光寻址电位传感器的正交相位检波检测方法

光寻址电位传感器的幅度检测方法易受噪声干扰,灵敏度差,信噪比和精度低,且受调制光源的影响较大,影响检测结果的准确性.为此提出了一种基于正交相位检波的光寻址电位传感器检测方法.该方法是将光寻址电位传感器的输出光电流信号分别与两路正交信号相乘,通过低通滤波提取直流分量并相除,即可得到光寻址电位传感器的输出信号相位信息.与已有的光寻址电位传感器相位检测方法相比,该方法具有算法复杂度低、实时性高的优点.实验研究了调制光源光强对光寻址电位传感器幅度检测和相位检测的影响,对比分析了光寻址电位传感器的传统幅度检测方法与正交相位检波检测方法对pH检测的灵敏度、线性度及信噪比.结果表明,相比于幅度检测方法,调制光源光强对光寻址电位传感器的相位检测影响更小,在频率为10 kHz,pH的范围为1.68~10.01的情况下,相位检测方法比幅度检测方法测得的灵敏度增加了7 mV/pH,精度提高了14.9 mpH,非线性误差减小了0.003%,均方差减少了0.1051×10^-5,信噪比增加了8.2827 dB.该方法特别适用于弱光下的光寻址电位传感器检测.     

Study of blood collection and sample preparation for analysis of vitamin D and its metabolites by liquid chromatography–tandem mass spectrometry

The analysis of vitamin D status, with special emphasis on 25-hydroxyvitamin D and 1,25-dihydroxyvitamin D, is gaining interest in clinical studies due to the classical and non-classical effects attributed to this prohormone. In this research, the influence of the two steps preceding determination (viz. sample collection and preparation) on the quantitative analysis of vitamin D and its more important metabolites has been studied. Two preparation approaches, deproteination and solid-phase extraction (SPE), have been evaluated in terms of sensitivity to delimit their application, thus establishing that detection of 1,25-dihydroxyvitamin D cannot be addressed by protein precipitation. Concerning sample collection, serum and plasma reported high accuracy (above 83.3%) for vitamin D and metabolites, while precision, expressed as relative standard deviation, was below 12.9% for all analytes in both samples. Statistical analysis revealed that serum and plasma provided similar physiological levels for vitamin D₃, 24,25-dihydroxyvitamin D₃ and 25-hydroxyvitamin D₃, while significantly different levels were obtained for 1,25-dihydroxyvitamin D₃, always higher in plasma than in serum. Sample collection and treatment have proved to be significant in the analysis of vitamin D and its relevant metabolites.     

Detailed experimental and kinetic modeling study of 3-carene pyrolysis

3-Carene is an important potential biofuel with properties similar to the jet-propellant JP-10. Its thermal decomposition and combustion behavior is to date unknown, which is essential to assess its quality as a fuel. A combined experimental and kinetic modeling study has been conducted to understand the initial decomposition of 3-carene. The pyrolysis of 3-carene was investigated in a jet-stirred quartz reactor at atmospheric pressure, at temperatures varying from 650 to 1050 K, covering the complete conversion range. The decomposition of 3-carene was observed to start around 800 K, and it is almost complete at 970 K. Online gas chromatography shows that primarily aromatics are generated which suggests that 3-carene is not a good fuel candidate. The potential energy surface for the initial decomposition pathways determined by KinBot shows that a hydrogen elimination reaction dominates, giving primarily cara-2,4-diene. Next to this molecular pathway, radical pathways lead to aromatics via ring opening. The kinetic model was automatically generated with Genesys and consists of 2565 species and 9331 reactions. New quantum chemical calculations at the CBS-QB3 level of theory were needed to calculate rate coefficients and thermodynamic properties relevant for the primary decomposition of 3-carene. Both the conversion of 3-carene and the yields of the primary products (ie, benzene and hydrogen gas) are well predicted with this kinetic model. Rate of production analyses shows that the dominant pathways to convert 3-carene are hydrogen elimination reaction and radical chemistry.     

自动石墨消解–电感耦合等离子体质谱法同时测定左氧氟沙星胶囊中7种金属元素

建立自动石墨消解-电感耦合等离子体质谱法(ICP-MS)同时测定左氧氟沙星胶囊中铅、铬、砷、镉、锡、铝、铁7种金属元素含量的方法。以HNO3-H2O2()体积比为1∶1为消解体系,采用自动石墨消解法消解左氧氟沙星胶囊样品,消解液除酸后,用5%硝酸溶液定容至50 mL,采用电感耦合等离子体质谱法对消解液进行测定,以内标法定量。铅、铬、砷、镉、锡、铝、铁的质量浓度在0.05~20.0μg/mL范围内与质谱响应值成良好的线性关系,相关系数均大于0.998,方法检出限为0.119~1.323μg/kg。样品加标回收率为91.2%~105.5%,测定结果的相对标准偏差为1.67%~3.46%(n=6)。该方法样品前处理简单,检出限低,测定结果准确,适用于左氧氟沙星胶囊等沙星类抗生素中多种金属元素残留的测定。     

三元素氢氧化物中镍钴锰含量的测定

采用仪器分析方法和化学分析方法相结合测定三元前驱体Ni0.33Co0.33Mn0.33(OH)2中镍、钴、锰主含量,分别采用电感耦合等离子体原子发射光谱(ICP-AES)内标法测定镍、钴、锰的摩尔比例,EDTA滴定法测定镍、钴、锰的摩尔总量,计算得到各元素的含量。通过优化实验条件,进行了准确度和精密度实验,加标回收率为99.2%~101%,相对标准偏差小于0.65%。方法准确、快速,已用于实际的检测工作中。     

锌粉-硼砂-硼酸熔融-碘酸钾滴定法测定高硅锡精矿中的锡

针对高硅锡精矿中锡的测定时通常用锌粉-氢氧化钠熔融,精密度差,不能满足分析要求的问题,建立了锌粉-硼砂-硼酸熔融,盐酸浸取,铝粒将锡还原,碘酸钾滴定法测定高硅锡精矿中锡的分析方法。方法结果稳定,精密度好,相对标准偏差在0.19%~0.55%,加标回收率在96.9%~105%。分析结果能够满足高硅锡精矿中锡的测定要求。     

Comparison of a single-use pH test strip and a glass electrode for potentiometric titration

The potentiometric titration of a carbonate mixture or an acetate solution is a common experiment in analytical laboratories. Typically, a glass electrode combined with a calomel or Ag/AgCl reference electrode is used to locate the equivalence points in neutralization titrations. The dissociation constants of weak acids and bases can be calculated from the pH at the half-neutralization point. Recently, a new commercial product for measuring pH has been developed. This novel acid–base detection strip is a single-use sensor that requires neither storage in a preservation liquid nor calibration prior to use. This study examined its suitability for the continuous monitoring of pH changes in potentiometric titrations of carbonate mixtures, acetate solutions, or ammonia solutions. There were no significant differences in the concentrations of solutions tested using a glass electrode and a pH test strip. The pK_a, pK_b, and pH values determined using the two systems differed by less than 5%. The results confirmed that the pH strips are suitable for continuously monitoring pH changes during neutralization titrations. However, the strips can only be used once.     

Analytical Methods for Determination of Phytic Acid and Other Inositol Phosphates: A Review

From the early precipitation-based techniques, introduced more than a century ago, to the latest development of enzymatic bio- and nano-sensor applications, the analysis of phytic acid and/or other inositol phosphates has never been a straightforward analytical task. Due to the biomedical importance, such as antinutritional, antioxidant and anticancer effects, several types of methodologies were investigated over the years to develop a reliable determination of these intriguing analytes in many types of biological samples; from various foodstuffs to living cell organisms. The main aim of the present work was to critically overview the development of the most relevant analytical principles, separation and detection methods that have been applied in order to overcome the difficulties with specific chemical properties of inositol phosphates, their interferences, absence of characteristic signal (e.g., absorbance), and strong binding interactions with (multivalent) metals and other biological molecules present in the sample matrix. A systematical and chronological review of the applied methodology and the detection system is given, ranging from the very beginnings of the classical gravimetric and titrimetric analysis, through the potentiometric titrations, chromatographic and electrophoretic separation techniques, to the use of spectroscopic methods and of the recently reported fluorescence and voltammetric bio- and nano-sensors.     

自动快速燃烧－离子色谱测定铜精矿中的氟

建立了自动快速燃烧（AQF）－离子色谱联用测定铜精矿中氟的方法。将 AQF 的自动化特性和离子色谱的灵敏度高、准确性好的特点结合起来,能够实现操作过程的连续自动化。结果表明,线性范围内（1.0?50.0 μg )校准曲线相关系数 r >0. 999,氟的检出限为0.0004%。按照实验方法测定铜精矿样品中氟,结果的相对标准偏差（ RSD ,n =6)为2.14 % ?4.24 %。将实验方法用于铜精矿标准样品氟含量测定,测定值与认定值吻合较好;方法对照试验表明,实验方法对氟含量的测定值与国家标准 GB/T 3884. 12—2010的测定值基本一致。     

全自动电位滴定法测定锂电池原料碳酸锂中主成分的含量

采用全自动电位滴定法测定锂电池原料碳酸锂中主成分的含量,用盐酸标准溶液进行滴定,考虑自动电位滴定仪的灵敏性和准确度,通过多次对比实验,确定了仪器的最佳工作参数、滴定剂浓度和样品称样量等滴定条件;对两个不同品位试样分别进行了11次平行测定,相对标准偏差(RSD)均小于1%。在碳酸锂试样中加入基准物质无水碳酸钠进行碳酸根的加标回收实验,碳酸根的加标回收率在99.4%~100%。与传统的酸碱滴定法相比,全自动电位滴定法方便、快捷,同时方法测定结果准确、可靠、精密度高,适合大批量样品快速分析。