TiO_2光催化剂的形貌与晶面调控

二氧化钛(TiO2)具有化学稳定性高、无毒、价格低廉、来源广泛及光电性能优异等优点,被广泛应用于太阳能电池和光催化等领域,尤其是在污染物的光催化降解方面,可很好地解决当前的环境污染问题。但一方面受带隙宽度限制,使其对太阳光的利用率不足5%,不能充分利用太阳光中的可见光;另一方面由于光生电子-空穴容易结合,催化效率低,从而使TiO2的实际应用受到限制。因此必须采取合适的措施,一方面要增强TiO2对可见光的吸收,提高对太阳光的利用率;另一方面要抑制光生电子-空穴的复合,提高光催化效率。目前越来越多的科学家通过控制TiO2的形貌、晶型、特殊晶面暴露等手段来提高TiO2光生电子-空穴的传输速率和光电转换效率。本文主要综述了近年来在TiO2光催化剂的特殊形貌和特殊晶面暴露等方面的研究进展,对未来的研究和发展方向作了展望。     

Pollution characteristics of ambient PM2.5-bound PAHs and NPAHs in a typical winter time period in Taiyuan

The pollution characteristics of ambient fine particulate matter（PM2.5） containing polycyclic aromatic hydrocarbons（PAHs） and nitrated PAHs（NPAHs） in samples collected during a typical winter time period in Taiyuan of China were investigated.The obtained results revealed that the mean mass concentrations of PM2.5,SPAHs（sum of 16 PAHs） and SNPAHs（sum of 3 NPAHs） on PM2.5were161.4 mg/m3,119.8 ng/m3and 0.446 ng/m3,respectively.Diagnostic ratios of PAHs and NPAHs implied that coal consumption might be the main source of the PM2.5pollution.The measured PM2.5mass concentrations,BaP equivalent toxicity（28.632 ng/m3） and individual carcinogenicity index（3.14 10 5） were much higher than those of the recommended safety standards.     

不同聚合物对纳米SiO2表面改性的研究进展

纳米SiO2由于具有无味、无毒、无污染等特性,因而被广泛用作无机纳米填料。纳米SiO2极易团聚,从而限制了它的广泛应用。但纳米SiO2表面富含大量的硅羟基,可对其进行表面改性。纳米SiO2表面改性的方法较多,主要有表面物理改性和表面化学改性两种,其中表面化学改性中又以聚合物改性的效果最好。本文综述了国内外利用不同的聚合物——亲水性、疏水性和两亲性聚合物对纳米SiO2表面的化学改性,并对其应用进行了分析,展望了其发展前景。     

Preparation and characterization of Ti0.7Sn0.3O2 as catalyst support for oxygen reduction reaction

Sn-doped TiO_2 nanoparticles with high surface area of 125.7 m~2·g~(-1) are synthesized via a simple one-step hydrothermai method and explored as the cathode catalyst support for proton exchange membrane fuel cells.The synthesized support materials are studied by X-ray diffraction analysis,energy dispersive X-ray spectroscopy and transmission electron microscopy.It is found that the conductivity has been greatly improved by the addition of 30 mol%Sn and Pt nanoparticles are well dispersed on Ti_(0.7)Sn_(0.3)O_2 support with an average size of 2.44 run.Electrochemical studies show that the Ti_(0.7)Sn_(0.3)O_2 nanoparticles have excellent electrochemical stability under a high potential compared to Vulcan XC-72.The as-synthesized Pt/Ti_(0.7)Sn_(0.3)O_2 exhibits high and stable electrocatalytic activity for the oxygen reduction reaction.The Pt/Ti_(0.7)Sn_(0.3)O_2 catalyst reserves most of its electrochemically active surface area(ECA),and its half wave potential difference is 11 mV,which is lower than that of Pt/XC-72(36 mV) under 10 h potential hold at 1.4 V vs.NHE.In addition,the ECA degradation of Pt/Ti_(0.7)Sn_(0.3)O_2is 1.9 times lower than commercial Pt/XC-72 under 500 potential cycles between 0.6 V and 1.2 V vs.NHE.Therefore,the as synthesized Pt/Ti_(0.7)Sn_(0.3)O_2 can be considered as a promising alternative cathode,catalyst for proton exchange membrane fuel cells.     

Coking-resistant Ni-ZrO2/A1203 catalyst for CO methanation

Highly coke-resisting ZrO2-decorated Ni/A1203 catalysts for CO methanation were prepared by a two-step process. The support was first loaded with NiO by impregnating method and then modified with ZrO2 by deposition-precipitation method （IM-DP）. Nitrogen adsorption- desorption, X-ray diffraction, scanning electron microscopy, transmission electron microscopy, thermogravimetdc analysis, H2 temperature- programmed reduction and desorption, NH3 temperature-programmed desorption, and zeta potential analysis were employed to characterize the samples. The results revealed that, compared with the catalysts with the same composition prepared by co-impregnation （CI） and sequential impregnation （SI） methods, the Ni/A1203 catalyst prepared by IM-DP showed much enhanced catalytic performance for syngas methanation under the condition of atmospheric pressure and a high weight hourly space velocity of 120000 mL.g-1 .h-1. In a 80 h life time test under the condition of 300-600 ~C and 3.0 MPa, this catalyst showed high stability and resistance to coking, and the amount of deposited carbon was only 0.4 wt%. On the contrary, the deposited carbon over the catalyst without ZrO2 reached 1.5 wt% after a 60 h life time test. The improved catalytic performance was attributed to the selective deposition of ZrO2 nanoparticles on the surface of NiO rather than A1203, which could he well controlled via changing the electrostatic interaction in the DP procedure. This unique structure could enhance the dissociation of CO2 and generate surface oxygen intermediates, thus preventing carbon deposition on the Ni particles in syngas methanation.     

准立方体纳米α-Fe_2O_3的制备及光催化活性研究

本文利用无表面活性剂条件,以氨水和醋酸锌为形貌调控剂,通过水热法合成了准纳米立方块结构的α-Fe2O3。并利用X射线衍射、透射电子显微镜、扫描电子显微镜对产物的形貌进行了的表征,对其形成机理进行了初步的解释。同时对其光催化降解活性进行了研究。     

XMgO·YMg(OH)_2吸附剂除氟机理及其净化水的水质研究

研究了XMg O·YMg(OH)2对水中氟离子的吸附性能,考察了吸附时间、吸附剂用量、含氟水p H值、温度、含氟水初始浓度等因素对吸附的影响。实验结果表明,在较宽的p H(3.4~8.4)值和水温(22~51℃)范围内,XMg O·YMg(OH)2对水中氟离子具有极强的吸附能力,室温下0.4g XMg O·YMg(OH)2可将100m L浓度为30mg F-1·L-1含氟水处理为符合含氟标准的饮用水。氟离子在XMg O·YMg(OH)2上的吸附速率较大,30min内基本达到吸附平衡,吸附平衡符合Langmuir方程,在50min内达到饱和吸附,室温下饱和吸附量为13.46mg·g-1。净化水呈微碱性,含有5.68~15.07mg·L-1Mg2+,有益于人体健康。吸附饱和后的XMg O·YMg(OH)2经焙烧再生,除氟率可达81%。     

含肽键芳酰腙镧(Ⅲ)配合物的合成、表征及对四种作物病害的抑制作用

合成了未见文献报道的镧(Ⅲ)与含肽键芳酰腙配体(2-羰基丙酸水杨酰腙)的配合物,经化学分析、元素分析及摩尔电导率等表征推测其组成为:La(H2L)(HL)·H2O(H3L为2-羰基丙酸水杨酰腙C10H10N2O4)。通过红外、紫外及荧光的研究表明配体以羧基氧、羰基氧和亚氨基氮与La3+三齿配位,形成了两个共边五元环的稳定结构。盆栽活体试验表明该配合物对四种作物病害都有不同程度的抑制作用,其中对小麦条锈病的防治效果最好,防治效果达80.8%。     

基于串联反应的吡虫啉新合成工艺研究

以2-氯-5-氯甲基吡啶(CCMP)、无水乙二胺和硝基胍为原料,运用串联反应方法合成了吡虫啉[化学名:1-(6-氯-3-吡啶甲基)-N-硝基-2-咪唑啉亚胺]。该方法反应中间体无需纯化处理,操作简单,同时解决了活性中间体进一步进行副反应的难题。通过单因素实验,探讨了pH、反应溶剂、温度以及时间等因素对产物收率的影响,得到的优化工艺条件为:以乙腈为溶剂,nCCMP∶n无水乙二胺∶n硝基胍=1∶5∶1,于30℃反应120min,产率可达96.35%。其结构经1H NMR、13C NMR、IR表征。     

双核铜配合物Cu2(2,2′-bpy)2(2-bba)4的合成、表征与晶体结构

在室温下,以2-溴苯甲酸和2,2'-联吡啶为配体,通过溶液法在甲醇/水的混合溶剂中反应合成了双核铜(II)配合物Cu2(2,2'-bpy)2(2-bba)4。通过元素分析、红外光谱、热重测试技术和X射线粉末衍射对其进行了结构表征,同时用X射线单晶衍射分析确定了其晶体结构。结果表明,其晶体属正交晶系,空间群为Pbca,晶胞参数:a=20.619(4),b=10.098(2),c=21.865(4),V=4552.5(15)3,Dc=1.808g·cm-3,μ=4.505mm-1,F(000)=2440.0,Z=4,最终残差因子R1=0.0583,wR2=0.1200。配合物为双核结构,每个结构单元中2个Cu(II)离子通过2个2-溴苯甲酸根配体单齿桥联。配合物中的每个Cu(II)离子为五配位的结构,分别和来自2个单齿桥联的2-溴苯甲酸根的2个氧原子、1个单齿配位的2-溴苯甲酸根的1个氧原子及来自1个2,2'-联吡啶的2个氮原子配位形成了畸变的四方锥型结构,分子间则通过弱的C—H…O氢键作用形成了一维链状的结构。CCDC:972827。