T-STRESS IN PIEZOELECTRIC SOLID

The non-singular and bounded terms for stresses near the crack tip were investigated. The crack problem in a transversely isotropic piezoelectric solid for the plane problem was dealt with. The principle of superposition and the Plemelj formulation were introduced. The non-singular terms are given by solving Rieman-Hilbert problem. It is shown that the non-singular terms are influenced by the elastic and electric constants.     

The scattering of harmonic elastic anti-plane shear waves by two collinear cracks in the piezoelectric plate by using the non-local theory

In this paper, the dynamic interaction between two collinear cracks in a piezoelectric material plate under anti-plane shear waves is investigated by using the non-local theory for impermeable crack surface conditions. By using the Fourier transform, the problem can be solved with the help of two pairs of triple integral equations. These equations are solved using the Schmidt method. This method is more reasonable and more appropriate. Unlike the classical elasticity solution, it is found that no stress and electric displacement singularity is present at the crack tip. The non-local dynamic elastic solutions yield a finite hoop stress at the crack tip, thus allowing for a fracture criterion based on the maximum dynamic stress hypothesis. The project supported by the Natural Science Foundation of Heilongjiang Province and the National Natural Science Foundation of China(10172030, 50232030)     

微小型四旋翼无人机自主着陆视觉系统研究

以实现微小型四旋翼无人机依靠视觉信息完成自主着陆为目的,采用TI公司DM3730芯片作为核心处理器,构建一套自主着陆视觉导引信息处理系统;充分考虑了视觉系统的特点,选用小巧、便携、合理的实验硬件,通过对图像的前期处理,采用相对简单的视觉处理算法,识别出着陆标识,通过解算得到着陆信息并完成飞行器的自主着陆过程;实验结果表明,系统较为可靠,在常规条件下,该系统能够有效识别人工着陆标识,准确解算出着陆标识与飞行器的相对位置信息用于自主着陆导引。     

变分法在含边裂纹正交各向异性板中的应用

文中给出了含边裂纹正交各向异性板问题的特征函数展开式，然后利用变分法及边值条件确定展开式中的未知系数，从而可求得裂端应力强度因子。该方法即可应用于应力边界值和位移边界值问题，又适应混合边界值问题。数值计算结果证实了该方法的有效性。     

含有随机夹杂的统计非均匀弹性介质参数的分析

本文提出了随机点场理论用于研究含有随机夹杂的统计非均匀介质。本文不同于其它作者,一般均将随机理论建立在Eshelby的等效夹杂原理之上,而这里是建立在Kunin的微结构理论基础之上。作为理论的一个应用,本文对复合材料的有效模量及夹杂内部及周围微观场进行了计算。     

地面装备电源变换系统高低压线缆串扰仿真研究

电源变换系统中功率器件如MOSFET和IGBT开关管的高速切换将产生高幅值和宽频段的电磁干扰,是电动车辆最为常见也无法避免的电磁干扰源。同时,互连线缆是机电设备传递信号和能量的载体,是实现设备功能不可或缺的组成部分,线缆的天线效应使其成为设备产生电磁干扰的主要途径,是系统电磁兼容问题的主要根源之一。为了分析高压电源变换系统对低压控制系统的电磁耦合,以某典型地面装备电源变换系统IGBT开关管产生的脉冲宽度调制波（PWM波）作为电磁干扰源,以实装线缆作为分析对象,构建高低压线缆串扰模型,仿真分析不同线缆对地距离、线缆间距条件下单线、屏蔽线、双绞线等多类低压线缆的近端串扰电压,得出低压线缆的抗干扰性,为系统线缆的布线提供指导。     

锯齿波频率对介质阻挡放电光谱特性的影响

采用微间隙平行平板介质阻挡放电(DBD)装置,以氩气作为工作气体,研究了锯齿波激励下DBD的放电图像、发光信号、发射光谱与锯齿波频率的关系。研究发现随锯齿波频率增加,DBD会从均匀模式(低于10 kHz),经历微放电丝与均匀放电共存,并最终过渡到微放电丝占据全部的电极区(频率高于35 kHz)。外加电压和发光波形表明,锯齿波频率较低时的均匀放电对应高占空比的阶梯放电。随频率增大,出现微放电丝后,发光波形呈现多脉冲形式,且电压半周期中的发光脉冲个数随着锯齿波频率的增大而减小。当锯齿波频率高于35 kHz时,每半个电压周期的发光脉冲个数减小为一个(单脉冲放电)。通过对放电的发射光谱进行研究,发现发射光谱中包含氮分子的第二正带系(C3Π_u→B3Π_u),OH(A2Σ+→X2Π)和ArI的特征谱线。研究表明OH(308.8 nm)和ArI(750.4 nm)的谱线强度均随锯齿波频率的增大而增大。     

基于金线填充的双芯光子晶体光纤偏振分束器

提出了一种基于金线填充的双芯光子晶体光纤超短偏振分束器,并进行了有限元分析.金线表面激发的表面等离子激元与双芯光子晶体光纤纤芯模之间的强烈耦合,导致更短的偏振分束器长度和更大的工作带宽.与同类的偏振分束器相比,所提出的偏振分柬器能同时实现较短的长度和较高的消光比.数值结果表明,长度为0.263 mm的偏振分束器,在波长1.55 μm处消光比达-70 dB,-20 dB消光比带宽为124 nm.     

INVESTIGATION OF BEHAVIOR OF MODE-I INTERFACE CRACK IN PIEZOELECTRIC MATERIALS BY USING SCHMIDT METHOD

The behavior of a Mode-Ⅰinterface crack in piezoelectric materials was investigated under the assumptions that the effect of the crack surface overlapping very near the crack tips was negligible. By use of the Fourier transform, the problem can be solved with the help of two pairs of dual integral equations. To solve the dual integral equations, the jumps of the displacements across the crack surfaces were expanded in a series of Jacobi polynomials. It is found that the stress and the electric displacement singularities of the present interface crack solution are the same as ones of the ordinary crack in homogenous materials. The solution of the present paper can be returned to the exact solution when the upper half plane material is the same as the lower half plane material.