静电纺聚偏氟乙烯@硅藻土锂离子电池隔膜的制备及性能

以聚偏氟乙烯(PVDF)和硅藻土为原料,通过静电纺丝法制备PVDF@硅藻土复合纤维膜,用于锂离子电池隔膜。 研究了隔膜的吸液率、热稳定性和电化学性能等。 添加硅藻土可有效提高复合膜的电解液吸收率和电化学性能,其中吸液率可达623.6%,相比于PVDF膜和聚丙烯(PP)膜具有优异的循环性能和倍率性能。     

White and Red Organic Light Emitting Materials

Derivatives of 2,3-(1,4-dialkoxyaceno)norbornadiene underwent ring-opening metathesis polymerization (ROMP) upon the catalysis of a ruthenium complex to afford the corresponding polymers. The polymeric materials containing anthracene chromophores emit white electro-luminescence, which can be fabricated into light-emitting diodes (LED). The broad emission band is composed of a blue emission from anthracene and a red emission from aggregates. A single layer device, ITO/polymer/Ca/Al, can be turned on at 7V and exhibits maximum intensity 427 cd/m2 at 15 V. A double layer device, ITO/polymer/TPBI/Mg:Ag (TPBI = (2,2′,2"-(1,3,5-benzenetriyl)-tris(1-phenyl-1H-benzimidazole)) displayed blue light with turn-on voltage 6 V and maximal intensity 930 cd/m2 at 15 V.Derivatives of bisindolylmaleimide were found to form amorphous solid films which exhibit intensive red luminescence. The property of forming glasses can be ascribed to the nonplanar geometry of these molecules. LED devices were fabricated by a layer of pure dye sandwiched between two charge transporting films. The yellow emission spectrum of the devices utilizing Alq (tris(8-hydoxyquinolinato)aluminum) contains a green component from Alq. Pure red emissions can be achieved by replacing Alq with TPBI. Typical devices can be turned on at ～3 V with maximal intensity 2000 cd/m2. White color devices are under current investigation, in which the green Alq layer is replaced by its blue derivative (bis(2-methyl-8-hydoxyquinolinato)(phenolato)aluminum).     

硅的低温电学性质

本文在20°—300°K研究了室温载流子浓度2×10¹²—1×10²⁰cm^-3含硼或磷(砷)Si的电学性质。对一些p-Si样品用弱场横向磁阻法及杂质激活能法进行了补偿度的测定,并进行了比较。从霍尔系数与温度关系的分析指出,对于较纯样品,硼受主能级的电离能为0.045eV,磷施主能级为0.045eV,在载流子浓度为10¹⁸—10¹⁹cm^-3时发现了费米简并,对载流子浓度为2×10¹⁷—1×10¹⁸cm^-3的p-Si及5×10¹⁷—4×10¹⁸cm^-3的n-Si观察到了杂质电导行为。从霍尔系数与电导率计算了非本征的霍尔迁移率。在100°—300°K间,晶格散射迁移率μ满足关系式AT^-a,其中A=2.1×10⁹,α=2.7(对空穴);或A=1.2×10⁸,α=2.0(对电子)。另外,根据我们的材料(载流子浓度在5×10¹¹—5×10²⁰cm^-3间),分别建立了一条电阻率与载流子浓度及电阻率与迁移率的关系曲线,以提供制备材料时参考之用。     

在等离子体中镁离子谱线MgⅡλ4481?的宽度和位移

本工作测量了MgIIλ4481?(3²D—4²F)在电子数密度为7×10¹⁶—3.1×10¹⁷电子数/cm³范围内的谱线轮廓和位移。采用振荡型电容放电作为光谱光源。在光源中引入水汽,由测量H_β谱线宽度来定电子数密度。观测结果指出,H_β的实验轮廓和Griem-Kolb-Shen的计算结果符合颇好。实验发现MgIIλ4481?谱线向紫方位移,并正比于微观电场的平方;由此定出一个经验上的二级斯塔克效应常数C₄=5.0×10^-14cm⁴/sec。该谱线的轮廓宽度和标准微观电场之间也有平方正比的关系。发现在本实验条件范围内,宽度和位移的比值γ/△保持为常数,其值为γ/△=10.4±0.6。由于谱项4²D的二级斯塔克效应的干扰而产生上能级4²F位移的理论计算虽能说明谱线位移和微观电场间的平方正比关系,但数值偏小于实验结果,指出还有电子贡献的部分。把光谱线的宽度和Lindholm理论公式及Griem等的近似公式作了比较;简单的估计指出,实验结果和后者符合较好。     

丁烯二酸三乙基锡酯的共聚

合成了顺-及反-丁烯二酸三乙基锡酯,并研究了它们和苯乙烯及甲基丙烯酸甲酯的共聚合反应。两种锡酯都能与苯乙烯共聚,与甲基丙烯酸甲酯未能得到共聚物。     

光声光谱法研究光学薄膜的吸收特性

本文以“一维热流活塞模型”为基础,推导出薄膜光声表达式,光声信号的幅值正比于吸收率.测量了透明基底上光学薄膜的光声吸收谱,实验结果与理论一致.尤其是测量弱吸收薄膜的吸收谱时,具有较高的灵敏度和实用性.     

5-羟基色胺类似物——Ⅲ.若干5-取代的2-二烃胺甲基苯并咪唑之合成

十二种4-取代的2-硝基-(二烴胺基乙酰)苯胺(Ⅰ_a-1)在稀醋酸中以次硫酸鈉处理,一步“还原环化”成相应的5-取代的2-二煙胺甲基苯并咪唑(Ⅱ_a-1).     

VOID FORMATION IN UNIDIRECTIONAL SOLIDIFICATION

Abstract

Visual and photographic observations of unidirectional solidification of liquids that shrink by about 10%% is reported. The liquid is contained in a constant-volume (sealed) cylindrical cell. To estimate the effect of gravity, cooling is provided from above or below. For degassed liquids, when solidified from below, it is observed that the shrinkage is accommodated at the top (like a cavity). However, when solidified from above, the shrinkage is accommodated by formation of voids and worms filled with vapor. The effect of dissolved gases is also investigated. It is observed that dissolved gases tend to distribute the voids for both solidification from below and above. Hence, dissolved gases may be used to control the location of shrinkage voids. Some discussions and predictions are made regarding the location of voids formed under zero gravity.     

两种型式水中用的压电水晶机电转换器

我们设计了并制造了两种不同型式的水中用水晶机电转换器:(i)镶嵌型,(ii)叠片型;尤其注意于水晶片的胶合、振动体的支持等问题,其目的在于减少转换器在无负荷时的等值电阻r。测得一个面积为609平方毫米其支持点完全自由的镶嵌型转换器的r为60kΩ;又测得另一个面积为256平方毫米四块水晶叠片型转换器的r焉15kΩ。再后讨论了两种型式转换器的优缺点,显见得叠片型的优于镶嵌型的很多,并进一步考虑了可能改进之点。     

复合聚合物CTNI/PMMA薄膜的制备及传输特性的研究

合成了一种新型有机金属配合物:[C16H33(CH3)3N]Ni(dmit)2(简称为CTNI),通过旋涂法制备了不同质量比的复合聚合物CTNI/PMMA薄膜,用视频摄像技术测量了其光传输损耗。结果表明,对8%质量分数掺杂浓度的CTNI/PMMA聚合物复合薄膜的光传输损耗为3.001dB/cm,随着CTNI在复合聚合物薄膜中浓度的增加,薄膜的光传输损耗线性增长。