored Ionic Interface for Ion Transport across One-Dimensional Channels

A strategy based on covalent organic frameworks for ultrafast ion transport involves designing an ionic interface to mediate ion motion. Electrolyte chains were integrated onto the walls of one-dimensional channels to construct ionic frameworks via pore surface engineering, so that the ionic interface can be systematically tuned at the desired composition and density. This strategy enables a quantitative correlation between interface and ion transport and unveils a full picture of managing ionic interface to achieve high-rate ion transport. Moreover, the effect of interfaces was scaled on ion transport; ion mobility is increased in an exponential mode with the ionic interface. This strategy not only sets a benchmark system but also offers a general guidance for designing ionic interface that is key to systems for energy conversion and storage.     

多层状碱式碳酸锌微晶的制备及其脱除Cu2+性能研究

以壳聚糖(CS)为生物模板,采用低温水热法成功制备出了多层状碱式碳酸锌(ZCHO)微晶.采用XRD、SEM和TG等手段对产物的结构、形态和热学性能进行了表征,结果表明,单个ZCHO微晶颗粒均是由许多ZCHO纳米片构成的.添加适量的CS对形成多层状ZCHO微晶起到了至关重要的作用.热重分析结果表明,CS辅助得到的碳酸锌微晶热稳定性较高.等温吸附实验表明,在室温下,多层状ZCHO微晶能有效脱除水体中的Cu2,去除量与浓度关系符合Freundlich模型.最后讨论了多层状ZCHO微晶大容量去除Cu2+的可能机理.     

Synthetic Humic Acids Solubilize Otherwise Insoluble Phosphates to Improve Soil Fertility

Artificial humic acids (A‐HA) made from biomass in a hydrothermal process turn otherwise highly insoluble phosphates (e.g. iron phosphate as a model) into highly available phosphorus, which contributes to the fertility of soils and the coupled plant growth. A detailed electron microscopy study revealed etching of the primary iron phosphate crystals by the ‐COOH and phenolic groups of humic acids, but also illustrated the importance of the redox properties of humic matter on the nanoscale. The combined effects result in the formation of then bioavailable phosphate nanoparticles stabilized by humic matter. Typical agricultural chemical tests indicate that the content of total P and directly plant‐available P improved largely. Comparative pot planting experiments before and after treatment of phosphates with A‐HA demonstrate significantly enhanced plant growth, as quantified in higher aboveground and belowground plant biomass.