污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能研究

亚甲基蓝和环丙沙星是水体中2种污染物, 对生态环境有潜在危害. 本文以市政剩余活性污泥为原料, 氯化锌为活化剂热解制备污泥基吸附剂, 研究盐酸酸洗浓度、氯化锌浓度、热解温度、热解时间等对污泥基吸附剂吸附水中亚甲基蓝和环丙沙星性能的影响. 结果表明 (1)污泥基吸附剂对亚甲基蓝的吸附性能随盐酸酸洗浓度的增大而增加, 对环丙沙星的吸附性能则随盐酸酸洗浓度的增大呈先降后增趋势, 两者均在1.500mol·L-1盐酸浓度下取得最优值. (2)污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能随氯化锌浓度和热解温度的增加呈先升后降趋势, 在氯化锌浓度为4.0mol·L-1、热解温度为500℃时有最优值; 随着热解时间的延长, 污泥基吸附剂对亚甲基蓝和环丙沙星的吸附性能分别在500℃热解70min和80min时有最优值. (3)污泥基吸附剂的最佳制备条件为 氯化锌4.0mol·L-1活化2h、500℃热解70min和80min、1.500mol·L-1盐酸酸洗; 以此制得的污泥基吸附剂对亚甲基蓝和环丙沙星的去除率分别为97.7%和96.4%, 平衡吸附量分别为97.9mg·g-1和3.9mg·g-1, 且污泥基吸附剂对亚甲基蓝和环丙沙星的吸附过程均符合准二级动力学方程.     

Behavior and process of background signal formation of hydrogen,carbon, nitrogen,and oxygen in silicon wafers during depth profiling using dual-beam TOF-SIMS

The behavior and mechanism of background signals during depth profiling of atmospheric elements using dual-beam time-of-flight secondary ion mass spectrometry (TOF-SIMS) have been experimentally investigated for silicon wafers. The background signals of atmospheric elements were found to be inversely proportional to the sputtering rate. Most of the background signals are largely attributable to the accumulation of components through adsorption and ion bombardment in the pre-equilibrium state. On the other hand, the contribution of real-time adsorption during the instant after the last sputtering in the equilibrium state is negligible under the present experimental conditions. H₂O is dominant in the background formation process of hydrogen and oxygen, which is supported by the higher adsorption coefficients. The background levels of carbon and nitrogen are lower than those of hydrogen and oxygen. Furthermore, the background signal of carbon with respect to the sputtering rate shows a different trend than the other elements. This could be attributed to accumulation in the pre-equilibrium state. These results indicate that the background levels can be lowered close to those of dynamic-SIMS by using an extremely high sputtering rate in dual-beam TOF-SIMS.     

DFT modeling of indoline spiropyrans with a cationic substituent in the gas phase

Isomeric forms of indoline spiropyrans show unusual behavior compared with similar compounds, according to experimental data. DFT modeling for gas phase was made to consider the simplest case without environmental effects, which revealed the intramolecular reasons for occurrence of ring opening reaction depending on the particular structure of the compound. The questions of charge redistributions, the changes of geometry and chemical bonds in the structures are also discussed.     

Monitoring the Thiol/Thiophenol Molecule-Modulated Plasmon-Mediated Silver Oxidation with Dark-Field Optical Microscopy

Surface plasmon can trigger or accelerate many photochemical reactions, especially useful in energy and environmental industries. Recently, molecular adsorption has proven effective in modulating plasmon-mediated photochemistry, however the realized chemical reactions are limited and the underlying mechanism is still unclear. Herein, by using in situ dark-field optical microscopy, the plasmon-mediated oxidative etching of silver nanoparticles (Ag NPs), a typical hot-hole-driven reaction, is monitored continuously and quantitatively. The presence of thiol or thiophenol molecules is found essential in the silver oxidation. In addition, the rate of silver oxidation is modulated by the choice of different thiol or thiophenol molecules. Compared with the molecules having electron donating groups, the ones having electron accepting groups accelerate the silver oxidation dramatically. The thiol/thiophenol modulation is attributed to the modulation of the charge separation between the Ag NPs and the adsorbed thiol or thiophenol molecules. This work demonstrates the great potential of molecular adsorption in modulating the plasmon-mediated photochemistry, which will pave a new way for developing highly efficient plasmonic photocatalysts.     

大一学生实验室安全教育实效研究*

为考查线上线下混合安全教育模式实施后的实际效果,对天津理工大学化工、环安、机械、材料学院2020级大一学生进行实验室安全知识测试。结果表明:接受线上线下混合安全教育的大一学生安全知识的掌握情况较好;不足之处在于学生普遍对应急处置知识掌握较差。因此,在后续安全教育过程中,仍需进一步优化安全教育内容与模式,全面推进全员、全程安全教育。     

The Decisive Role of Spin States and Spin Coupling in Dictating Selective O2 Adsorption in Chromium(II) Metal–Organic Frameworks**

The coordinatively unsaturated chromium(II)-based Cr₃[(Cr₄Cl)₃(BTT)₈]₂ (Cr−BTT; BTT³⁻=1,3,5-benzenetristetrazolate) metal–organic framework (MOF) has been shown to exhibit exceptional selectivity towards adsorption of O₂ over N₂/H₂. Using periodic density functional theory (DFT) calculations, we attempted to decipher the origin of this puzzling selectivity. By computing and analyzing the magnetic exchange coupling, binding energies, the partial density of states (pDOS), and adsorption isotherms for the pristine and gas-bound MOFs [(Cr₄(X)₄Cl)₃(BTT)₈]³⁻ (X=O₂, N₂, and H₂), we unequivocally established the role of spin states and spin coupling in controlling the gas selectivity. The computed geometries and gas adsorption isotherms are consistent with the earlier experiments. The binding of O₂ to the MOF follows an electron-transfer mechanism resulting in a Cr^III superoxo species (O₂^.−) with a very strong antiferromagnetic coupling between the two centers, whereas N₂/H₂ are found to weakly interact with the metal center and hence only slightly perturb the associated coupling constants. Although the gas-bound and unbound MOFs have an S=0 ground state (GS), the nature of spin the configurations and the associated magnetic exchanges are dramatically different. The binding energy and the number of oxygen molecules that can favorably bind to the Cr center were found to vary with respect to the spin state, with a significant energy margin (47.6 kJ mol⁻¹). This study offers a hitherto unknown strategy of using spin state/spin couplings to control gas adsorption selectivity in MOFs.     

Ultrahigh Loading Copper Single Atom Catalyst for Palladium-free Wacker Oxidation

Wacker oxidation is an industry-adopted process to transform olefins into value-added epoxides and carbonyls. However, traditional Wacker oxidation involves the use of homogeneous palladium and copper catalysts for the olefin addition and reductive elimination. Here, we demonstrated an ultrahigh loading Cu single atom catalyst(14% Cu, mass fraction) for the palladium-free Wacker oxidation of 4-vinylanisole into the corresponding ketone with N-methylhydroxylamine hydrochloride as an additive under mild conditions. Mechanistic studies by ¹⁸O and deuterium isotope labelling revealed a hydrogen shift mechanism in this palladium-free process using N-methylhydroxylamine hydrochloride as the oxygen source. The reaction scope can be further extended to Kucherov oxidation. Our study paves the way to replace noble metal catalysts in the traditional homogeneous processes with single atom catalysts.     

Electronic structures of CO adsorbed Pt-skin surface on Pt–Co and Pt–Ni alloys

By using angle resolved photoemission spectroscopy, we investigate the electronic structures of Pt-skin layer of Pt–Co and Pt–Ni alloys with CO molecules on the surface. Measured Fermi surface maps and band dispersions reflect the signatures of chemical bonding between Pt-skin layer and CO molecules. Furthermore, the degree of chemical bonding strength of CO molecules, estimated from the energy shift of the participating bands, is found to be reduced on both Pt bimetallic alloys. Our results show how the surface band structure of Pt bimetallic alloys is modified with molecular orbitals of CO molecules on the surface, revealing the important role of the electronic structure in the determination of chemical properties of bimetallic alloys.     

Mechanistic Investigation and Conductance Modulation of a Metal-Molecule-Metal Junction via Extra Acid Addition

One important prerequisite for the fabrication of molecular functional device strongly relies on the understanding the conducting behaviors of the metal-molecule-metal junction that can respond to an external stimulus. The model Lewis basic molecule 4,4′-(pyridine-3,5-diyl)dibenzonitrile (DBP), which can react with Lewis acid and protic acid, was synthesized. Then, the molecular conducting behavior of DBP, DBP-B(C₆F₅)₃, and DBP-TfOH (DBP-B(C₆F₅)₃, and DBP-TfOH were produced by Lewis acid and protonic acid treatment of DBP) was researched and compared. Given that their identical physical paths for DBP, DBP-B(C₆F₅)₃, and DBP-TfOH to sustain charge transport, our results indicate that modifying the molecular electronic structure, even not directly changing the conductive physical backbone, can tune the charge transporting ability by nearly one order of magnitude. Furthermore, the addition of another Lewis base triethylamine (of stronger alkaline than DBP), to Lewis acid-base pair reverts the electrical properties back to that of a single DBP junction, that is constructive to propose a useful but simple strategy for the design and construction of reversible and controllable molecular device based on pyridine derived molecule.     

Regulating Phase Junction and Oxygen Vacancies of TiO2 Nanoarrays for Boosted Photoelectrochemical Water Oxidation

In this study, we have provided a facile solution to synthesize well-aligned titanium dioxide nanorods by using hydrothermal reaction. By calcining the materials under different atmospheres and temperatures, a batch of titanium dioxides with excellent oxygen evolution reaction(OER) catalytic efficiency were obtained. This new structured TiO₂ photoanode material yields a high photocurrent density of 5.69 mA/cm² at 1.23 V vs. reversible hydrogen electrode(RHE) under simulated solar light(100 mW/cm²). Surface photovoltage techniques and other measurements were carried out to confirm that the enhanced photoelectrochemical performances were attributed to the synergistic effect of the phase junction and a certain content of surface states, which accelerate the separation and transmission of the photogenerated charges. This material with phase junction and surface states promises a potential application in the field of photoelectric catalysis under solar light.