LD泵浦Nd∶LuVO4/Cr4+∶YAG被动调Q激光器

采用大功率半导体激光器端面泵浦Nd∶LuVO4晶体，利用Cr4+∶YAG晶体作为可饱和吸收元件，实现了1.06 μm激光的被动调Q运转.在泵浦功率为19.1 W时，获得最高平均输出功率为4.58 W，脉冲宽度为84 ns，单脉冲能量为36.6 μJ以及峰值功率为436.2 W的激光脉冲.     

Hierarchical structures in a turbulent pipe flow

A hierarchical structure (HS) analysis (β-test and γ-test) is applied to a fully developed turbulent pipe flow. Velocity signals are measured at two cross sections in the pipe and at a series of radial locations from the pipe wall. Particular attention is paid to the variation of turbulent statistics at wall units 10<y⁺<3000. It is shown that at all locations the velocity fluctuations satisfy the She–Leveque hierarchical symmetry (Phys. Rev. Lett. 72 (1994) 336). The measured HS parameters, β and γ, are interpreted in terms of the variation of fluid structures. Intense anisotropic fluid structures generated near the wall appear to be more singular than the most intermittent structures in isotropic turbulence and appear to be more outstanding compared to the background fluctuations; this yields a more intermittent velocity signal with smaller γ and β. As turbulence migrates into the logarithmic region, small-scale motions are generated by an energy cascade and large-scale organized structures emerge which are also less singular than the most intermittent structures of isotropic turbulence. At the center, turbulence is nearly isotropic, and β and γ are close to the 1994 She–Leveque predictions. A transition is observed from the logarithmic region to the center in which γ drops and the large-scale organized structures break down. We speculate that it is due to the growing eddy viscosity effects of widely spread turbulent fluctuations in a similar way as in the breakdown of the Taylor vortices in a turbulent Couette–Taylor flow at high Reynolds numbers.     

Faraday镜预转角对FMOCT输出光偏振态的影响

通过计算机仿真，运用琼斯矩阵理论分析了Faraday镜预转角对法拉第镜式光学电流互感器输出光偏振态的影响.实验测量了Faraday镜实际预转角的大小，测量了外磁场的改变对Faraday镜预转角的影响.外磁场的存在和变化使Faraday镜预转角偏离初始值，并使系统输出光由理想状态下的线偏振光退化成椭圆偏振光，并引起法拉第镜式光学电流互感器工作灵敏度和稳定性的下降.提出了用电磁屏蔽解决外界磁场影响的方法.     

镧掺杂水滑石材料的热分解过程研究

采用共沉淀法制备了系列La掺杂改性的含Cu类水滑石,高温焙烧得到其衍生混合氧化物材料,并用XRD,TG-DSC,FT-IR等对材料进行表征.结果表明,前驱物XRD图谱呈典型的水滑石衍射特征且颗粒结晶良好;经800℃焙烧后,掺杂La2O3含量为5.1%的样品仅有Mg1-xFexO晶相出现,说明La的掺杂提高了材料的高温稳定性,混合氧化物中的Cu离子呈高分散状态.     

A supported gold catalyst for the elimination of hydrogen from CO2 feed gas in the production of urea

Supported gold catalyst for eliminating hydrogen from CO₂ feed gas in the production of urea is found to be superior to other industrial catalysts (e.g. Pt/Al₂O₃ and PdPt/Al₂O₃) in catalytic activity and resistance to sulfur poisoning.     

镧掺杂粘土源含铜氧化物催化剂的制备、表征及催化性能

采用共沉淀和水热法合成了不同阴离子粘土前驱型复合氧化物催化材料,样品经XRD,FTIR,TPR,TG-DSC,SEM进行表征.同时考察了铜含量在掺杂和不掺杂稀土时对甲烷催化燃烧的影响,结果发现随含铜量增加催化活性增加;未掺杂La的催化剂在高温下出现失活现象,而掺杂型催化剂稳定性良好.同时,制备方法对催化剂的性能有显著影响,在不同制备前驱物pH的条件下,使用共沉淀和水热法合成的阴离子粘土材料,合成时的pH均对催化剂的活性影响较大;同时焙烧温度对催化活性有不同程度的影响.     

电化学法测定几种稀土贮氢合金的热力学函数

贮氢材料由于能可逆地吸放氢,得到了广泛地应用.特别是以贮氢材料为负极制成的氢镍二次电池,容量为同类型镉镍电池的1.5～2倍,且电压又相近,是镉镍电池的理想换代产品,受到人们普遍的关注。LaNi_(4.5)Mn_(0.5),LaNi_(4.9)Sn_(0.1)和La_(0.8)Nd_(0.2)Ni_(2.5)Co_(2.4)Al_(0.1)是电化学性能较优越的贮氢合金。LaNi_(4.5)Mn_(0.5)的电化学容量高,理论容量可达400mAh.g~(-1).LaNi_(4.9)Sn_(0.1)和La_(0.8) Nd_(0.2)     

共振光散射法研究脱氧核糖核酸与多胺的相互作用及精胺的测定

在一定条件下,精胺不仅能够与脱氧核糖核酸(DNA)大沟嵌入结合,还能与DNA链上的碱基和磷酸基进行链内结合和跨链结合,形成致密的环状螺旋结构,造成DNA的凝聚,从而使DNA共振光散射(RLS)强度强烈地增强。增强的共振光散射强度与精胺的浓度呈现良好的线性关系,线性范围为5.0×10-7~1.0×10-5mol/L;校正曲线的回归方程为IRLS=40.22 5.28×107C(mol/L),相关系数r=0.9936;检出限(3σ)为7.4×10-8mol/L。在测定精胺的线性范围内,其它多胺(亚精胺,腐胺)、蛋白质及常见的金属离子不干扰测定。该方法用于测定新几内亚凤仙中的精胺,获得满意结果。     

Sol-gel polycondensation of methyltrimethoxysilane in ethanol studied by <Superscript>29</Superscript>Si NMR spectroscopy using a two-step acid/base procedure

Sol-gel polymerization of methyltrimethoxysilane (MTMS) in ethanol using a two-step acid/base catalyzed procedure (B2) is followed by ²⁹Si NMR spectroscopy. Analysis of the structural evolution of the B2 system shows that esterification of monomeric and end silicon species is rate-limited while that of linear and cyclic species is able to reach pseudoequilibrium in the second basic step. Condensation reactivity is reduced with increasing network connectivity, however, to a much less degree under B2 conditions than MTMS polymerization under acidic conditions. Steric effects as well as many other factors are attributed to this trend. The concentration of cyclic and polycyclic species of the B2 system is nearly 3 times lower compared to the acid-catalyzed system. The empirical degree of condensation at the gel point is determined to be 0.88. The effects of cyclization and phase separation on MTMS gelation are discussed for both B2 and acid-catalyzed systems. Based on these results it is believed that MTMS-based gels form for B2 and not acid-catalyzed conditions due to reduced cyclization, rapid hydrolysis and condensation, effective use of functional groups, and effective contribution of branched and polycyclic species as crosslinking points to connect polymeric chains in the B2 system.     

结晶聚合物品相相容性的研究

通过ＤＳＣ、Ｘ－射线衍射、红外光谱及拉伸试验研究了ＨＤＰＥ与ＬＬＤＰＥ、ＨＤＰＥ与ＬＤＰＥ之间的晶相相容性．结果表明，链结构相近的ＨＤＰＥ和ＬＬＤＰＥ的晶相相容性好，能形成共晶；而链结构差异较大的ＨＤＰＥ和ＬＤＰＥ的晶相相容性较差，倾向于分别结晶，但有部分链段被对方的晶区夹持．不论是支化度大的ＬＤＰＥ链段插入以ＨＤＰＥ为主的晶区，还是支化度小的ＨＤＰＥ链段插入以ＬＤＰＥ为主的晶区，都可破坏晶区的规整性．共晶的形成使共混物的熔点、结晶度、晶粒体积等低于两组份的线性加和，而力学性能，尤其是断裂伸长率，则显著提高，呈协同效应．