Crosslinking network of bio‐based bis‐functional epoxides derived from trans‐limonene oxide

The thiol‐ene reaction between trans‐limonene oxide (trans‐LO) and ethane‐1,2‐dithiol in the presence of triethylborane affords a bio‐based bis‐functional epoxide (bis‐trans‐LO). The crosslinking reaction of bis‐trans‐LO with branched polyethyleneimine (BPEI; M_n = 600; BPEI₆₀₀) at a feed ratio of bis‐trans‐LO/BPEI₆₀₀ = 57/43 (wt/wt) yields the corresponding network polymer with T_d10 (10% thermal decomposition temperature) of 304.7 °C in 98% yield. In contrast, negligible amounts of network polymer are obtained by the reaction of bis‐LO (bis‐functional epoxide derived from cis and trans‐LO) and BPEI₆₀₀ regardless of the feed ratio. The mechanical strengths as measured by direct tensile tests of the network polymers derived from bis‐trans‐LO and BPEI_600,1800 (M_n = 600 and 1800) were approximately 16 and 11 times higher than that of bis‐LO and BPEI₁₈₀₀, respectively. The tensile shear strengths of the metal‐to‐metal adhesive bonds induced by bis‐trans‐LO and BPEI_600,1800 were 9.5 and 14.1 MPa, respectively. DMA revealed that the storage modulus of the network polymer derived from bis‐trans‐LO and BPEI₁₈₀₀ in the rubber region was higher than that of the material prepared from bis‐LO and BPEI₁₈₀₀, indicating higher crosslink density of the bis‐trans‐LO/BPEI₁₈₀₀ system. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019 , 57, 2466–2473     

双奇核188Au的准粒子带结构研究

利用在束γ谱学实验技术, 通过¹⁷³Yb(¹⁹F,4nγ)反应 布居了¹⁸⁸Au的高自旋态, 并对其准粒子带结构进行了研究. 基于实验测量结果, 对原有的双奇核¹⁸⁸Au能级纲图做了较大的修改. 通过系统性比较, 对15⁺以上的能级结构进行了讨论.     

Major-to-ultratrace elements in bone-marrow fluid as determined by ICP-AES and ICP-MS.

The major-to-ultratrace elements in human bone-marrow fluid were determined by ICP-AES (inductively coupled plasma atomic emission spectrometry), and ICP-MS (inductively coupled plasma mass spectrometry). The bone-marrow fluid sample was centrifuged prior to acid digestion to exclude the bone piece from bone marrow, and then digested with nitric acid. As a result, 20 elements could be determined over the concentration range from 1610 microg g(-1) for Na to 0.00043 microg g(-1) for W. It was found that Fe, Zn and Sb were enriched by ca. 264-, 7- and 15-fold, respectively, in bone-marrow fluid, compared to those in human blood serum. Alkali metals (K, Rb, Cs), except for Na, were also significantly enriched in bone-marrow fluid. Furthermore, the concentrations of various elements, such as Fe, P, Al, Zn, Cu, Se, Zr, Sn, Ag and W, were significantly higher than those in open seawater.     

Holomorphic Maps of Compact Generalized Hopf Manifolds

We investigate holomorphic maps between compact generalized Hopf manifolds (i.e., locally conformal Kähler manifolds with parallel Lee form). We show that they preserve the canonical foliations. Moreover, we study compact complex submanifolds of g.H. manifolds and holomorphic submersions from compact g.H. manifolds.     

Cluster and periodic DFT calculations of adsorption and activation of CO2 on the Cu(hkl) surfaces

The adsorption behavior and thermal activation of carbon dioxide on the Cu(1 1 1), Cu(1 0 0), and Cu(1 1 0) surfaces have been investigated by means of density functional theory calculations and cluster models and periodic slabs. According to the cluster models, the optimized results indicate that the basis set of C and O atoms has a distinct effect on the adsorption energy, but an indistinct one on the equilibrium geometry. For the CO₂/Cu(hkl) adsorption systems studied here, the final structure of adsorbed CO₂ is near linear and the preferred modes for the adsorption of CO₂ onto the Cu(1 1 1), Cu(1 0 0), and Cu(1 1 0) surfaces are the side-on adsorption at the cross bridge site with an adsorption energy of 13.06 kJ/mol, the side-on adsorption at the short bridge site (13.54 kJ/mol), and the end-on adsorption on the on-top site with C–O bonds located along the short bridge site (26.01 kJ/mol), respectively. However, the calculated adsorption energies from periodic slabs are lower as compared to the experimental data as well as the cluster model data, indicating that the periodic slab approach of generalized gradient approximation in the density function theory may be not suitable to obtain quantitative information on the interaction of CO₂ with Cu(hkl) surfaces.     

Mass spectrometric analysis of low molecular mass polyesters by laser desorption/ionization on porous silicon

A low molecular mass polyester was analyzed by desorption/ionization on porous silicon (DIOS) mass spectrometry. The results were compared with those of matrix-assisted laser desorption ionization (MALDI) mass spectrometry using matrixes of alpha-cyano-4-hydroxycinnamic acid (CHCA) and 10,15,20-tetrakis(pentafluorophenyl)porphyrin (F20TPP). The CHCA matrix was not suitable for characterization of low molecular mass components of the polyester because the matrix-related ions interfered with the component ions. On the other hand, the F20TPP matrix showed no interference because no matrix-related ions appeared below m/z 822. However, the solvent selection for determining optimal conditions of sample preparation was limited, because F20TPP does not dissolve readily in any of the available organic solvents. In the DIOS spectra, the polymer ions were observed at high sensitivity without a contaminating ion. No matrix is needed for DIOS spectra of low molecular mass polyesters, facilitating sample preparation and selectivity of a precursor ion in post-source decay measurements.     

Influence of shell strength on shape transformation of micron-sized,monodisperse, hollow polymer particles

Micron-sized, monodisperse, non-spherical polymer particles with "rugby ball" and "red blood corpuscle"-like shapes were produced by seeded polymerization of the dispersion of (divinylbenzene/vinylbiphenyl/xylene)-swollen polystyrene particles prepared by utilizing the dynamic swelling method which the authors proposed in 1991. Their non-spherical shapes were based on buckling of the shell of the resultant hollow particles. In this article, the reversible shape transformation of the hollow composite polymer particle between spherical and such non-spherical shapes was studied in detail by controlling the shell strength. A part of the shell was buckled by external pressure which was caused by evaporation of xylene from the hollow when the shell had the tensile modulus below the critical value calculated from the pressure-buckling relationship of a spherical shell proposed by Uemura. The plasticization of the shell by a good solvent was one of key factors for the shape transformation.