A theory of finite tensile deformation of double-network hydrogels

A continuum damage model was developed to describe the finite tensile deformation of tough double-network (DN) hydrogels synthesized by polymerization of a water-soluble monomer inside a highly crosslinked rigid polyelectrolyte network. Damage evolution in DN hydrogels was characterized by performing loading-unloading tensile tests and oscillatory shear rheometry on DN hydrogels synthesized from 3-sulfopropyl acrylate potassium salt (SAPS) and acrylamide (AAm). The model can explain all the mechanical features of finite tensile deformation of DN hydrogels, including idealized Mullins effect and permanent set observed after unloading, qualitatively and quantitatively. The constitutive equation can describe the finite elasto-plastic tensile behavior of DN hydrogels without resorting to a yield function. It was showed that tensile mechanics of DN hydrogels in the model is controlled by two material parameters which are related to the elastic moduli of first and second networks. In effect, the ratio of these two parameters is a dimensionless number that controls the behavior of material. The model can capture the stable branch of material response during neck propagation where engineering stress becomes constant. Consistent with experimental data, by increasing the elastic modulus of the second network the finite tensile behavior of the DN hydrogel changes from necking to strain hardening.     

Formation of low-temperature deformation-induced segregations of nickel in Fe–Ni-based austenitic alloys

ABSTRACT

The authors present the results of an investigation in Fe–Ni-Cr austenitic alloys of the low-temperature deformation-induced segregations of nickel that form in the micro regions being (i) located close to grain- and subgrain boundaries and (ii) characteristic of the concentration and magnetic inhomogeneities indicated by the appearance of a dark diffraction contrast at the electron diffraction patterns taken from these regions typical (at the same time) of an enhanced value of Curie temperature. The observed effects were connected with the micro distortions caused by the local change of lattice parameter because of an increase in nickel concentration, as well as in the result of a magnetostriction dilatation. Using methods of the X-ray energy dispersive spectroscopy (XEDS) and atomic-probe body-section radiography (tomography – APT) has made it possible to determine the borders of those regions of austenite that were characteristic of an enhanced concentration of nickel in the fields of the localisation of a deformation-induced segregation of nickel in the vicinity of grain (subgrain) boundaries of austenitic alloys of the types Fe–13Cr–30Ni and Fe–37Ni–3Ti.     

ZnO nanowire lines and bundles: Template-deformation-guided alignment for patterned field-electron emitters

One-dimensional ZnO materials have been promising for field-emission (FE) application, but how to facially control the alignment of ZnO emitters is still a great challenge especially for patterned display application. Here, we report the fabrication of novel ZnO nanowire (NW) line and bundle arrays for patterned field-electron emitters. The effects of PS template size and heating time on the resulted ZnO nanoarrays were systematically studied. The deformation degree of PS templates was controlled and hence utilized to adjust the alignment of electrochemically deposited ZnO arrays. It was found that the length of NW lines and the density of NW bundles can effectively tuned by the PS template heating time. The optimal FE performance with turn-on electric field as low as of 4.4 V μm⁻¹ and the field-enhancement factor as high as of 1450 were achieved through decreasing the screening effect among the patterned field-electron emitters.     

Synthesis,self-assembly and photo-responsive behavior of AB2 shaped amphiphilic azo block copolymer

In this work, we report the synthesis of AB2 shaped amphiphilic azo block copolymer by macromolecular azo coupling reaction. The product and intermediates were characterized by various methods. The selfassembly in selected solvents and photo-responsive behavior of the copolymer were studied by means of UV–vis spectrophotometry and TEM. Spherical aggregates can be obtained by gradually adding water into the solution of this amphiphilic azo block copolymer. Upon irradiation with polarized UV(365 nm)light, the aggregates can be elongated in the polarized direction.     

考虑塑性变形发展程度系数的RC梁开裂弯矩改进计算公式

针对RC梁开裂荷载计算方法尚未统一的现状，首先，结合18根RC梁试验数据对比了已有的6种RC梁开裂弯矩计算公式，发现开裂弯矩理论计算值与试验值的偏差大小和混凝土强度有关；然后，通过提出塑性变形发展程度系数k，推导新的RC梁开裂弯矩计算公式，并进一步基于k值和塑性影响系数计算值γ_k进行改进；最后，选取12根RC试验梁验证改进公式的准确性，证明改进公式的计算值与试验值吻合更好且偏于安全。     

Permanent antimicrobial silicone rubber based on bonding guanidine polymers

Recently, silicone rubber (VMQ) was extensively used in household articles and medical devices. To develop a kind of safe and long‐term antimicrobial VMQ was of great significance. In this work, a kind of vinyl‐contained polyhexamethylene guanidine hydrochloride (VPHMG) was synthesized and used as antimicrobial additive for VMQ. With the increasing of VPHMG addition, the mechanical properties and antimicrobial properties of VMQ‐VPHMG were significantly improved. In particular, the antimicrobial rates against Escherichia coli and Staphylococcus aureus were higher than 99.99% as for 4 wt% of VPHMG addition. Moreover, the surface concentration of VPHMG as well as the antimicrobial rates revealed almost unchanged after being extracted by water and methanol. All the results indicated the vinyl‐contained VPHMG vulcanization and therefore provided the permanent antimicrobial performance for VMQ.     

Existence of strong minimizers for the Griffith static fracture model in dimension two

We consider the Griffith fracture model in two spatial dimensions, and prove existence of strong minimizers, with closed jump set and continuously differentiable deformation fields. One key ingredient, which is the object of the present paper, is a generalization to the vectorial situation of the decay estimate by De Giorgi, Carriero, and Leaci. This is based on replacing the coarea formula by a method to approximate $SB{D}^p$ functions with small jump set by Sobolev functions, and is restricted to two dimensions. The other two ingredients will appear in companion papers and consist respectively in regularity results for vectorial elliptic problems of the elasticity type and in a method to approximate in energy $GSB{D}^p$ functions by $SB{V}^p$ ones.     

One-pot Synthesis of a Truncated Cone-shaped Porphyrin Macrocycle and Its Self-assembly into Permanent Porous Material

Here, we report the synthesis of a truncated cone-shaped triangular porphyrinic macrocycle, P₃L₃ , via a single step imine condensation of a cis-diaminophenylporphyrin and a bent dialdehyde-based linker as building units. X-ray diffraction analysis reveals that the truncated cone-shaped P₃L₃ molecules are stacked on top of each other by π⋯π and CH⋯π interactions, to form 1.7 nm wide hollow columns in the solid state. The formation of the triangular macrocycle is corroborated by quantum chemical calculations. The permanent porosity of the P₃L₃ crystals is demonstrated by several gas sorption experiments and powder X-ray diffraction analysis.     

形变张量的特征值与Boussinesq方程组的正则性估计

讨论了二维及三维满足周期边界条件的Boussinesq方程初边值问题的局部正则解在有限时间内爆破的可能性.在二维情况下,用形变张量的特征值给出温度梯度的L2估计,从中看出若流体微团变形的速率大,则解爆破的可能性就大.在三维情况下,用形变张量的特征值和温度的偏导给出涡量的L2估计,从中发现若流体微团在大部分时间内一般是平面拉伸,且温度的偏导较小时,解爆破的可能性就大;若一般是线性拉伸,温度的偏导又不任意增大时,解爆破的可能性就小.     

Deformation of single‐walled carbon nanotubes by interaction with graphene: A first‐principles study

The interaction between single‐walled carbon nanotubes (SWNTs) and graphene were studied with first‐principles calculations. Both SWNTs and single‐layer graphene (SLG) or double‐layer graphene (DLG) display more remarkable deformations with the increase of SWNT diameter, which implies a stronger interaction between SWNTs and graphene. Besides, in DLG, deformation of the upper‐layer graphene is less than in SLG. Zigzag SWNTs show stronger interactions with SLG than armchair SWNTs, whereas the order is reversed for DLG, which can be interpreted by the mechanical properties of SWNTs and graphene. Density of states and band structures were also studied, and it was found that the interaction between a SWNT and graphene is not strong enough to bring about obvious influence on the electronic structures of SWNTs. © 2015 Wiley Periodicals, Inc.