Urea method for the synthesis of hydrotalcites

Mg-Al, Zn-Al and Ni-Al hydrotalcite-like compounds with high crystallinity were synthesized by using the decomposing property of urea at high temperature. The crystallinity and the regularly of the samples were much preferable to those synthesized by other methods. This revised version was published online in June 2006 with corrections to the Cover Date.     

大学物理实验教学改革的实践与思索

本主要介绍了我校近年来在大学物理实验课程体系和教学内容改革的实践及下一步改革的思路。     

聚能射流的断裂时间

从描述聚能射流失稳的一维近似方程出发，导出了聚能射流断裂时间的近似公式。这个近似公式定量显示了屈服应力、本构关系、粘度和径向收缩效应等对射流断裂时间的影响，在４个不同的特殊近似下，可以自然演化为近１０年来所发表的几个半经验解析公式，并且在合理的参数范围内，公式给出的断裂时间曲线覆盖了射流断裂时间的全部实验点。     

Further study of the viscoelastic phase separation of cyanate ester modified with poly(ether imide)

In this study, the viscoelastic phase separation process was studied further by time‐resolved light scattering, differential scanning calorimetry, and scanning electron microscopy in the system of poly(ether imide)‐modified bisphenol‐A dicyanate. It was observed that the evolution time of phase structure and relaxation time of diffusion flow of the bisphenol‐A dicyanate were similar with the phase diagram of curing conversion versus content of PEI. The results suggested that the viscoelastic phase separation was affected by the curing conversion of the system at the onset point of phase separation. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 517–523, 2006     

电化学合成聚苯胺粉末电极的电化学行为研究

我们曾用慢速动电位扫描法研究化学合成聚苯胺粉末的电化学行为.本文对恒电位电解合成聚苯胺粉末进行了研究.用这种方法制备的粉末由于合成溶液中不含氧化剂因而纯度高.本文还报导了这种聚苯胺粉末电极的交流阻抗测量结果.交流阻抗法曾用于聚苯胺膜的电导和化学合成聚吡咯的电阻测定. 所用盐酸、氟硼酸、硅氟酸、苯胺均为分析纯;苯胺经常压蒸馏提纯;硫酸为超纯;磷酸为分析纯;高氯酸为优级纯.溶液皆用两次蒸馏水配制.     

ABO_3，A_2BO_4型复合氧化物催化剂用于CO，CH_4，NH_3完全氧

本文探讨了ＣＯ，ＣＨ＿４和ＮＨ＿３在ＬａＮｉＯ＿３，Ｌａ＿２ＮｉＯ＿４和ＬａＳｒＮｉＯ＿４三个催化剂上的氧化行为，并得出结论：对于ＣＯ氧化，关键步骤在于ＣＯ在催化剂表面上的络合活化。Ｎｉ￣（３＋）含量越高，越利于ＣＯ的络合活化。对于氨氧化，催化反应遵循氧化－还原机理。Ｎｉ￣（３＋）是主要的活性离子，晶格氧是主要活性氧种。对于ＣＨ＿４氧化，催化机理较复杂，只是发现Ａ＿２ＢＯ＿４型氧化物（Ｌａ＿２ＮｉＯ＿４，ＬａＳｒＮｉＯ＿４）比ＡＢＯ＿３型氧化物（ＬａＮｉＯ＿３）较利于ＣＨ＿４的氧化。     

Study of quasi-monodisperse In2O3 nanocrystals: synthesis and optical determination

In this communication, we report a successful synthesis of quasi-monodisperse In2O3 nanocrystals with high crystallinity in a high-temperature organic solution. The average size of nanocrystals can be tuned using a dynamic injection technique. TEM and XRD investigations indicate that each nanocrystal is a single crystal. The optical determination implies that the photoluminescence behavior of these In2O3 nanocrystals is different from that of the bulk, probably due to the combination of weak quantum-confinement-effects and the nature of high crystallinity in nanocrystals.     

压缩X因子导数光谱法测定痕量锗

本采用压缩Ｘ因子导数光谱技术实现了宽峰体系灵敏度的大幅度提高，提出了测定痕量锗的方法。在０．７２ｍｏｌ／ＬＨ２ＳＯ４和３．０ｍｏｌ／ＬＨ３ＰＯ４的混酸介质中，锗－水杨基荧光酮－ＯＰ三元显色体系的压缩Ｘ因子四阶导数光谱摩尔响应系数达１．８９×１０＾６Ｌ．ｍｏｌ＾－１．ｃｍ＾－１，灵敏度比常规光度法高１２．４倍；最低检测出限为０．０００３３ｍｇ／Ｌ，比常规光谱法低４倍；选择性也进一步提高，绝大多数离     

Sn/Al2O3催化剂结构与选择性催化还原NO性能

以不同沉淀剂和铝盐与SnCl4共沉淀制备了Sn/Al2O3催化剂.考察了催化剂在富氧条件下催化丙烯选择性还原NO的性能,借助于X射线衍射(XRD)、扫描电镜(SEM)、N2吸附-脱附、吡啶吸附红外光谱(Py-IR)和程序升温还原(TPR)等方法研究了催化剂性能与结构的关系.发现以NH3.H2O和NH4HCO3为沉淀剂、NH4Al(SO4)2为铝盐制备的Sn/Al2O3催化剂催化活性最高,NO转化率达90.9%,最佳催化活性温度为350℃.该催化剂的比表面积为254 m2/g,孔体积为0.878 cm3/g,孔径分布曲线在3~8 nm出现双峰,Sn物种主要以晶态SnO2存在,且表面Lewis酸酸量增加.     

Polymerization-induced viscoelastic phase separation in polyethersulfone-modified epoxy systems

The polymerization-induced phase-separation process of polyethersulfone (PES)-modified epoxy systems was monitored in situ continuously on a single sample throughout the entire curing process by using optical microscopes, time-resolved light scattering (TRLS), scanning electronic microscopes (SEM), and a rheometry instrument. At specific PES content a viscoelastic transformation process of phase inversion morphology to bicontinuous was found with an optical microscope. The rheological behavior during phase separation corresponds well with the morphology development. Light-scattering results monitoring the phase-separation process of systems with final phase inversion morphology show a typical exponential decay procedure of scattering vector qm. The characteristic relaxation time of phase separation can be described well by the WLF equation.