排序方式: 共有58条查询结果,搜索用时 15 毫秒
1.
2.
3.
采用不同老化温度(80、100、120和150℃)合成了一系列KIT-6载体,并通过浸渍法制备了相应的CeO_2/KIT-6催化剂。结合X射线衍射、N_2物理吸附、NH_3程序升温脱附、CO_2程序升温脱附、透射电子显微镜、傅里叶变换红外光谱和X射线光电子能谱等表征结果,详细考察了老化温度对KIT-6结构以及CeO_2/KIT-6催化剂直接催化CO_2和甲醇合成碳酸二甲酯(DMC)反应活性的影响。结果表明,不同老化温度下制备的KIT-6均保持其独特的三维孔道结构。随着老化温度升高,KIT-6比表面积先增大后减小,当老化温度为100℃时,KIT-6比表面积达到最大(683 m~2·g~(-1))。KIT-6较高的比表面积有利于提高CeO_2分散度,进而提高暴露的活性位点数量,催化活性随催化剂表面中等碱/酸性吸附位数量和Ce~(3+)含量的增加而逐渐提高。其中,CeO_2/100-KIT-6催化剂中CeO_2颗粒尺寸最小(5.9 nm),暴露的活性位数量最高,催化活性最佳。随后,考察了反应温度和压力对CeO_2/100-KIT-6催化活性的影响。随着反应温度提高,催化活性先升高后降低,当反应温度为140℃时,催化活性最高;且催化活性随反应压力的提高而逐渐增加。在反应温度为140℃、压力为6.8 MPa条件下,催化剂经6次循环后,DMC收率由15 mmol·g_(CeO_2)~(-1)逐渐降低至2.8 mmol·g_(CeO_2)~(-1),原因归结为反应过程中CeO_2纳米颗粒发生团聚,使暴露出的活性位数量减少。 相似文献
4.
The correlation between neutron-to-proton yield ratio (Rnp) and neutron skin thickness (δnp) in neutron-rich projectile induced reactions is investigated within the framework of the Isospin-Dependent Quantum Molecular Dynamics (IQMD) model. The density distribution of the Droplet model is embedded in the initialization of the neutron and proton densities in the present IQMD model. By adjusting the diffuseness parameter of neutron density in the Droplet model for the projectile, the relationship between the neutron skin thickness and the corresponding Rnp is obtained. The results show strong linear correlation between Rnp and δnp for neutron-rich Ca and Ni isotopes. It is suggested that Rnp may be used as an experimental observable to extract δnp for neutron-rich nuclei, which is very interesting in the study of the nuclear structure of exotic nuclei, the equation of state (EOS) of asymmetric nuclear matter and neutron-rich matter in astrophysics, etc. 相似文献
5.
6.
We study the dissipative quantum phase transition(QPT)in a biased Tavis–Cummings model consisting of an ensemble of two-level systems(TLSs)interacting with a cavity mode,where the TLSs are pumped by a drive field.In our proposal,we use a dissipative TLS ensemble and an active cavity with effective gain.In the weak drive-field limit,the QPT can occur under the combined actions of the loss and gain of the system.Owing to the active cavity,the QPT behavior can be much differentiated even for a finite strength of the drive field on the TLS ensemble.Also,we propose to implement our scheme based on the dissipative nitrogen-vacancy(NV)centers coupled to an active optical cavity made from the gainmedium-doped silica.Furthermore,we show that the QPT can be measured by probing the transmission spectrum of the cavity embedding the ensemble of the NV centers. 相似文献
7.
针对雷达体制反舰导弹矢量脱靶量测量系统在复杂电子干扰环境中存在的不足,在建立被动声定位模型后,基于极大似然估计思想,采用搜索方式解算反舰导弹攻靶段飞行轨迹的最优解。仿真计算结果表明,当反舰导弹在靶船上方飞过时,绝大部分区域解算精度优于2m,满足试验评定要求。 相似文献
8.
以乙酰丙酮铜Cu(acac)2为铜源、 NH4Y分子筛为载体, 采用固相反应制备了无氯CuY催化剂, 考察了在甲醇氧化羰基化合成碳酸二甲酯过程中固相反应温度和Cu负载量对CuY催化剂催化性能的影响, 分析了CuY催化剂物相结构、 可还原性Cu物种和织构性质对催化性能的影响. 结果表明, 随着固相反应温度的升高, 与NH4Y中N 发生离子交换的Cu2+交换度和活性中心Cu+含量先增大后降低, CuY催化剂活性也呈现出相同的变化趋势; 负载量(质量分数)低于10%时, 受分子筛残留B酸位影响, 碳酸二甲酯的选择性较低, 而负载量高于12%时, CuY催化剂中出现了CuO物种, 且粒子逐渐长大, 覆盖部分活性中心, 甚至堵塞孔道, 使催化剂活性降低. 当固相反应温度为250 ℃, Cu负载量为12%时, 活性中心Cu+含量最高, 催化剂表现出最佳的催化活性, 碳酸二甲酯基于甲醇的时空收率为267.3 mg·g-1·h-1, 甲醇转化率为6.9%, 碳酸二甲酯(DMC)的选择性为69.2%. 相似文献
9.
本实验以钛酸四丁酯为钛源,醋酸镉为镉源,利用静电纺丝的方法制备了直径~250 nm的电纺丝纳米纤维。通过高温煅烧和硫化钠溶液进行水热处理,得到CdS超薄片层包覆TiO2中空结构的纳米纤维。推测该复合结构形貌的形成过程为:在Ti/Cd(摩尔比)为1:1和2:1时,由于CdO的含量较高,反应过程中CdO溶解,并与反应溶液中的S2-形成CdS超薄片层生长在纤维的外表面,剩余的TiO2纳米粒子聚集形成中空的纳米管状结构;而Ti/Cd(摩尔比)为4:1和8:1时,由于溶解的CdO较少不足以形成TiO2纳米管,同时,生成的CdS也不足以完全包覆TiO2纳米纤维形成非管状结构。当Ti/Cd为1:1时,TiO2@CdS复合材料具有最好的产氢活性。在300 W氙灯光照条件下和加UVCUT-420 nm滤光片下,50 mg催化剂产氢速率分别为19.7 μmol/h和3.4 μmol/h,这主要是由于所得到的复合结构中TiO2为非晶材料。进一步在惰性气氛下煅烧,也很难将TiO2晶化。 相似文献
10.
高压变质二氧化硅矿物的合成及表征 总被引:1,自引:0,他引:1
根据高能机械球磨与地球板块碰撞之间具有的碰撞局域性和剪切应力相似的特点, 采用高能机械球磨和静高温高压技术, 以α-石英与石墨混合粉末为原料, 提出了人工合成地表柯石英的一种新方法. 利用高能机械球磨制备了α-石英和石墨纳米非晶混合粉末, 其高温高压合成柯石英的最低条件是970 K和3.7 GPa. 合成的柯石英有10个Raman峰, 分别位于120, 152, 179, 206, 270, 329, 357, 428, 467和521 cm-1, 是目前最全的柯石英Raman谱. 相似文献