数字全息图变频采样研究

根据Whittaker-Shannon抽样定理,对菲涅耳全息图进行变频率采样,保证整个全息图各部分采样频率为该处相应空间频率的两倍,从而完全消除数字全息图由于采样冗余而带来全息图的信息冗余.并且,对变频采样后的全息图进行线性插值恢复即可获得良好的再现像质.实验和理论均证明了该方法的有效性和可行性,为全息图的信息存贮与传输提出一条新的思路.     

同轴相移数字全息中相移角的选取及相移误差的消除

基于两步同轴相移数字全息,首先从理论上分析了记录时不同相移角的选取及相移误差对再现像的影响,并给出了一种利用再现像所有抽样点的强度偏差之和作为评价标准,通过逐步改变理论设定相移角值来寻找实际相移角的相移误差消除新方法;其次对二步相移数字全息中记录时参考光波最佳相移角的选取作了计算机模拟,发现只有将参考光波的相移角选择在一定范围内,再现像的噪声较小;最后利用计算机模拟了相移误差消除,验证了所提方法的可行性.     

关于限制李超代数的分解

代数$A$ 称为不可分解的,如果 $A$ 不能分解成理想的直和.文中将证明满足$C(L_{\bar{0}})=C(L)=\{0\}$的限制李超代数能够分解成不可分解限制理想的直和,这种分解在不计理想次序的前提下是唯一的.而且还证明了限制李超代数的一些结果.     

EFFECT OF MOLECULAR WEIGHT OF PDMS ON MORPHOLOGY AND MECHANICAL PROPERTIES OF PP/PDMS BLENDS

 A series of polydimethylsiloxane (PDMS) with varied molecular weights (Mw = 3  106, 1  106 and 0.5  106) were melt blended with PP to investigate the effect of PDMS molecular weight (MW) on the morphology and mechanical properties of PP/PDMS blends. Scanning electron microscopic (SEM) examination showed that the size of PDMS domains was dependent on the MW of PDMS. It was found that the lower the value of PDMS MW, the better dispersion of the PDMS domains in the PP matrix. Tensile and Izod impact tests revealed that the addition of PDMS with lower MW would lead to a more significant increase in impact strength of the blends compared with the blends with higher MW ones, while the influence of the molecular weight on tensile strengths of the blends was relatively small in the MW range studied. Differential scanning calorimetry (DSC) results also showed that the crystallization temperature of PP was increased with decreasing PDMS MW, indicating a better nucleation capability of lower MW of PDMS. Melting flow rate (MFR) measurements indicated that the processibility of PP could be enhanced by adding PDMS, and again the lower MW PDMS resulted in better data. Our work demonstrates that not only the processibility but also the mechanical properties of PP could be enhanced to a more significant degree by using low MW PDMS than the higher ones.     

MEASUREMENTS OF CHAIN INTERPENETRATION OF POLYMER GLASSES

The concept of entanglement provides the basis of our current understanding of the flow behavior of polymer melts, Current techniques developed to investigate the degree of interpenetration of polymer chains only provide indirectly the information of the degree of entanglement in a relatively large scale （several to tens of nanometer）. In this article, we report ^1H-NMR spectroscopy with dipolar filters under fast magic angle spinning for probing chain interpenetration of polymer glasses at the molecular level.     

STUDY ON THE PROPERTIES OF BLEND OF NATURAL RUBBER LATEX/METHYL METHACRYLATE GRAFTED RUBBER LATEX BY GAMMA RADIATION

Natural rubber latex(NRL)and methyl methacrylate(MMA)grafted rubber latex were blended in different ratios and irradiated at various absorbed doses by gamma rays from Co-60 source at room temperature.The tensile properties, swelling ratio and permanent set were measured.The maximum tensile strength and modulus at 500% elongation were obtained at an absorbed dose of 8 kGy.Modulus increases from 6.99 MPa to 9.87 MPa for an increase in proportion of MMA grafted rubber from 40% to 60% in the blend at similar absorbed dose.Elongation at break and swelling ratio decrease with increasing absorbed dose as well as the MMA grafted rubber content in the blends.The decreasing trend of permanent set is high up to 5 kGy absorbed dose,and beyond that dose,it becomes almost flat.     

INVERSE OPALINE STRUCTURE TITANIA PHOTONIC CRYSTALS BY FUNCTIONALLY MODIFIED COLLOIDAL CRYSTALS TEMPLATING

Ordered macroporous titania photonic crystals （PCs） and photonic balls were fabricated by functional modified polymer colloidal crystals. The TiO2 PCs and balls formed through this method exhibit no cracks and lacunae in large areas on their surface and their inner structures.     

光学移相干涉仪抗振系统的鲁棒控制系统仿真分析

将被动抗振和主动抗振相结合的混合控制技术应用于解决光学移相干涉仪抗振系统的不确定性问题,其中主动抗振采用鲁棒控制策略.该方法克服了由模型和干扰所引起的不确定性,使得控制系统能够有效地抑制抗振模型的不确定性和外部振动的干扰.仿真结果表明,该方法使光学移相干涉仪在振动的干扰下具有较好的鲁棒稳定性和控制准确度.     

关于Hayman问题与分担值

设 f 为非常数亚纯函数, n(≥ 4)为正整数, a 为非零有穷复数. 若a 为f ⁿ与 (f ⁿ)′ 的CM分担值, 则nf ’=f.     

基于光纤光栅的高功率光纤激光器

分析了光纤光栅的选频原理以及光纤光栅基高功率光纤激光器的阈值特性和输出特性.采用紫外写入的光纤光栅做谐振腔,研制了全光纤结构的高功率光纤激光器,泵浦阈值为186 mW, 最大输出功率1.78 W,斜率效率59%,实验结果与理论分析基本吻合.