ON THE ASYMPTOTIC BEHAVIOUR OF THE STEADY SUPERSONIC FLOWS AT INFINITY

This paper studies the asymptotic behaviour of steady supersonic flow past a piece-wise smooth corner or bend. Under the hypothese that both vertex angle and the total variation of tangent along the boundary are small, it is shown that the solution can be obtained by a modified Glimm scheme, and that the asymptotic behaviour of the solution is determined by the velocity of incoming flow and the limit of the tangent of the boundary at infinity.     

Microstructure of a-SiOx:H

A set of a-SiO_x:H (0.52 <x< 1.58) films are fabricated by plasma-enhanced-chemical-vapor-deposition (PECVD) method at the substrate temperature of 250°C. The microstructure and local bonding configurations of the films are investigated in detail using micro-Raman scattering, X-ray photoelectron spectroscopy (XPS) and Fourier transform infrared spectroscopy (FTIR). It is found that the films are structural inhomogeneous, with five phases of Si, Si₂O:H, SiO:H, Si₂O₃:H and SiO₂ that coexist. The phase of Si is composed of nonhydrogenated amorphous silicon (a-Si) clusters that are spatially isolated. The average size of the clusters decreases with the increasing oxygen concentration x in the films. The results indicate that the structure of the present films can be described by a multi-shell model, which suggests that a-Si cluster is surrounded in turn by the subshells of Si₂O:H, SiO:H, Si₂O₃:H, and SiO₂.     

MORPHOLOGIES AND GAS SEPARATION PROPERTIES OF MELT-SPUN ASYMMETRIC POLY(4-METHYL-1-PENTENE)HOLLOW FIBER MEMBRANES*

Poly(4-methyl-1-pentene) (PMP) hollow fiber membranes were prepared by the melt-spun and cold-stretch(MSCS) method. Scanning electronic microscopy (SEM) was used to characterize the section and surface structures of themembranes with special asymmetric structure. The preliminary results of gas permeation measurements indicated that the resultant hollow fiber membranes have the potential ability for oxygen/nitrogen separation.     

含铈不锈钢的抗菌性能

以00Cr18Ni9不锈钢成分为基础,添加0～5%的稀土元素铈（Ce）.利用电子探针分析了加铈（Ce）不锈钢中Ce的分布;用化学分析法测定了含铈不锈钢中铈（Ce）和碳（C）的含量;用X射线衍射方法测试了含铈（Ce）不锈钢中铈（Ce）的析出相成分;采用贴膜法测试了含Ce不锈钢对大肠杆菌ATCC 8099、金黄色葡萄球菌ATCC 6538的抗菌性能.结果表明： 含Ce不锈钢具有优异的抗菌性能,与含Cu抗菌不锈钢相比,含Ce不锈钢无需时效热处理就具有优异的抗菌性能.并讨论了含Ce不锈钢的抗菌机制.     

碘化物-罗丹明B体系荧光猝灭反应测定痕量亚硝酸根

拟定了一个荧光猝灭法测定痕量亚硝酸根的新方法。在盐酸介质中，亚硝酸根氧化 碘化钾的反应，其反应产物Ｉ３－使罗丹明Ｂ荧光猝灭。方法的检出限为３．６μｇ／Ｌ；测定范围为 １０～１２０μｇ／Ｌ。方法简便快速、选择性好，用于自来水，矿泉水及合成样品中亚硝酸根的测定， 结果满意。     

二氯化-N,N-′-二(3-脱氢松香酰氧-2-羟丙基)四甲基乙二胺的合成与性能

研究了Gemini表面活性剂中疏水"尾巴"结构对性质的影响,以脱氢松香酸和环氧氯丙烷为原料合成了中间体3-脱氢松香酰氧-2-羟丙基氯,再与四甲基乙二胺反应,得到1种以脱氢松香酰基为疏水链"尾巴"的对称Gemini型双季铵盐阳离子表面活性剂:二氯化-N,N′-二(3-脱氢松香酰氧-2-羟丙基)四甲基乙二胺。在合成工艺条件的基础上,采用IR光谱、MS谱和元素分析测试技术对产物进行了结构确认。结果表明,该产物可降低水的表面张力达34.9 mN/m,临界胶束浓度为1.0×10-4mol/L。表明具有良好疏水性能的2个大"尾巴"使合成的Gemini表面活性剂更易形成胶束,大大提高了表面活性。     

Preparation of dendritic‐like CdS by hydrothermal method and its photocatalytic performance

In this article, dendritic‐like CdS has been prepared by a hydrothermal method using thiourea as the sulfur source, and the effects of experimental conditions on the morphologies of CdS have been investigated. The performances of CdS have been analyzed by X‐ray diffraction (XRD), field emission scanning electron microscopy (FESEM), and the fluorescence and photodegradation properties of CdS have also been investigated. The XRD result indicates that the dendritic‐like CdS are of hexagonal phase and they are highly crystallized. Also, the FESEM results show that the ratio of raw material affects the yield of CdS, the reaction time affects the morphology of CdS. The best morphology of CdS is dendritic structures and the length is about 6 μm. The fluorescence spectrum shows three peaks at 470 nm, 513 nm and 547 nm, which indicates that the dendritic‐like CdS mainly emits green and blue fluorescence. Moreover, the dendritic‐like CdS exhibits good photocatalytic activity and its photodegradation rate to methylene blue can reach 92%. The growth mechanism for the formation of CdS with dendritic structure is also described.     

Optical properties of flower‐like CdS prepared by a hydrothermal method with SDBS as surfactant

In this article, flower‐like CdS structures have been prepared by a hydrothermal method with SDBS as surfactant. The influences of different experimental conditions on the morphologies, UV‐Vis and fluorescence properties of CdS have been investigated. The performances of CdS have been analyzed by X‐ray diffraction (XRD), field emission scanning electron microscopy (FESEM), ultraviolet‐visible (UV–Vis) and room‐temperature photoluminescence (PL). The XRD result indicates that the flower‐like CdS structures are of hexagonal phase. The FESEM results indicate that the main role of SDBS is to make the CdS crystals assemble together to form the flower‐like structures. The UV–Vis results show CdS has a strong absorption in the ultraviolet region and visible‐light region. The PL results show CdS has two emission peaks, respectively at 461 nm and 553 nm. The growth mechanism for the formation of flower‐like CdS structures is also described.     

Two new secoiridoid glucosides from Syringa velutina Kom

Chemical investigation of Syringa velutina Kom. led to the isolation of two new secoiridoid glucosides. Their structures were identified as 6'-0-(6, 7-dihyrofoliamenthoyl)-8-epi-kingisidic acid (syrveoside A, 1) and 6'-O-menthiafoloyl-8-epi-kingisidic acid (syrveoside B, 2) on the basis of chemical and physicochemical evidence.